A junction box is a container used to enclose electrical connections (junctions).

learn more… | top users | synonyms

5
votes
5answers
15k views

Is this an adequate junction box wire job using a standard electric box? (pic included)

I needed to splice a wire to repair nicked wire insulation, but I didn't feel like running to Lowe's just for a junction box. Instead, I used a regular electrical box. The wire comes up from the ...
4
votes
1answer
19k views

How to tell if a ceiling junction box is braced to hold the weight of a ceiling fan?

My new home is almost done being built, and one of the extras I asked for was for two of the rooms to have junction boxes in the ceiling suitable for hanging a ceiling fan in the future. The light ...
4
votes
2answers
9k views

How can high and low voltage be mixed in a junction box?

So I'm aware of the standard rule of thumb, keep high and low voltage away from each other, preferably on opposite sides of a stud. However, while looking at some properties, I'm seeing telephone and ...
12
votes
3answers
29k views

What's the minimum depth that an electrical box can recess into a finished wall? Does it have to be flush?

Do electrical boxes have to be flush to the finished surface? Can they recess any depth into the wall by as much as 1/8" or 1/4"? Edit: I appreciate everyone offering alternative solutions to ...
5
votes
5answers
25k views

Can I cover junction boxes in the attic with insulation?

This may be a duplicate of What are the codes for electrical wiring in attics? I have an attic which is accessible via a ladder through an access panel in the garage and in a bedroom. The trusses ...
2
votes
2answers
455 views

How should I connect a grounding wire from a device to this box?

I'm replacing this simple 2-connector light switch with a 4-wire dimmer. The 2 new wires present on the dimmer are neutral and ground, and only neutral has an obvious home. The box has no visible ...
2
votes
2answers
324 views

Is there a way to extend electrical wire where the splices can be finished over? [duplicate]

I want to extend some wires to relocate some switches. Normally one might do this by splicing new wires in and covering the junction box with a cover plate. Is there a way to permanently splice wires ...