Horizontal support structures beneath the floor running between load bearing walls.

learn more… | top users | synonyms

3
votes
1answer
2k views

How can I remove just one tongue-and-groove subfloor board?

I am not talking about laminate planks, but actual subfloor sections. My entire room consists of tongue-and-groove boards. I was under the impression that the point of this was so you didn't have to ...
6
votes
1answer
503 views

How do I fit a joist in this small space?

This is a follow on question from here: Floor joists connection to eaves Since this question, I have been told I need 8" joists for my span and I have exposed my eaves area to see what space I've ...
1
vote
1answer
215 views

How can I locate the 2x8 boards beneath subfloor, backer board, mortar, and ceramic tile?

My floor is getting a little creaky in my bathroom. Unfortunately, it has ceramic tile over it (along with mortar and backer board). What I need to do is drill a clearance hole through the grout and ...
6
votes
2answers
2k views

What should I do about a hardwood floor that's sagging between the joists?

I recent bought an older (1890) house. On the original floors, the wood flooring is sagging between the joists--you can feel the height difference as you walk, up and down, up and down. It's firm, ...
2
votes
1answer
4k views

How should I add new joists and flooring to a loft space?

First off, basic floor plan of the loft: Hard lines are the walls on the first floor underneath, joists on the first floor landing run left to right so does that mean the central wall running front ...
1
vote
1answer
273 views

What height of insulation should I use between joists in an MDF floor?

Background I am starting my first serious DIY project - converting our garage into a playroom for the kids. The garage floor is concrete. My plan is to run timber (Sawn Kiln Dried Timber (L)3000 x ...
1
vote
1answer
2k views

How far apart should timber joists be for an MDF floor?

Background I am starting my first serious DIY project - converting our garage into a playroom for the kids. The garage floor is concrete. My plan is to run timber (Sawn Kiln Dried Timber (L)3000 x ...
8
votes
4answers
2k views

Floor joists connection to eaves

Apologies if this is a duplicate. I'm attempting to floor my loft space. It currently has 47mm x 75mm ceiling joists, not enough for a floor. I am going to add something like 47mm x 200mm along ...
9
votes
1answer
604 views

How do I get to the wall cavity above a double floor joist from below?

I am running some new romex for a couple of electrical outlets. One of the outlets is on one side of a wall in one bedroom and the other outlet is on the other side of the wall in another bedroom. ...
11
votes
3answers
4k views

How do I meet the 7 feet high ceiling requirement after finishing the basement?

My basement ceiling joists are exactly 7 feet above the concrete slab. The requirement for finished living space is 7 ft from the finished floor to the finished ceiling. Since I'll loose a couple of ...
0
votes
1answer
428 views

Alternatives to wood joists

I have a brick(3 wythe) building and starting to plan a kitchen remodel. The floor in the kitchen is pretty slanted and the wood joists don't look too good. So I will need some way to level the floor. ...
1
vote
2answers
2k views

What is the strongest way to join a deck joist to a corner joint?

I'm working on designing the support frame for a deck for my backyard. The basic shape of the deck: It's essentially a square with one corner chopped off. The red line is the joist in question, ...
6
votes
1answer
1k views

Should I worry about sagging joists?

I have a two story house and some of the joists between the floors are sagging about an inch or two. When I walk around upstairs I can feel the level difference and downstairs you can slightly see the ...