Tagged Questions

Horizontal support structures beneath the floor running between load bearing walls.

learn more… | top users | synonyms

6
votes
1answer
560 views

How to properly seal the transition between basement wall framing and spray-foamed box joists?

We're looking at insulating the box joists of our concrete foundation. We have 2x3" walls framed which are holding batt insulation, which are 3-4" away from the wall (to accommodate a layer of batt ...
4
votes
2answers
406 views

How do I reinforce the ends of 2x8s that are sistered to 2“x5” (actual size) joists?

I want to strengthen the floor of my office. Currently the joists are 2"x5" (actual size). I want to put a 2"x8" (1.5"x7.5" actual size) which will double the existing joists. I will have to reduce ...
2
votes
1answer
691 views

How can I build a temporary support for rafters?

I have a hipped roof with 5.5 metre common rafters supported mid span by strutted purlins. The rafters, and below them the ceiling joists, are trimmed around a double flue chimney breast at the flank ...
3
votes
2answers
2k views

How can I hang a heavy bag from this beam in my garage?

I'm renting a house that was built about 10 years ago. The attached, finished garage is under the master bedroom. It has two large beams running across it, see picture. The larger one is 6.5" ...
4
votes
1answer
606 views

Do the guidelines for holes in joists apply to band joists?

This question have a great answer with all the guidelines for drilling holes in joists. The question: Are the guidelines the same for band joists? A bit of context: I'd like to add an exterior ...
10
votes
1answer
720 views

Are there any dangers to sistering a joist with oversize lumber?

I've done some research lately on joist sistering as a solution to bouncy floors. The logic seems to revolve around the following principles. The stress of carrying a load is at the center of the ...
5
votes
1answer
1k views

Is there a correct orientation for hurricane clips?

When installing hurricane clips to joists where it crosses a beam, is there a preference to mounting the clips on the inside or the outside of the beam? And should the ears on the clips point inward ...
2
votes
2answers
1k views

What packing material to use between a brick and house beam?

I'm replacing a damaged beam under my house with bricks under each floor joist. The bricks are 15mm lower than the original beam. I've been told to use roof slates to pack the rest of the height. I'm ...
7
votes
6answers
1k views

How do I remove floorboard nails from joists?

How do I remove floorboard nails from joists? The nails are ~3-4mm diameter with no heads. I've tried claw-hammer and wrecking bar with no success because without nail-heads, I cannot get purchase. ...
1
vote
1answer
2k views

Can I build a deck close to the ground? [duplicate]

Possible Duplicate: Can I build a deck this low to the ground? Every set of instructions I've seen for building a deck requires me to put joists on top of beams attached to posts. But I ...
4
votes
1answer
3k views

What does blocking refer to in relation to floor joists?

This question was triggered by the following line in a home inspection: Blocking is not installed for I joists above beams in basement. I have found pictures of blocking at ...
3
votes
2answers
468 views

Is there a way to sound proof my basement while I've got part of the ceiling open?

We had a header beam installed in our basement. The floor joists are exposed for 1ft (~30cm) on both sides for the length of the beam. The basement is an apartment, so I'd like to add some ...
17
votes
1answer
15k views

What are the guidelines for holes in joists?

I've been unable to find a good reference for the size/amount/location of holes I can drill through joists. This is mostly in order to pass cabling or pipes through the joist crosswise. Also, what ...
3
votes
1answer
3k views

How can I remove just one tongue-and-groove subfloor board?

I am not talking about laminate planks, but actual subfloor sections. My entire room consists of tongue-and-groove boards. I was under the impression that the point of this was so you didn't have to ...
6
votes
1answer
577 views

How do I fit a joist in this small space?

This is a follow on question from here: Floor joists connection to eaves Since this question, I have been told I need 8" joists for my span and I have exposed my eaves area to see what space I've ...
1
vote
1answer
234 views

How can I locate the 2x8 boards beneath subfloor, backer board, mortar, and ceramic tile?

My floor is getting a little creaky in my bathroom. Unfortunately, it has ceramic tile over it (along with mortar and backer board). What I need to do is drill a clearance hole through the grout and ...
6
votes
2answers
3k views

What should I do about a hardwood floor that's sagging between the joists?

I recent bought an older (1890) house. On the original floors, the wood flooring is sagging between the joists--you can feel the height difference as you walk, up and down, up and down. It's firm, ...
2
votes
1answer
5k views

How should I add new joists and flooring to a loft space?

First off, basic floor plan of the loft: Hard lines are the walls on the first floor underneath, joists on the first floor landing run left to right so does that mean the central wall running front ...
1
vote
1answer
297 views

What height of insulation should I use between joists in an MDF floor?

Background I am starting my first serious DIY project - converting our garage into a playroom for the kids. The garage floor is concrete. My plan is to run timber (Sawn Kiln Dried Timber (L)3000 x ...
1
vote
1answer
3k views

How far apart should timber joists be for an MDF floor?

Background I am starting my first serious DIY project - converting our garage into a playroom for the kids. The garage floor is concrete. My plan is to run timber (Sawn Kiln Dried Timber (L)3000 x ...
8
votes
4answers
2k views

Floor joists connection to eaves

Apologies if this is a duplicate. I'm attempting to floor my loft space. It currently has 47mm x 75mm ceiling joists, not enough for a floor. I am going to add something like 47mm x 200mm along ...
9
votes
1answer
704 views

How do I get to the wall cavity above a double floor joist from below?

I am running some new romex for a couple of electrical outlets. One of the outlets is on one side of a wall in one bedroom and the other outlet is on the other side of the wall in another bedroom. ...
11
votes
3answers
5k views

How do I meet the 7 feet high ceiling requirement after finishing the basement?

My basement ceiling joists are exactly 7 feet above the concrete slab. The requirement for finished living space is 7 ft from the finished floor to the finished ceiling. Since I'll loose a couple of ...
0
votes
1answer
550 views

Alternatives to wood joists

I have a brick(3 wythe) building and starting to plan a kitchen remodel. The floor in the kitchen is pretty slanted and the wood joists don't look too good. So I will need some way to level the floor. ...
1
vote
2answers
3k views

What is the strongest way to join a deck joist to a corner joint?

I'm working on designing the support frame for a deck for my backyard. The basic shape of the deck: It's essentially a square with one corner chopped off. The red line is the joist in question, ...
6
votes
1answer
1k views

Should I worry about sagging joists?

I have a two story house and some of the joists between the floors are sagging about an inch or two. When I walk around upstairs I can feel the level difference and downstairs you can slightly see the ...