1
vote
3answers
46 views

How do I join pieces of wood tiles, 12“ by 12” pieces, to make a larger slab?

I have a project to work on that requires me using larger pieces of planks than what I currently have. I have square planks all over the porch that would suffice if only I had a good way of fitting ...
1
vote
2answers
224 views

Compound mortise and tenon joints on corners (ie. legs of a table)

I am playing around with the idea of doing a workbench that can be disassembled, using pinned mortise and tenon joints. I haven't found anything that could be used where two spans meet at a corner ...
2
votes
2answers
476 views

Which technique of wood joining is the best for joining these boards of a small table?

I want to join these four 1.8 cm thick beechwood boards as one can see on the picture. My idea is to join at the B points with biscuits but I’m not sure what to do about the A points. It needs to be a ...
2
votes
3answers
522 views

How to make a Bevel Lap Splice joint, for connecting a portable floor?

I'm new to woodworking, and I've read that I could potentially create this joint using a table saw, jointer, or even a circular saw - but I do not want to rent/purchase one and find out that I can't. ...
8
votes
2answers
883 views

How do I drill a mortise and tenon joint so I can reinforce it with a dowel?

I want to make a mortise and tenon joint that will be held together with a dowel instead of glue. How can I drill the hole in the mortised stock and the tenon so that they line up accurately and ...
4
votes
1answer
443 views

When should I round over the edges leading to a miter joint?

I'm going to be joining 2 1x6" pieces of wood at a simple miter joint. However, I want the top edges to be rounded over. I'm planning to use my router and a round over bit to soften the edges, the ...