1
vote
3answers
61 views

How do I join pieces of wood tiles, 12“ by 12” pieces, to make a larger slab?

I have a project to work on that requires me using larger pieces of planks than what I currently have. I have square planks all over the porch that would suffice if only I had a good way of fitting ...
1
vote
2answers
300 views

Compound mortise and tenon joints on corners (ie. legs of a table)

I am playing around with the idea of doing a workbench that can be disassembled, using pinned mortise and tenon joints. I haven't found anything that could be used where two spans meet at a corner ...
2
votes
2answers
501 views

Which technique of wood joining is the best for joining these boards of a small table?

I want to join these four 1.8 cm thick beechwood boards as one can see on the picture. My idea is to join at the B points with biscuits but I’m not sure what to do about the A points. It needs to be a ...
4
votes
1answer
981 views

What kind of connection is used to attach the legs to this table?

I (a beginner) would like to build a table of this form. Does anyone know what kind of corners are used to connect the legs, or any other construction tips.
5
votes
1answer
7k views

How can I join 2x6 pressure treated wood for a shed base?

I am creating a wood frame for my Suncast Sierra shed. I already weighed the pros and cons of each option for a base and came out with a wood frame as the most economical with all factors considered. ...
8
votes
2answers
935 views

How do I drill a mortise and tenon joint so I can reinforce it with a dowel?

I want to make a mortise and tenon joint that will be held together with a dowel instead of glue. How can I drill the hole in the mortised stock and the tenon so that they line up accurately and ...
4
votes
1answer
463 views

When should I round over the edges leading to a miter joint?

I'm going to be joining 2 1x6" pieces of wood at a simple miter joint. However, I want the top edges to be rounded over. I'm planning to use my router and a round over bit to soften the edges, the ...
5
votes
1answer
201 views

How can I extend existing 8 x 8 pilings?

I am converting a deck to a boat lift. I have 8x8 sqaure pilings built at deck height, 2.5 ft above water. I knew it might get converted into a boat lift so they are all in the correct location. But ...