3
votes
2answers
3k views

Do I need to remove existing drywall before framing an interior wall?

Below is a rough diagram of the interior wall I'd like to build. The wall is in green, and the rooms are in white. The grey offset around the edges of the walls represents 3/8" drywall. My question ...
2
votes
3answers
9k views

How should I apply brick to an interior wall?

I don't want to use veneer, I want to use real brick. Is it as easy as using tie-ins to the studs and setting the brick as one would normally? The existing wall is drywall, So I was thinking of ...
2
votes
2answers
407 views

Tips for texturing ceilings?

I'm getting ready to texture ceilings for the first time using an air-compressor / hopper. I plan to practice first on some old sample sheets of drywall I have laying around but was also hoping to ...
2
votes
1answer
227 views

How large are in-wall heating vents that connect to registers?

I'm curious how large heating vents can typically be when connecting to in-wall registers. Do they fill up the entire space between studs? I'm framing for some drywall patches and would ideally not ...
6
votes
3answers
3k views

Can quick-drying mud be used on the same drywall joints where slow-drying mud was used?

I think I phrased the summary/title poorly but essentially, I'd like to know if all drywall mud coats need to use the same type of joint compound for all coats or if I can transition to quick drying ...
4
votes
2answers
652 views

How should I repair drywall where heating registers used to be?

We recently had an asbestos abatement crew remove heating ducts in our house that had asbestos-lined duct insulation. Part of the process required them to remove the duct registers in the wall as ...
5
votes
2answers
2k views

What are the pros and cons of rolled-on wall/ceiling texture paint?

I just recently learned that some wall/ceiling textures can be applied with a paint-roller and special texture "paint". Here are a couple examples from Home Depot: I was hoping to get more ...
7
votes
3answers
2k views

How can I keep leftover drywall mud from drying out in the box?

I'm not quite sure how much drywall mud I'll be using for my upcoming project so I'm planning to buy a box of it. Assuming that I have some left over, is there a technique for not wasting it? Will it ...
7
votes
3answers
6k views

What consistency should drywall mud be?

I've been reviewing various drywall videos and documentation but I haven't found clear details on what kind of thickness the joint compound should be. Is there a definitive answer for this? Or does ...
10
votes
3answers
375 views

Why are progressively larger drywall knives used after each mudding pass?

I've been researching drywall finishing techniques and have noticed that when a first coat of mud compound is used, a smaller 6 inch taping knife is used... then on the second mud application, a ...
2
votes
1answer
7k views

What are some tips/techniques for applying knockdown texture to drywall?

I'd like to get advice on applying knockdown texture and fixing my own mistakes in the process. The consistency I'm looking for is something similar to this: As per an eHow article, I think the ...
3
votes
1answer
613 views

How do I replace missing drywall strips after an asbestos abatement?

I'm getting ready for my first major DIY project (about a week away). Here's a summary: We confirmed the presence of Asbestos in our house heating vent insulation and acoustic ceilings. We're ...