For questions generally relating to the proper insertion of a particular device or feature into a home, building or other structure. As this topic is very broad in general, when using this tag please include additional tags to narrow the scope of the discussion to a particular room, subsystem ...

learn more… | top users | synonyms

1
vote
2answers
36 views

How do we fit a pedestal sink top onto a vanity base?

We want to put a rectangular pedestal sink top onto a wooden vanity (yet to be built). We won't be using a solid surface or laminate product on top, but instead want the sink to slightly overhang the ...
1
vote
0answers
13 views

I want to install veneerstone to a painted, dirty concrete wall. How do I properly prepare the wall?

I want to install veneerstone to the concrete porch foundation. It is dirty and has been painted with latex paint. What do I need to do to the concrete so I can apply the veneerstone?
2
votes
2answers
91 views

How can I calculate the rotational force and motor HP needed to lift a 5lb sheet from a horizontal position to a vertical position from one end?

Essentially, I need to know the following: How do I calculate the rotation force along a fulcrum? Is there an equation? What is the weight of a 5 lb object at the fulcrum if the fulcrum is located ...
1
vote
2answers
39 views

How do you install the plastic/nylon toggle anchors?

I recently bought a shelf that included these types of wall anchors, and for the life of me, I could not figure out how to install them. What's the trick with them? ...
2
votes
1answer
41 views

Can I use a toggle bolt if there's no space behind the drywall?

While trying to install a 14lb metal shelf to the wall, I had learned from a previous installation mishap to upgrade from plastic anchors to something stronger. I picked up a few toggle bots (3/16" w ...
0
votes
0answers
27 views

How do I attach stone veneer to a brick fireplace?

We have a brick fireplace we'd like to reface with one of the many stone veneers. However, I'm not sure of the proper method to attach it. To complicate matters, around the firebox on the top and ...
0
votes
2answers
57 views

Is it possible to replace my phone wires t network wires in the walls?

In my house I have telephone access point in each room. Is it possible to replace them with network cables? I have tried every option I know to get WIFI signal in my top floor but always getting poor ...
0
votes
1answer
107 views

Ceiling Fan Install - Ground Wire

I' removed an old ceiling fan and I am replacing it with a new one. My home was built in the 60s and I'm installing so it works off one switch. After the removing the old fan the ceiling revealed two ...
0
votes
3answers
64 views

How do I install a ceiling fan remote?

I am trying to replace a busted hunter ceiling fan remote. The transmitor unit from the old remote had 5 wires - live and neutral, and then 1 that was labeled "fan out", 1 that was labeled "light ...
0
votes
1answer
30 views

Where do you buy a whiteboard? [closed]

I'm a math student, and I just entered grad school. I have a studio apartment, and there's one bigger-sized wall with no windows. I'd like to put a large whiteboard or chalkboard on it. Where would ...
0
votes
1answer
87 views

How do I frame this oddly spaced rough in

It's been a long time since I posted about this stupid rough in (dang kids), but I'm attempting to get back on it. The spacing for these pipes are driving me crazy. For a quick reference, the ...
2
votes
2answers
355 views

Is a special circular saw blade needed to cut plastic?

We purchased two portable air conditioners for our bedrooms. It include a plastic window kit that can be fitted for the window. I.e., this: I need to trim off about 6 inches, which requires a ...
3
votes
1answer
345 views

hoses instead of pipes

Quick question that came to my mind earlier today: When installing a water system (concealed installation), why does one use pipes. It seems to me that hoses would be easier to install, more flexible ...
0
votes
1answer
82 views

What do I do with a 1 11/16" gap when installing a new pre-hung door?

I am replacing a door with a pre-hung door including the jamb. The old door was 29 11/16" wide. The new pre-hung door is 28". Is this too big of a gap? Should I make it plumb on one side and make up ...
3
votes
1answer
183 views

Do I need to ground Ethernet cable run beneath a pier & beam house?

I'm fairly amateur when it comes to home networking, though I get the basic concepts. I bought a 1000' spool of this Cat6 Ethernet cable, simply because it was the only outdoor-rated cable sold by ...
2
votes
2answers
387 views

Can I use glue instead of nails to install shoe molding?

I installed engineered bamboo flooring in my home office and have quarter round shoe molding to install to cover the expansion gap. Given how hard the trim is (I've bent nails installing the carpet ...
1
vote
1answer
48 views

What ceiling/wall lamps fit these ports

I am looking for ceiling lamps for the first one and wall lamps for the second port. Since I have a low ceiling in my apartment in an old house, I want to the use of pendant lamps.
0
votes
0answers
115 views

Wood fence not installed properly…need a quick solution

My neighbor recently installed a wood fence around his property, unfortunately, he failed to properly install the fence, i.e., in attaching the wood slats on MY side he only used two screws on the ...
0
votes
1answer
32 views

How to better isolate a floor with carpet?

I am going to put a carpet on a room. This room is on a ground floor and it's actualy cold (I can feel the cold on the ground). Is there some material that I can put between the carpet and the floor ...
1
vote
2answers
628 views

How can I connect this washing machine outlet to the drain?

I have been given a washing machine and I've plumbed in the inlet no problems The problem I have is that the outlet hose coming from the machine is not compatible with the drainage plumbing in the ...
0
votes
1answer
105 views

How do I add support blocking for a floating sink (when the wall framing is metal studs)?

I'm installing a floating sink and think I need to install blocking between the studs. I would normally open the drywall at the correct height and use a 2x6 between the studs. But this is going into a ...
1
vote
1answer
56 views

What are the consequences of incorrect positioning of air separator (and swapped return/flow) in solar heating system?

I've moved into a house that has a Vaillant Solar system for helping heat the water. We had various issues that resulted in a Vaillant engineer visiting, who pointed out various problems, including a ...
-2
votes
2answers
90 views

IKEA table problem [closed]

I got this table and legs from IKEA, and I have no idea how to assemble them. The legs are like this: The table has screws on one side
3
votes
2answers
455 views

How do I properly frame an opening to angle a through-wall air conditioner?

I'm going to install a through-wall air conditioner using a purpose-built sleeve. The instructions from the manufacturer say to install it such that it angles slightly downwards to the outside (about ...
1
vote
2answers
102 views

Fencing yard and then cementing Area - What to do first?

I live in Midwest in a townhouse. Having problems with new neighbors dogs crapping in yard. Planning to surround yard with 5ft chainlink fence and also cementing the encased area to use as patio with ...
1
vote
2answers
48 views

pre hung doors to fit into old frame

I have purchased some pre hung doors at 30" by 80" the jambs are 4 5/8 wide. The house is 50 years old and the existing door frame is 5 1/4 wide. Any solution as to how to fit these doors into the ...
1
vote
0answers
66 views

what could happen if a 240 stove cord was improperly installed and then stove was plugged in to the receptacle?

I think my new stove cord was installed wrong and after being plugged in we heard a ((whooooaamp)) sound and all the lights in the house flickered, now none of my 220 appliances will work correctly. ...
0
votes
2answers
122 views

Replacing old thermostat with new wi-fi Honeywell

I'm trying to replace my old mercury thermostat with Honeywell Rth8580wf. The cable has 8 wires, only 4 were being used. The wire colors and letters on the thermostat do not match up, so I'm left with ...
5
votes
3answers
2k views

Should backsplash be tiled before or after installing kitchen cabinets?

I've been searching the Internet and all English-speaking web sites state that the backsplash should be tiled after installing the kitchen cabinets (both lower and upper) and countertops. In some ...
2
votes
3answers
158 views

Starting row of laminate flooring

Just wondering how to start the 1st row of laminate flooring. I have a door to deal with right off the bat. Wondering which is the better option (see diagram). This diagram is not to scale. The wall ...
2
votes
2answers
2k views

How do I mount a TV to cover a cubby hole above my fireplace?

I have an odd space above the mantle that my wife hates, and we tried covering it up with our TV, but I'm not very confident that the mantle is strong enough to hold the TV. I would like to do ...
1
vote
1answer
756 views

Is it okay to connect a round supply duct directly to an air handler?

I removed all of my existing duct work that was designed as a radial system with a sheet metal rectangular plenum with very long flex runs poorly attached. I am replacing my system with all round ...
0
votes
3answers
2k views

How do I wire a humidifier without a 24 VAC IN terminal?

The instructions for the humidifier I'm installing says to connect the humidistat wiring to the two terminals "marked 24 VAC IN". My furnace doesn't have terminals marked that. I have R,C,W,Y.G. Am ...
1
vote
1answer
87 views

Can I install a flow through humidifier on either side of the duct?

I was about to install a Wait6000 whole home humidifier when I hit this snag in the plan. On page 3 of their manual (PDF), it says the cold air return duct must be at least 10" wide. The diagram ...
0
votes
1answer
707 views

Was my new carpet installed correctly?

My guess is no. We had carpet installed on our stairs and our upstairs hallway and bedrooms. The carpet install was "free" though we had to pay extra for the stairs. When vacuuming the steps the ...
2
votes
1answer
183 views

Is caulk sufficient to seal around my new bathtub?

I installed a new tub which does not have a flange. Before I put up Duraboard what product, if any, should be used to seal the space outside of the tub's edge (garden/jacuzzi type of bathtub edge). ...
0
votes
1answer
3k views

How should I connect nipples to a hot water heater?

I recently installed my new hot water heater. I know nothing about plumbing and my installation procedure was informed only by sketchy home depot employees and youtube. One of the issues I'm having ...
1
vote
1answer
43 views

How can I sand the underside of an enamel sink?

we need clearance to install stem valves because the faucet hole was drilled too close to the sink. We need about 1/2" extra clearance. The counter top guys drilled too close to the sink and did not ...
0
votes
3answers
183 views

How do I mount this box without drilling or damaging the shelf?

I bought a network switch that I'd like to hang on the underside of a shelf immediately above my desk. The designers of the switch provides two screw holes on the underside of the box to mount it. ...
3
votes
1answer
215 views

What depth does a gate post need?

I have an entranceway between my house and a wall. There's a concrete walk in the center with small patches of dirt on each side. I want to put a wooden gate across with the posts sunk in the dirt. ...
1
vote
1answer
310 views

How to secure bookcase to drywall right over concrete without drilling concrete?

I got some tall bookcases and want to set them up against a wall in a condo. The wall is shared with my neighbor and as such it seems to be a half inch drywall right over a concrete wall, so I don't ...
1
vote
0answers
188 views

Installing a Sewer Cleanout

Recently I've been experiencing some backup with my toilet and tub due to some roots in our line. I've had Roto Rooter come out a couple times to do their thing and cut out some of the roots to ...
2
votes
2answers
286 views

How to fix this window on a stud wall?

We recently bought two of these windows on a garage sale of a local window provider. We were so happy to have found two windows of the same size with the right color on sale that we quickly bought ...
3
votes
3answers
734 views

How do I build floating shelves in a nook with a mirror behind it?

I have a bar nook area that I want to do something similar to the image below, but on the back of the shelves I want to put a large mirror. I was planning on ordering a custom cut mirror for the wall ...
3
votes
4answers
597 views

How do I adhere vinyl sheeting to carpet?

We foster puppies on a regular basis and in order to protect the carpet I am looking to cover a section of their room with vinyl sheet flooring where their pen is located. I thought about vinyl ...
2
votes
2answers
2k views

How do I install a bathroom fan with its own switch?

There is an existing light fixture and switch for the light fixture. I want to add a bath fan with its own switch. What is the easiest way?
0
votes
1answer
5k views

What can I do if my washing machine inlet hoses are not compatible with the plumbing?

I purchased a fully automatic washing machine and little did I realize that it requires special plumbing to fit inlet hoses to water source. All I have got in my house are the taps to which it can be ...
2
votes
1answer
602 views

How can I install an overhead water tank and refill it for individual usage?

I live in a group apartment where there is severe water supply problem. We have a common sump in basement which can be filled with water from external supply sources like water tanker trucks on ...
2
votes
2answers
407 views

What material should I use for a platform that holds 300-500 lbs?

I am making a flat platform with 4 leveling feet that can hold a 150 lb Corrosion-Resistant Heavy Duty Blower plus another 150-350 lb (so in total 300 - 500 lbs of mass). It is around 24" x 24". Do ...
0
votes
1answer
110 views

How do I wrap the pre-filter around the HEPA filter in this air purifier?

I bought this air purifier and was installing the pre-filter that came with it. The instructions go "Carefully wrap the pre-filter around the HEPA filter so that the ends meet. Fasten the ends ...