For questions generally relating to the proper insertion of a particular device or feature into a home, building or other structure. As this topic is very broad in general, when using this tag please include additional tags to narrow the scope of the discussion to a particular room, subsystem ...

learn more… | top users | synonyms

4
votes
1answer
2k views

How do I anchor an acrylic claw foot tub?

I have been working on remodeling my bathroom. As part of the renovations we have decided to replace our old tub with an acrylic claw foot tub. The tub is extremely light weight. I am assuming that ...
7
votes
3answers
10k views

How do I install wood shutters on a brick house?

I've built some Board-N-Batten shutters and am ready to hang them on the house. However, I've never installed shutters before, so I want to be sure I install them properly. Do I drill pilot holes in ...
6
votes
1answer
774 views

Installing new toilet. Does the wax ring have to fit snug around the hole in the underside of the toilet?

I got a new toilet complete with installation kit. The illustrations on the directions appear to say to apply the wax ring around the drain opening beneath the toilet then set the toilet down on the ...
4
votes
4answers
3k views

Do I have to check if my floor is level before installing new linoleum (from a roll, not tiles)?

I just tore up my old linoleum flooring and will be installing new linoleum in the next few days. Some internet research has revealed that I need to make sure the floor is level and, if it is not ...
4
votes
1answer
267 views

Can hurricane shutters be installed horizontally?

Looking at the photos at this site, it appears that they are able to be installed horizontally. Do you have to use a track or can you drill into the shutters and then Tapcon them to the masonry? I ...
1
vote
1answer
592 views

How do I find someone to install a utility pole?

I am in need of a fairly tall utility wooden pole installed on my property, which I'm sure requires special know how and equipment to do safely. I've been doing a lot of Googling and found a few ...
3
votes
2answers
364 views

How do I install a fire extinguisher on the side of a cabinet?

I want to hang my fire extinguisher on the cabinet next to my sink. Below are pictures of the fire extinguisher bracket and the location where I want to put it. Should I use a bolt with a nut - or ...
4
votes
1answer
309 views

Installing a new exterior door into a taller existing opening

We are remodeling our 1948 home, and the previous owner was quite tall. We are trying to replace our exterior door, and have come across a wonderful deal on a door. Here is the issue: How can I make ...
7
votes
6answers
3k views

Carpet company wants to charge me for the waste they will have left over. Is this normal?

My floor measures out at 296 sq ft, but the carpet company wants to charge me for 330 sq ft. Their reasoning is that they are not charging me for the actual square feet of total area, but for the ...
0
votes
2answers
333 views

When is the “best” time to get a gunite pool installed?

Is there a time of the year where pool installers are generally "cheaper", due to lack of business? I've heard that it's best to purchase decks in the fall, since that is the slow season. Just not ...
5
votes
1answer
77 views

Choosing Hurricane Shutters

In Florida, it is now officially hurricane season. I am in the market for aluminum hurricane shutters. However, I do have some questions. Home Depot offers aluminum shutters that are either 48 inches ...
5
votes
2answers
8k views

How do I install a portable air conditioning unit in a large sliding window?

I have a large sliding window that is 53 inches top to bottom and I want to install a portable air conditioning unit. The kind that don't sit in the windows but vent to the window. The window ...
1
vote
3answers
8k views

How to prep existing floor for installation of self-adhesive vinyl flooring?

Some quick background to preempt some discussion about quality, longevity, rental issues, etc.: I'm in a rental that is literally "anything goes". It's a long story, but suffice it to say if it does ...
2
votes
1answer
895 views

Removing knockouts in composite granite sink

The sink has one existing hole, and 3 knockouts which are cut about half way through the material. What are the best tools, and techniques for removing fixture knockouts on a composite granite ...
5
votes
1answer
125 views

Bought a US appliance and powered directly off Aus mains, is it boned?

Hope this is on topic for this stackexchange. I recently bought a lamp from the US and had it shipped to Australia. Stupidly I powered it straight off the mains through an adapter. The device is ...
3
votes
1answer
393 views

Kitchen Cabinets And Dry Wall Screws

I've got some kitchen cabinets that were hung using 4", course threaded, dry wall screwed. At every stud there is a screw at the top and bottom of the cabinet. Additionally, each cabinet is joined ...
3
votes
4answers
11k views

How do I install laminate counter tops? What are some tips/tricks to it?

I'm preparing to install a new laminate counter top in my kitchen; as this is the first I have installed by myself, I would like to know if there are any tip/tricks or things to look out for while ...
1
vote
1answer
212 views

Using screws to install a set of french doors?

I am installing a set of french doors. I have installed many doors before, but I was curious as to whether or not anyone has tried using countersunk screws to install the door? If I needed to adjust ...
2
votes
2answers
423 views

TV antenna moves a bit - problem?

I'm partway through installing my own outdoor TV antenna. I've gone with a "through the roof and screwed into a beam" method rather than the "sit on top of roof and stabilise using 3-4 wires screwed ...
1
vote
2answers
291 views

What is the order of installation for a stair railing?

I am rebuilding a set of steps, and have decided that I need to replace the handrail at the base of the steps. This is one of the exposed handrails, with ballisters and a newel at the end. This is a ...
3
votes
1answer
216 views

Tips for measuring a front door opening?

I'm getting ready to replace my front door with a brand new pre-hung door and have some questions regarding collecting measurements. Where exactly should I measure? I've heard people use the phrase ...
7
votes
3answers
2k views

Are new “low noise” whole house fans actually quieter?

I've dealt with a number of older whole house fans (10 years and older) and the one thing they all had in common was a ton of noise. Are the new "low noise" fans actually that much quieter than the ...
4
votes
3answers
9k views

How do I install a pre-hung door in a rough opening that's too wide?

I'm replacing an interior door -- including the original jamb -- in my house with a new 30" pre-hung door. With the jambs, the new door is 31 3/8" wide. However, the original rough opening is ...
14
votes
17answers
62k views

When installing hardwood floors, should I use rosin paper, roofing felt, or nothing underneath? Why?

I've installed hardwood floors, over top of OSB subfloor with a layer of roofing felt in between. I copied this from the hardwood floor contractor who did a kitchen in my home once. He'd been in ...
1
vote
2answers
2k views

How do I install hanging cabinets with a flimsy backing?

I went and watched this 1 min video clip about hanging cabinets: http://www.easy2diy.com/cm/easy/diy_ht_3d_index.asp?page_id=35750421 It seems to say to just screw my cabinets into the wall (where ...
6
votes
1answer
11k views

Do I need an outlet box to install an outdoor light fixture?

We're getting a sliding door and deck installed this week and the town inspector said I need to have an outside light by the door. I'm ready to tackle this part myself. Most of the howto stuff I ...
7
votes
3answers
6k views

What consistency should drywall mud be?

I've been reviewing various drywall videos and documentation but I haven't found clear details on what kind of thickness the joint compound should be. Is there a definitive answer for this? Or does ...
3
votes
3answers
990 views

What are the pros and cons of vinyl gutters?

I need to add some gutters to part of our house and I'm seriously considering vinyl gutters because they seem REALLY easy to setup (with minimal tools required too). That being said, I've heard some ...
5
votes
2answers
670 views

How Is “Super Laminate” flooring installed?

I recently learned about AABSO "Super Laminate" flooring (aka Vinyl flooring planks). It seems to have some advantages over standard laminate flooring when it comes to moisture resistance so I'm ...
7
votes
8answers
19k views

How do I uninstall a receptacle when the wires are stuck?

I just installed a receptacle in my basement and I realized I need to reinstall it someplace else. The leads are inserted into the holes behind the receptacle and I can't get them out! The ...
3
votes
2answers
856 views

Tips and advice for installing a chimney cap?

I have an older wood-burning fireplace that is missing a chimney cap. I'd like to install one prior to rain season here in California but would still like the ability to use the fireplace now and ...
2
votes
3answers
230 views

What should I look for in a Whole House Fan

I see a lot of variance in the prices of whole house fans in the market, and not a lot of clarity or comparison between vendors and models. We're looking to buy some to install in our newly purchased ...
6
votes
4answers
514 views

What's the easiest process for cutting bathroom flooring tiles to fit complex door trim?

I'm going to be laying in some fairly heavy-duty vinyl bathroom flooring tiles (similar to the Armstrong Caliber product, although I'm not sure it's actually that brand). The bathroom has some tough ...
11
votes
9answers
93k views

What direction should laminate flooring be placed in?

I'm thinking of installing laminate flooring and have a question: If I'm installing laminate throughout the house, should ALL of it be going in the same direction? Say for example, let's say I have ...
7
votes
3answers
4k views

Should my toilet flange sit on top of the backer board or the tile of the floor?

The bathroom model saga continues. The old toilet flange was rusting, and the subfloor was rotting, so I pulled up the subfloor around the toilet, and replaced the drain pipe with ABS, and an elbow. ...
5
votes
6answers
12k views

What material should I use for a custom, do-it-yourself desk for my home office?

I am currently remodeling my office, a converted formal dining room, and I am stuck on what material to use for the desktop. Currently I have a 1" thick Cherry Veneer particle board that is 6' wide x ...
4
votes
1answer
2k views

How do I add a quiet blower or fan to a gas fireplace?

I have beautiful fireplace in my family room, although it is gas rather than wood burning, and it vents strait outside. Due to the nature of how it is vented, I don't really get much heat from it, and ...
8
votes
4answers
357 views

Is air conditioner installation a DIY project?

We got a bargain on a brand new 6.2kw Split System Inverter Air Conditioner. The quotes we've received for installation are almost as much as the unit cost itself. Is this something I should be ...