1
vote
1answer
31 views

How can I sand the underside of an enamel sink?

we need clearance to install stem valves because the faucet hole was drilled too close to the sink. We need about 1/2" extra clearance. The counter top guys drilled too close to the sink and did not ...
2
votes
2answers
527 views

Should I secure a free-standing vanity sink to prevent drain pipe damage?

I recently installed a free-standing vanity sink in my laundry room, similar to the one pictured below. Due to the configuration of the drain and supply pipes in the room, the sink could not be ...
4
votes
5answers
5k views

How do I install this wall mount bathroom sink?

I'm replacing a sink that was on a vanity cabinet and hoping to do as little busting through the perfectly good tile as possible. I heard a rumor that I need to make very sure that the sink is ...
2
votes
1answer
791 views

Removing knockouts in composite granite sink

The sink has one existing hole, and 3 knockouts which are cut about half way through the material. What are the best tools, and techniques for removing fixture knockouts on a composite granite ...