0
votes
1answer
1k views

How should I connect nipples to a hot water heater?

I recently installed my new hot water heater. I know nothing about plumbing and my installation procedure was informed only by sketchy home depot employees and youtube. One of the issues I'm having ...
2
votes
1answer
378 views

How can I install an overhead water tank and refill it for individual usage?

I live in a group apartment where there is severe water supply problem. We have a common sump in basement which can be filled with water from external supply sources like water tanker trucks on ...
1
vote
1answer
176 views

How can I fix this broken connector piece on my Symmons shower Knob?

I was trying to get the knob off so I could potentially increase the amount of hot water getting mixed and it seemed to be coming off nicely but then snapped. By nicely, I mean it was a steady ...
5
votes
1answer
612 views

Should a curtain drain be covered/back filled?

I do some light maintenance and yard work in exchange for rent. The building had some problems with flooding. We have an extensive drain system, but it was a bit clogged. Even after the plumbers ...
4
votes
5answers
5k views

How do I install this wall mount bathroom sink?

I'm replacing a sink that was on a vanity cabinet and hoping to do as little busting through the perfectly good tile as possible. I heard a rumor that I need to make very sure that the sink is ...
1
vote
1answer
275 views

What should the water main connect to first: carbon filter or water softener?

I have an Amazon Gold carbon filter and water softener. It's not clear to me if the water main should go to the carbon filter first then to the water softener or vice versa. So, which goes first?
3
votes
1answer
322 views

How to add a drain pipe to a concrete block wall covered in insulation?

I want to run a 1.5" drain pipe along the wall about 2 feet from the floor to a microbrewery setup in the corner of my basement. I have sheets of fiberglass insulation against the walls though, and I ...
2
votes
1answer
791 views

Removing knockouts in composite granite sink

The sink has one existing hole, and 3 knockouts which are cut about half way through the material. What are the best tools, and techniques for removing fixture knockouts on a composite granite ...
6
votes
3answers
2k views

Should my toilet flange sit on top of the backer board or the tile of the floor?

The bathroom model saga continues. The old toilet flange was rusting, and the subfloor was rotting, so I pulled up the subfloor around the toilet, and replaced the drain pipe with ABS, and an elbow. ...