0
votes
1answer
50 views

Does HVAC lineset need to be grounded?

My HVAC contractor says the installation of the line set between the air handler and the condenser outside is complete but he has not grounded the lines. Do HVAC copper pipes need to be grounded?
2
votes
1answer
110 views

Breaker box or heat pump problem?

We ran our forced air heat pump today. 15 min. in we noticed it just stopped running. Looking in the breaker panel I could see that the breaker for the heating unit had tripped. When I tried to ...
3
votes
2answers
533 views

What kind of wall switch is needed for a natural gas fireplace to ignite consistently?

When we moved in, our natural gas fireplace worked well: Flick the switch & it would ignite. Years later, it started acting erratically: Sometimes, the switch worked, other times, no luck. We'd ...
0
votes
2answers
885 views

What size breaker and wire do I need for central air conditioning?

I am getting ready to hang drywall in my basement but before I do that, I need to run wire from the main panel upstairs to the future location of the central AC furnace through the basement ceiling ...
3
votes
1answer
81 views

How can I calculate the Btus needed for a single room A/C unit?

How many Btus is recommended for a room about 35 square meters? I have 2 units with 13,000 Btus each. I'm thinking it should be enough, but the room is just so-so cool. I can never say it's COLD in ...
1
vote
4answers
228 views

How can I calculate the power consumption of an A/C unit?

I have an AC unit with the following specs: Cooling Capacity: 1260 kcal/h, 1.47kW, 5000 Btu/h Fan Motor Power: 0.034 kW Current: 0.155 A My question is how much power does this unit actually ...
1
vote
2answers
175 views

How can I locate a short in a 24V central A/C circuit?

My A/C is not working. I checked the panel and the LED light code told me that there was a fuse blown or a short in the circuit. I checked and confirmed that the fuse had blown. If the fuse blows ...
6
votes
1answer
12k views

Why is my air conditioner tripping the circuit breaker?

Our air conditioner recently stopped blowing out cold air. When I went to check on it, I noticed that the outside unit wasn't coming on. We had had problems with ants in the contacter in the past, ...
3
votes
1answer
238 views

Does outside air conditioning compressor fan run all the time?

Had some electrical issues with an air conditioner and after I rewired it, I noticed that the fan was stopping every 30 seconds or so. Is this fan supposed to shut off when unit is running?
2
votes
3answers
498 views

How can I repair these rusty electrical connections?

When I turn on my air conditioner at the thermostat the vents kick on but nothing outside. Also the last time that it worked it took a few minutes to get going and was pretty loud. I checked the ...
1
vote
1answer
79 views

Plug HRV (Constructo 2.0 ES) into power bar?

Would there be any issues if I plugged this HRV into a power bar? I have this unit (says 200 watts of power) which is in the closet of the master bedroom and plugged directly into a wall socket. I ...
0
votes
1answer
113 views

How can I add a relay to the manual control for my HVAC unit?

I have a self standing HVAC unit that has a control panel with manual buttons. There is no thermostat. Eventually my goal is to create a relay that can be controlled via IR/RF so I can install a Nest ...
3
votes
1answer
127 views

How do I install a bathroom exhaust system?

We are set to close on our house in about three weeks and one of the problems that the inspector noted was that the vent in the guest bath vents into the attic (never going outside) and the master ...
0
votes
1answer
279 views

Why isn't my thermostat working?

I have an old Lennox (gas heat only) thermostat. There are 3 wires coming from the wall. Black, yellow and a light blue color (could be a faded green or an old dirty white). The thermostat wouldn't ...
0
votes
1answer
294 views

How can I get my thermostat C wire connected? [duplicate]

I have an older furnace, on the switch block I have Y,C.W,R and an unlabeled screw that connects to the shut off it looks like. I need to hook up a thermostat that needs the C wire. I have a spare ...
1
vote
1answer
892 views

Can you terminate more than one common on the furnace C terminal?

TL;DR: Can you terminate more than one common on the furnace C terminal? Background: I've linked a diagram of how my non-programmable thermostat is currently hooked up. I want to replace it with a ...
0
votes
2answers
2k views

How can I use a separate transformer to provide a C wire to my thermostat?

I Purchased the Honeywell WiFi Prog Thermostat to replace my Round Digital Honeywell Thermostat. I have separate Heating and Cooling (Heating is a Weil McLain Boiler for Hot water baseboard and Hot ...
5
votes
2answers
1k views

Should I be concerned about fridge/freezer airflow?

We just recently had the following counter/cabinet system put into our basement family room. After everything was done, I started to get concerned about airflow. The enclosure was built in such a ...
3
votes
1answer
3k views

Convert line voltage heating system to use low voltage thermostats

I currently have two line voltage ceiling radiant heating systems in my condo each with their own DPST thermostat. I'd like to use low voltage thermostats such as the nest. I found this ...
2
votes
1answer
3k views

How can I add a “C” common wire to this system? [duplicate]

I would like to add a "C" / Common wire hookup to my hvac system and get a fancy new thermostat. I've read Options for adding "C" wire to thermostat and still have some questions. First of ...
2
votes
2answers
5k views

How do I wire an old furnace motor so I can use it as a garage exhaust fan?

Since last I posted, I moved WAY south (lil warm down here) and the house I moved into was a foreclosure so a few things needed done, namely the AC and furnace. When the guy did the job he said he ...
3
votes
3answers
10k views

How much less power does a three-phase A\C unit use as apposed to a 220v unit?

I'm planning to install a 5 ton central AC. I'm deciding between a condensing unit that runs on 220V and a costlier unit that runs on 207Y three-phase. My understanding is that three-phase motors use ...
2
votes
2answers
280 views

How much current should I expect this motor to draw when it's running steadily?

This fan lists its "Max. Amperage" as 3.2. I assume the motor draws that much when it's first turning on, then settles down to some lower current. How much current should I expect it to draw when ...
3
votes
1answer
381 views

How can I protect A/C condenser wires?

I bought a replacement condenser fan motor for my outdoor A/C unit. The old unit was CW direction only. This one is CW/CCW and has 4 wires stick out of the side that change direction depending on how ...
3
votes
2answers
2k views

$400 electric bill traced to heater - what could be wrong with it?

Back in December/January, we got a real shocker; a $400+ electric bill. I thought there must be a billing error, so I went out to the meter, and found that not only was the number probably right, we'd ...
5
votes
2answers
596 views

Is it safe to install a sconce light box inside a return air space?

In my finished basement, the space between one section of studs is being used as a return air duct for my furnace and central air. Here is a picture, looking up from the vent at the floor level: ...
3
votes
3answers
3k views

Can I using a 3-phase connection to power 1-phase AC unit?

I have preparation for an AC connection with 3-phase 220V 3X16A breaker. I want to install a 220V 1-phase unit, which also needs a 16A breaker. The physical connection has screw-on terminals, so there ...
1
vote
2answers
4k views

How do I replace a condenser fan motor in a central air unit?

The condenser fan motor on my central air unit has seized up (tried like crazy to turn it it, but no go). I'm not sure how old the motor is but I'm guessing it's original, so about 12 years old. I ...
4
votes
2answers
107 views

DIYer to skilled tradesperson

What is the process a DIYer has to go through to become a skilled tradesperson? Are the only options apprenticeships, or are there other paths to follow to learn a trade/become licensed? What type ...