1
vote
2answers
103 views

How do I fill a hole above my shower where cockroaches are coming through?

I recently moved into an old brownstone and realized that there is a cockroach issue in the entire building. I'm working on getting rid of them but the other night I noticed some were near the ceiling ...
1
vote
3answers
75 views

Options for covering an in-wall safe removal?

I recently removed an in-wall safe which fit neatly between two 16"-on-center studs. But now I'm left with a big hole in the wall where the safe once was. Since the hole is behind a closet door, I'd ...
3
votes
1answer
492 views

How can I patch a hole in this brick wall?

I just pulled out the washing machine the old owners "kindly" left us to find a hole where the wall meets the floor. It's approximately 80mm x 50mm and goes down approx 100mm - below ground level - ...
4
votes
4answers
708 views

Oak doors stripped of paint - need to fill holes underneath before revarnishing/oiling

We've recently sent our doors for stripping of many years of gloss paint and lead based varnish. The oak doors came back looking largely fantastic. As the doors are very old, understandably they have ...
2
votes
1answer
167 views

Is it hazardous to leave a hole in the wall for a week or two?

Yesterday in a fit of manliness I accidentally punched a hole in the wall of my bedroom. I will eventually get some putty to fill in the hole but I'm concerned about the fibrous dust that may be in ...
0
votes
0answers
371 views

How can I patch a large hole in a metal bathtub?

My tub is rotting from the top and I'm not yet ready to replace it. Water collects along one of the short sides of the tub (not the end with the faucet, the opposite end) and that is rotting and now ...
14
votes
5answers
4k views

How can I fill a screw hole so it can be used again?

My dishwasher attaches to the cabinets on the side via a screw. This hole has become a little stripped, is there a way to fill it in and then screw in to it again? I can't change the location of ...
5
votes
5answers
27k views

How can I fix a stripped hole in an aluminum piece?

I have a tripod head that is made of aluminum. In the head there is a small hole that houses a small screw that secures a quick-release plate. After some time the hole stripped and the screw no longer ...