The tag has no wiki summary.

learn more… | top users | synonyms

2
votes
2answers
684 views

Why is my electric water heater making an intermittent groaning noise?

My 8 year old electric water heater started to make a strange rattling noise a couple of weeks ago. The noise happens at random and lasts for only a few minutes. Short bursts of noise about a minute ...
1
vote
1answer
21 views

water heater repair

Ihave an on demand water heater i have 3 40 amp breakers in sub pannel as that is what it calls for ,but only a 100 amp in main panel feeding sub panel.would this cause no hot water the lights are on ...
1
vote
1answer
36 views

Does water in the water heater drip pan mean my heater is bad?

I recently noticed my drip pan had about a half-inch of water in it. I could find no water leaks around the fittings or valves. The water is slowly evaporating--very dry climate area--and the water ...
0
votes
1answer
49 views

Why would I have to continually reset my hot tubs heater?

Trying to determine if I have a heater issue or maybe a sensor problem. Heater works and heats up the 2000 Grandee hot tub, but every few days it stops working. If I turn if off at breakers for a few ...
1
vote
0answers
11 views

can I replace a gas wall furnace with a gas pot belly stove?

Wall furnace on interior wall with hotwater heater behind the wall. Burns open to air. Stoves I am seeing online require exhaust or be placed on exterior side wall. Am confused about my options. ...
1
vote
0answers
24 views

Replaced Thermostat, Furnace worked for 1 cycle now blows cold

Hello I just replaced my old White-Rodgers thermostat because it just wasn't working consistently (sometimes it would turn on the furnace, but mostly it wouldn't). I swapped it with a White-Rodgers ...
1
vote
0answers
42 views

Why won't my outdoor patio propane heater light?

No propane is coming out and we did replace the valve from the tank. Any idea why it will not light?
1
vote
0answers
43 views

My gas heater relief valve keeps blowing, is the circulator installed backwards?

So I had a contractor put in a new circulator last season. Its a honeywell PC3F. I tried turning my heater on for the first time this season and the relief valve blew. I tried replacing that and ...
1
vote
0answers
394 views

Do I need to add a protective layer to insulation for wall heater?

I am going to install a 4000 watt wall heater to an add on. It is the kind of wall heater that is seated in the wall. i also plan to install insulation in between my wall studs. there will be ...
0
votes
0answers
15 views

Water heater inlet leak

I just installed a new water heater and something I noticed has bugging me so I thought I would ask. When I installed the heater I obviously closed the inlet gate valve but when I disconnected the ...
0
votes
0answers
51 views

How should I wire this 3 switch box in my bathroom?

I have a 3 switch box and the bottom switch that controls the heater was broken so I replaced it and I can't remember how to wire it, tried 10-15 combinations and it still doesn't work, not sure how. ...
0
votes
0answers
63 views

Baseboard heater install from room to room?

I am looking to install 240v electric baseboard heaters which will be fed with 12-2 on 20 amp breakers. I did my amperage calculation 4000/240v = 16.6 amps. So with that said I can run all my heaters ...
0
votes
0answers
1k views

Where to connect a c-wire on a furnace with existing two wire mercury thermostat

My existing thermostat is an old mercury two wire device, heat only. Looking to upgrade to a better model, but I need to run a c-wire. I don't know where to connect the wire at at the furnace, any ...