3
votes
1answer
208 views

What router bearing can I use to reduce groove depth?

I order this 3/32 slotting bit from Amazon. Shank size 1/4, depth of cut up to 9/16. I only need 3/8 depth (slightly over is ok), but I could not find the right bearing. There are router bearing ...
4
votes
2answers
738 views

Routing grooves in engineered hardwood flooring

This is an open-ended question. I will describe the situation and outline my approach to solving the problem. I am hoping to get feedback that will help me decide if this is the right approach, ...
2
votes
4answers
2k views

Can I float a tongue-and-grooved 1x12 pine floor over a concrete slab on grade?

I have bare concrete floor that was, until recently, covered with carpet. After recently seeing a friend of mine purchase raw pine, shape the tongue-and-groove himself, and seal it to achieve a ...