0
votes
0answers
33 views

Can two ground rods be bonded via a PVC conduit above ground?

According to my understanding, if a supplementary ground rod is installed, it must be bonded to the existing rod via a buried 6 AWG cable (NFPA 70). However, because virtually every side of my house ...
0
votes
2answers
97 views

Is it okay to drill a ground rod through pavement?

All the sides of my house are paved, and I need to drive a new ground rod for an antenna. Would it be against code (NEC) to drill a hole in the concrete to pound in a ground rod? Bonus question: How ...
3
votes
2answers
1k views

Can I terminate a ground wire to the neutral bus if the ground bus is full?

I have a Crouse-Hinds main load center. The ground bus is at the top left of panel and the neutral bus is at the bottom right of the panel. I want to add a 15 amp circuit for two outlets in my ...
2
votes
2answers
2k views

Can I extend the ground/bus bar in a main service to accomodate subpanel equipment ground?

I am about to replace the main service breaker panel in my house. The old panel (a 200amp Siemens 40-circuit) had bus bars that extended the entire vertical length of the box. The new panel I would ...
5
votes
1answer
331 views

Can a single metal electrical box use two ground clips?

Inside a metal electrical box, can I use multiple ground clips (one for each conductor), or is it required that all ground conductors be twisted together and pigtailed into the same clip?