Ground fault circuit interrupter, also referred to GFCI, GFI, or a residual-current device. This devices detects a leak in current, or an imbalance between the current on the hot and neutral wires. This is used to prevent electrical shock.

learn more… | top users | synonyms

1
vote
3answers
617 views

How do I wire this switch/outlet combo?

This 5 minute task has kept me busy for an hour. Old switch/outlet combo melted. Replacing with gfci combo. Red/White pair is the line. Orange/White pair is the load to the light. Strangely, ...
0
votes
3answers
42 views

What breaker size for box containing two GFCI circuits?

What should the main panel breaker size be to control a 60amp GFCI for a hot tub and a 15amp GFCI outlet. The gfci's are mounted in a box that will be wired to the main panel.
1
vote
1answer
751 views

GFCI combination switch and outlet to fully switched protected outlet

Before a single screw comes out of the wall, I need to be sure I understand this fully, and rather than type out everything, I made a diagram based on what I was able to dig up on forums. This is for ...
0
votes
1answer
27 views

GFCI issue with grounded protected receptacle

Trying to wire GFCI and a protected receptacle into the same box for 4 outlet set up. When I wire protected receptacle to LOAD side and connect it to the ground, the GFCI test fails. If I ...
0
votes
1answer
25 views

Do newer GFCI receptacles still trip due to inductive load from motors?

I am rewiring a kitchen and faced with a dilemma of having the garbage disposal on a GFCI circuit. Will it trip when turned off like the older GFCI's?
0
votes
1answer
57 views

New GFCI in garage is tripping when driveway lights are turned on

So I had GFCI outlets put into the garage to use for Christmas lights outside. After installing, the christmas lights all work great but when I flip the switch in the foyer for the lights at the end ...
0
votes
1answer
46 views

GFCI trips after adding new circuit to it

Preface: I am a complete newbie when it comes to electrical circuits. I usually have electricians do all the work in our house. An electrician installed a circuit in our backyard with 8 outlets on ...
0
votes
1answer
168 views

Efficient way to determine line and load

My townhouse was built in the early 1980's, and since it was built, the state laws around which outlets are on a GFCI line have changed. The wiring itself is fine, just the receptacles need to be ...
0
votes
1answer
55 views

What could be causing my GFCI outlet to trip?

I have a GFCI outlet in my garage that keeps shutting off. I have unplugged all utilities from it and it still trips off. I replaced it with another GFCI outlet. When I hooked up that new outlet it ...
2
votes
0answers
39 views

Outlets that seem to be on same circuit, but not behaving that way

I'm trying to install a GFCI outlet in my kitchen. My understanding is that you can install one GFCI on the circuit and this will protect all of the other outlets. This is assuming that the GFCI ...
2
votes
0answers
95 views

Is there a safe alternative to electrical grounding for computers in Argentina?

I came across this APC product page for Microsol Isolator Modules, which purportedly provide "safe power in places with poor or nonexistent grounding." The unit is meant for Brazil, so it won't work ...
1
vote
0answers
58 views

GFCI breaker trips when switched on

I'm buying a house. It's an old house. I had to put in a GFCI breaker for the bathroom. It trips as soon as I switch it on. If I disconnect the neutral it doesn't trip. It is three wire coming ...
1
vote
0answers
41 views

what could cause my gfci to randomly trip?

I'm in the process of finishing my basement, and am almost done with the electrical rough-in. The whole thing is open studs at this time, so any sort of reconfiguration is easily possible. I have a ...
1
vote
0answers
75 views

Breaker to outdoor Sub panel keep tripping

Need help with my outdoor kitchen fridge. A 20 amp fuse at the main box goes takes a 10/2 w/ground wire to a sub panel. The sub panel has two 15 amp breakers circuit one goes to a storage shed via ...
1
vote
0answers
93 views

Washing machine randomly tripping GFCI

I read a previous question regarding a GFCI outlet and a washing machine, but my issue is slightly different. I have 2 GFCI outlets in a washroom in the downstairs of my home. One is obviously ...
1
vote
0answers
84 views

Wiring a gfci switch combo…I can't get the light to turn off?

I have a Pass & Seymour GFCI Switch/outlet combo. I am replacing a switch/outlet combo that was a non gfci. I haver three wires coming into the box. The hot wire, the wire to the light and a ...
1
vote
0answers
252 views

Gas Dryer suddenly trips any GFCI Outlet immediately upon being plugged in, but works fine in non GFCI

I have a Maytag Centennial gas clothes dryer in my laundry room. It is connected to a non-gfci outlet which is downstream of another outlet with built in gfci. It has been connected like this and ...
1
vote
0answers
43 views

What's wrong with my replacement GFCI outlet?

I'm trying to replace a GFCI outlet in my bathroom. (the old one trips almost every time you plug something in) When I connect the line wires from the panel to the line poles and the load wires to ...
1
vote
0answers
704 views

Why do I have a 3 wire/double pole breaker for kitchen receptacle?

I am switching my kitchen receptacle to a GFI; it has 3 wires. I'm pretty sure I have to break the bar between the two hot screws, thus making the top and bottom on a separate circuit. What is the ...
1
vote
0answers
426 views

Washer tripping gfi outlet

I've been living in my house for almost two years and my washer and dryer have been working fine. I have a maytag Neptune washer and dryer, just the other day I took a packet of tide washing machine ...
1
vote
0answers
344 views

How to finish the wiring of a shared GFCI receptacle

My neighbor who is an electrician helped me start an electrical project in my garage but has been MIA for 3 weeks and I'm not sure how to finish the wiring of the receptacles. He didn't seem to start ...
0
votes
0answers
19 views

Outlet problems after GFCI replacement

Replaced a GFCI outlet to the right of my sink. Was careful to mark all wires and photo with my iPhone. Hooked it all back up and it worked and tested fine. The outlet to the right of the GFCI will ...
0
votes
0answers
27 views

20/30 GFCI spa disconnect

Instead of spending 400 on a spa disconnect with a 2 pole 20 amp gfci and a 2 pole 30 amp gfci breaker. Can I take the 50-60 amp gfci breaker from the spa disco, put that in the main panel and use ...
0
votes
0answers
34 views

Need to Convert GCFI to Non GFCI outlets on generator

I have a gas powered electric start dewalt 7000 watt 240AMp generator with 4 GFCI outlets, the machine I need to run off the generator trips the breakers. Even when i run it off the factory provided ...
0
votes
0answers
19 views

GFI - Five Wires Plus Ground

Installing GFI. Five wires plus Ground in box. Two black, one white, two beige, one bare. One romex has a black and white. Black is hot. Another romex has one beige which is hot (from a red, black, ...
0
votes
0answers
49 views

Fluorescent lights tripping GFCI

I'm not very strong with electrical, but I can do basic repairs. I plugged an extension cord in and somehow the 15 amp GFCI in my garage blew. I replaced it with a new 15 amp GFCI. I now have power to ...
0
votes
0answers
69 views

How do I prevent my generator from permanently tripping my GFCI breakers?

I have an old house with a new addition. The new addition has a subpanel to the od house panel. This new subpanel required GFCI breakers. When I started the generator it tripped all these GFCI ...
0
votes
0answers
626 views

Can a GFCI receptacle share the neutral wire of another circuit?

When I connect my GFCI receptacle on one circuit that shares the neutral wire with another circuit, it immediately faults out. If I remove the second circuit from the neutral there is no problem.
0
votes
0answers
56 views

Cant seem to get the GFCI to work

I'm not an electrician - I know enough to get basic wiring accomplished... or so I thought. I'm finishing my basement, and we ran 5 new outlets, in conduit, all are 15a. I have a box right next to ...
0
votes
0answers
108 views

Why won't a replacement GFCI work when the old one was wired identically?

I am trying to replace an old GFCI outlet box in the bathroom. I bought a new one and wired it the same as the old one (the new one had extra screws). The new outlet has a tiny green light on the ...
0
votes
0answers
257 views

How do I wire a GFCI with 5 wires?

How do I install a GFCI receptacle with 2 black and 3 white wires plus a ground? I have two such regular receptacles next to sinks and should replace them before the upcoming home inspection, please ...
0
votes
0answers
298 views

Why is my bathroom vent fan tripping the GFCI when being shut off?

I have a GFCI tripping when a vent fan is being shut off. I saw in KeithS's answer to a similar question that the blades rotating after shut off causes an imbalance, tripping the GFCI. In my case the ...
0
votes
0answers
68 views

GFCI circuit partially works

While making coffee using downstream outlet, it just stopped. My GFCI outlet works and it isn't disconnecting. The test button also works but downstream outlets don't. What would cause that? ...
0
votes
0answers
215 views

Why does a GFCI breaker and receptacle on the same circuit cause tripping tripping?

I work in the apt industry as maintenance, currently on a new property. I had a call this weekend about no power in kitchen outlets or dining room. I found a GFCI outlet in the run, tried resetting it ...