2
votes
2answers
136 views

Did I damage the breaker by incorrectly wiring a generator?

During a power outage I attached my generator incorrectly (I have never done this before - I just was not paying attention). Anyway, I crossed the ground at the box with the black. When I turned on ...
1
vote
1answer
191 views

Can I install two GFCI receptacles on a multiwire branch circuit?

I am wondering if I'm using a 10/3 teck cable to power two 20 amp GFCI receptacles for a temporary power situation, can I use two separate single pole 20 amp breakers at the panel for each receptacle. ...
1
vote
0answers
172 views

Why do I have a 3 wire/double pole breaker for kitchen receptacle?

I am switching my kitchen receptacle to a GFI; it has 3 wires. I'm pretty sure I have to break the bar between the two hot screws, thus making the top and bottom on a separate circuit. What is the ...
1
vote
1answer
389 views

What could be causing a new 20 amp dedicated circuit supported by a GFCI breaker to trip?

I installed a dedicated 20amp circuit home run to support a single duplex outlet in a bathroom. The GFCI breaker is wired correctly. However, When I plug in a load such as a light a the breaker ...
4
votes
3answers
2k views

Why does my circuit breaker trip with any small load, even after replacing the breaker?

I have a 20A 240V GFCI breaker in my main breaker box going to a conduit to another breaker box outside. All worked well last summer. Now, when I put any load (weed-eater, light, etc.) on an outlet ...
6
votes
1answer
2k views

GFCI outlet won't come on

I have a couple recently installed (By a professional licensed electrician) GFCI outlets outside a barn, both on their own circuit. Both have water trough heaters plugged into them - 1500 watts each. ...