The tag has no wiki summary.

learn more… | top users | synonyms

0
votes
1answer
35 views

How do I determine what size Generator I need?

What are the number of factors and considerations to be taken into account before sizing a prime rated generator ??
0
votes
0answers
29 views

What do I do with the neutral and ground when wiring a transfer switch?

I know there are a lot of questions about wiring a generator to a home electrical panel, but I can't find the answer to the questions that I have. I would like to wire a generator that has the ...
0
votes
1answer
176 views

L14-30 Plug & Generator

Please move if this is the incorrect place. I have a portable generator that is mounted to a car trailer. No earth grounds are made from the generator to the ground. There is a service panel inside ...
0
votes
2answers
119 views

Should I drill through the concrete garage wall to install a generator inlet switch inside?

I recently purchased a generator in the aftermath of the ice storms in the Northeast. I'm quit handy with the electrical wiring in my house and have no issue installing the proper circuit for the ...
1
vote
2answers
129 views

How do I get my small portable generator started?

My portable generator has been sitting for quite awhile. I drained out the old gas and refilled. Squirted carburetor cleaner. Spray starting fluid it starts as long as starting fluid is squirted. ...
0
votes
1answer
237 views

Can I connect my generator transfer switch to a subpanel instead of to the main panel?

My house has a generator transfer switch (ProTran 30310B) attached to circuits in the main panel (see photo). I added an attached garage to the house. I want to add a subpanel in the garage, ...
2
votes
3answers
722 views

How can I shut off circuits when I have a generator with an automatic transfer switch?

We had professionals install a generator with an automatic transfer switch. I showed them our circuit-breaker box and told them which circuit numbers should be on generator power. Okay, everything's ...
1
vote
2answers
70 views

How can I switch between two generator inlets?

I recently pulled a permit and installed a 30A generator inlet and backfeed breaker w/ interlock. However, I actually would like to install a second inlet in an alternate location and be able to ...
7
votes
3answers
450 views

How can I ensure portable generator success during a long natural disaster?

I live in the SF Bay Area. My house is blocks from the Hayward Fault, where a large earthquake is likely during my lifetime. Along with the usual disaster-prep things (water, food, etc.) I'm ...
0
votes
2answers
1k views

Which type of portable generator will power my furnace during an outage?

I live in New Jersey, and in preparation for future severe-weather-related outages, I would like to have a backup plan in order to power my natural gas furnace, as well as the fridge/freezer and a few ...
2
votes
2answers
156 views

Did I damage the breaker by incorrectly wiring a generator?

During a power outage I attached my generator incorrectly (I have never done this before - I just was not paying attention). Anyway, I crossed the ground at the box with the black. When I turned on ...
2
votes
2answers
683 views

Can I connect a portable generator to a subpanel to backfeed my house?

I have a portable 6500 W generator. I have a main house electrical panel and a subpanel in my garage, which are on opposite sides of the house. My subpanel is on the outside wall of my garage. The ...
2
votes
1answer
107 views

Why is my emergency generator hard to pull for starting?

My portable generator ran fine for 5 hours, then ran out of gas. I refilled the tank but now the pull is excessively hard and the unit will not start. I removed the spark plug and the pull was ...
12
votes
4answers
35k views

Can I backfeed a portable generator into my house's electrical system?

Is there a safe way to power my house using a portable generator? The power rating for the generator is 6kW, and I want to run my electric water heater (4.5kW) and my refrigerator (0.5kW) and possibly ...
1
vote
1answer
58 views

Testing generator output

I'm having trouble getting a 6kw generator to power a sub panel that was installed by a licensed electrician. I would like to be able to test the generator's output. How do I do that?
7
votes
3answers
7k views

Are generator interlock kits permitted in residential applications?

There have been some questions on the site lately, that reference using interlock kits with portable generators. This has inspired me to read through article 702 Optional Standby Systems of the ...
2
votes
2answers
7k views

Why won't my portable generator start?

With a storm bearing down on the mid-Atlantic US and robocalls from the local power utility warning of the possibility of extended power outages, I figured tonight would be a good time to check the ...
3
votes
2answers
3k views

Can my generator power my deep well water pump?

I have a 120/240 volt generator with an output of 3250 watts peaking at 3750. I want to be able to power my well water pump but I'm getting conflicting answers on whether this generator packs enough ...
5
votes
2answers
484 views

Are the wires for my generator transfer switch undersized?

I purchased a Reliance Q510-C transfer switch to use with a 50 amp generator at my house. The transfer switch is rated at 50 amps. I have wired it into my main electrical box. I also wired a 50-amp ...
0
votes
0answers
158 views

Installing a standby generator

I am planing to install a generator and I have drawn a diagram of what I plan to do. I am not sure of the neutral and neutral to ground bonding. Would someone kindly look at my plan and tell me if I ...
1
vote
1answer
437 views

Can I connect the generator neutral to my mains neutral permanently?

I have a 3 phase 15KW generator with four wires. I want to use it as a standby generator for my house. My house uses 1 phase 220 volts on two wires (no ground as the house is quite old). I have a 3 ...
0
votes
1answer
207 views

How can I install this automatic transfer switch?

I currently have a Gentran 3028 subpanel connected to a 12,000 watt generator over a 30 AMP branch and the utility/main panel over a 60 AMP branch. I want to replace the Gentran with a APC UTS10BI. ...
4
votes
2answers
392 views

Will my wood platform support my generator?

I built a wood platform out of pressure treated lumber 6ft X 4ft 2x6 with beams every 16 inches and 2x6 deck. It is bolted into the house 2x10 on the 6 ft rear wall and carriage bolted to an existing ...
1
vote
1answer
141 views

How do I select the right generator?

I'm looking for advice on what kind of generator I should get for my mobile home. We have had 3 pretty bad storms (2 hurricanes, 1 blizzard) and am looking to give my home backup power. Now I have ...
1
vote
1answer
5k views

What size wire do I need to connect a portable generator inlet to my main panel?

I am planning on installing an interlock kit and backfeeding my panel with my portable generator. The backfeed will be to a 30 amp breaker, coming from the 240/30A outlet on my Generac 5500. The ...
5
votes
1answer
350 views

Is it reasonable to create a 30amp branch circuit for the purpose of feeding the panel from a generator?

I recently purchased an 8kW generator (Briggs and Stratton). It has a 4-wire twist lock outlet that can handle 30 amps. Suppose I were to: Run a 10/3 NM cable from the panel in the basement out to ...
6
votes
3answers
3k views

What is a good generator for emergency backup?

So recently, during Irene, I learned that my car's lighter outlet was insufficient to power a sump-pump (hello, two inches of water in the master bedroom) Thankfully, the car's circuitry was fine but ...
3
votes
1answer
252 views

Does a replacement propane supply line have to be made of a special material?

One of the propane rubber hoses in a portable generator has cracked and broken in several spots while the other one is in fine condition. As a stop gap a washing machine supply line was cut and used. ...
1
vote
1answer
206 views

Wood heating - Problems with power failures. Need some advice

My sister uses wood heating in here house. Her heating system has temperature control but of course does not work without electricity. If electricity goes off the temperature can grow ...
4
votes
2answers
236 views

What Good and Affordable Alternative Power Source Would You Recommend?

I am woking on a startup (read: using my computer always). 80% of the time, I generate my own electricity with a petrol/gas generator. On new years day, the Nigerian government increased the price of ...
3
votes
1answer
759 views

Should a generator transfer switch have continuity between all contacts in the “Gen” position?

I am finishing up installing my generator transfer switch today and I think I have a wiring problem... I have a six circuit transfer switch wired in with a power inlet box outside. Everything is ...
3
votes
2answers
2k views

How do I troubleshoot my generator and transfer switch installation?

I recently mounted a 10 circuit Transfer switch and attached about half of the wires to the electrical panel. After I start and plug in the generator, some of the circuits work fine (well pump, which ...
3
votes
1answer
5k views

How can I get a standby generator with GFI to work with a 2-pole transfer switch?

I have a home standby generator that is equipped with a GFI, and my original electrician (who has long since flaked out on me leaving me in a lurch with this) installed a standard 2-pole transfer ...
4
votes
1answer
168 views

Can I retrofit a wind-power system for my home?

I live in a VERY windy place. My neighborhood is a new development of your typical suburban single family homes. There isn't really room for a full windmill, nor would it look very well. But there has ...
2
votes
1answer
3k views

Generator carburetor problem, is it the float?

Hopefully this is an appropriate place to post: I had to use my generator today and it ran fine for about an hour but when I went outside to check on it, I noticed it was dripping gas from the ...