1
vote
0answers
44 views

How should I support a large gate in a vinyl fence?

I'm adding a new gate in my vinyl fence; a full width (6') gate. I'm concerned about support. The fence posts are decently moored, but there is still some wiggle. Would it be better to dig out and ...
2
votes
1answer
211 views

Should I use wood or metal for an 8" gate post?

I am replacing the wooden gate post of my farm's entrance. I have a solar-powered electric opener and am using a 16 foot tubular gate. I want two 8" posts, 12' tall, either metal or wood. Which would ...
9
votes
2answers
7k views

How deep should I sink a gatepost for a 7' wide gate in my fence?

I am a first time fence builder, which will be 6ft cedar. I need a gate that is 7 to 8 ft wide. I live in Oregon and the frost line is only a foot deep. I was planning on a 7ft gate with a 6x6 post. ...
2
votes
1answer
1k views

What gauge fence post should I use for a 36" wide wooden gate?

I want to attach a gate to a fence where the fence will be attached to a 2 3/8 in. metal post. What gauge should the post be for proper support? The fence will be a six foot wooden fence, as will ...
7
votes
2answers
1k views

What's the best way to adjust a leaning gate post?

I recently built a large double wood gate using 6x6x8 posts. Each post was set with concrete in a 26" hole. After some settling, one of the posts is now leaning about 1/4 inch toward the middle. ...
2
votes
2answers
8k views

What size posts do I need to use to build a wooden driveway gate?

I have just built a 6 foot fence all the way around my property. To finish it offI need to build a driveway gate. The gate will be 15 feet wide and have two swing gate sections. I have used 4x4x8 foot ...