1
vote
2answers
78 views

How does one upgrade garage electrical from an In-House main?

tl;dr Want to know the easiest way to upgrade electrical in garage from 15A to 20A. Actual Post Garage is on a 15 amp circuit, doesn't work out too well for a 15A air compressor. The main is in ...
1
vote
1answer
66 views

Wiring requirements for garage and bedroom addition

I've just added a new garage and bedroom and am about to wire them. I've done a lot of wiring in my house, know all the basic requirements for how wiring is run, etc, never had a problem with ...
2
votes
1answer
251 views

Can I upgrade my garage to 20amp service without a headache?

I have an unfinished garage which I am looking to upgrade the service to. Currently it is 15amps running through some difficult to access sub-ground conduit, but if I run the band saw plus the ...
0
votes
1answer
5k views

Network Garage Door opener/ how does the switch work

I'm trying to connect a relay/switch to a Garage door(Lift Master). I know that there are two wires to trigger the garage door. I'm not sure how it works exactly. I'm trying to control the garage ...
6
votes
1answer
2k views

How can I replace a light fixture?

I need someone to sort out this wiring question for me. I'm trying to hang a flourenscent light in the garage, however, when I took the old garage light out (one of those round, single light ...
4
votes
1answer
3k views

What are the requirements for wiring an unfinished garage with lights and outlets?

I found this DIY article online which suggests that running Romex along the center faces of studs and rafters was code compliant for unfinished garages. How to Wire a Garage The article is dated ...
4
votes
3answers
1k views

What voltage/amperage garage circuits should I install for welding tools and an air compressor?

As a part of renovating my garage this fall, much of the wiring is being re-done. Since doing the work before putting up walls will be much easier now than adding circuits in the future, I'd like to ...