The furnace is part of an HVAC or central heating system used to generate heat. Typically this is done with gas, a heat pump, or an electric element. For hot water and radiator based heating, use the boiler tag.

learn more… | top users | synonyms

3
votes
4answers
4k views

Why would a furnace overheat with a standard density filter?

Some time ago I found my furnace (gas, forced air, downdraft) was getting stuck on, blowing cold air. I could reset it, but it would happen again after a while. After calling out a service man, I ...
0
votes
1answer
141 views

Legal requirements regarding 100% asbestos duct work [closed]

I am renting a condo. After starting the heater, dusty air came out of the registers, so I called out a company to clean the ducts. They verified the ducts are 100% asbestos and cannot be cleaned. ...
1
vote
0answers
1k views

Why is my furnace limit tripping?

My furnace is tripping the high limit. It is a Downflow Payne 90+ have replaced the limit switch. I pulled the blower door off and checked all vents to ensure they are open and it still short cycles. ...
1
vote
1answer
173 views

Can I install a flow through humidifier on either side of the duct?

I was about to install a Wait6000 whole home humidifier when I hit this snag in the plan. On page 3 of their manual (PDF), it says the cold air return duct must be at least 10" wide. The diagram ...
5
votes
3answers
571 views

Should the fill line be removed when decommissioning an old oil tank?

So, I have a contractor decommissioning my old 650-gallon oil tank. There is a 3" metal tube coming out of the ground from the tank that is what I believe to be the receptacle used to fill the tank ...
0
votes
2answers
14k views

What size breaker and wire do I need for central air conditioning?

I am getting ready to hang drywall in my basement but before I do that, I need to run wire from the main panel upstairs to the future location of the central AC furnace through the basement ceiling ...
1
vote
2answers
297 views

How do I close this hole in the HVAC vent?

What's the best way to close up this hole in the venting leaving the hvac? Would foil tape be sufficient? Right now it bleeds out hot air into the basement in the winter, and cold air in the summer. ...
1
vote
1answer
1k views

Furnace won't adjust to thermostat setting

I have a 2007 Trane furnace that has been working the AC all summer just fine. With the cooler weather, when I turn on the heat and set the thermostat to 72 degrees, the furnace comes on but heats the ...
1
vote
4answers
1k views

Are 5" thick filters for furnace/Central AC still available?

My furnace/AC was installed about three years ago. It uses 16" X 25" X 5" filters. The problem is when I try to find a replacement at my local home center: at Lowe's, Home Depot, (you name it), I ...
0
votes
1answer
539 views

How do I maintain an 80% efficient natural gas furnace?

I have an 80% efficient gas furnace at my house, that is seemingly working well and is configured with an air conditioner. What preventative maintenance should be done to it, and at what interval? Is ...
0
votes
2answers
3k views

lennox furnace not working pilot light on but burner doesn't start

lennox furnace, model # G20Q2E-75-C1, serial #6392H32332, pilot light lights, blower motor turns on, burner doesn't burn
3
votes
2answers
2k views

Can I piggyback a thermostat with a C Wire hookup on a furnace?

I'm trying to install a new thermostat that needs a C wire hookup. There are currently 4 wires running from the thermostat to the furnace, none of them are a c wire. When I look at my furnace itself ...
3
votes
1answer
200 views

Should I use a quick or gradual 90 in my flexible A/C ductwork?

To elaborate a bit more. If you are running an 8" duct off the supply, would you do a quick 90 degree towards the destination or do a gradual 90 degree? I would guess a quick would be better because ...
2
votes
2answers
1k views

Can I remove the fresh air supply that is attached next to my furnace?

It looks like my gas furnace is already vented but I'm not sure. There are two white pipes from the top of the furnace that are vented outside. The furnace is a Trane XR90. We have cold winter climate ...
3
votes
1answer
1k views

How can I prevent water from entering through water heater/furnace exhaust vent?

I have an exhaust vent in my basement (Amerivent Type B) which takes the exhaust from my gas furnace and water heater goes out the basement wall, and up my chimney. A little bit water is coming in to ...
1
vote
1answer
230 views

Replacing Oil Furnace with Heat Pump

My wife and I would like to remove the older oil heat from our home and replace it with a heat pump. We currently have an Amana central air conditioning unit (3 ton), and an oil furnace in the ...
3
votes
1answer
18k views

Why is water collecting in the base of my furnace?

I changed my filter the other day and noticed a pool of water in the bottom of the furnace, below the filter. The humidifier has been off so that's not the issue. I removed the furnace panels and see ...
1
vote
1answer
1k views

Why is the circuit breaker for my furnace stuck in the off position?

The breaker for my furnace is stuck in the off position. We were away for the winter and had someone shut it off, and now the breaker won't turn on at all. We shut off the thermostat upstairs thinking ...
2
votes
1answer
133 views

Can a non-expandable filter be used in place of an EZ flex furnace filter?

My Carrier furnace has the EZ flex filters (16x25x5). These come with the plastic end caps that fit on the expandable filters. Can a regular filter, non expandable, of the same dimensions be used as ...
2
votes
1answer
352 views

What is a quieter alternative to gas forced air heating?

My small 1BR apartment has an old gas furnace that works great, but costs my landlord too much to insure. He plans to install gas forced air, an in-unit upright furnace. I'd love to suggest a ...
0
votes
1answer
119 views

What to look for in a new furnace

I've recently been told that my furnace, which is about 20 years old, is on it's last stretch and that I should consider replacing it now rather than waiting for it to fail - potentially at a very ...
1
vote
2answers
6k views

How do I build a firewall around my furnace/water heater?

I'm in the planning stage of finishing my basement. I'd like to section off the furnace and water heater, and am assuming that I should fireproof that section of the build. What's the best way to go ...
3
votes
2answers
800 views

How is a high altitude natural gas burner different?

What is the difference between high altitude natural gas burner and conventional low altitude gas burner and why high altitude natural gas burner are needed?
8
votes
1answer
366 views

Should I relocate the HVAC unit in my attic?

I have had a couple of estimates to replace our HVAC system and one contractor says he would relocate the system to a more central location in the attic. One says there is no need to relocate. There ...
3
votes
3answers
15k views

If I turn off the breaker to the Gas furnace will the pilot light go out?

I need to turn off the breaker for the furnace but am afraid this will turn off the pilot light to my gas furnace & I don't know how to relight it. Are any special steps necessary to prevent ...
1
vote
2answers
373 views

How do I interpret my furnace clearance diagram?

My brother-in-law and I are going to be finishing my basement. We just got the permit from the building inspector. When they returned my plans there was a note that told me to make sure furnace and ...
1
vote
2answers
1k views

Why is my furnace blower coming on so early in the ignition process?

Alright, I installed a new furnace a few months ago and have begun to notice an issue with the blowers. When the furnace first starts up, the exhaust blower should turn on to expel gas, then the ...
2
votes
2answers
541 views

Can I move my furnace room ventilation intake closer to my furnace?

I live in a 3 story townhouse with a garage in the basement. Off the side of the garage is our furnace room. The ventilation and exhaust for the furnace goes to the roof. For ventilation (air coming ...
9
votes
4answers
19k views

Does lowering the blower speed of a forced-air furnace lower its efficiency?

My gas furnace has two options for the blower speed: MED, and MED-HI. It had been set on the higher speed, but that was too harsh, so I lowered it to the slower speed. Does that have any impact on the ...
10
votes
2answers
16k views

What does a Summer/Winter switch on furnace air ducts do?

On some of our furnace ducts, there is a switch/valve for Summer/Winter or S/W. What does changing this switch/lever accomplish? Can bad things happen if I forget to switch it? Bonus question: ...
4
votes
1answer
726 views

How can I unbend a bent furnace filter slot?

I recently bought a new home. When going to change the furnace filter, I couldn't get the original furnace filter out of the slot at the last part of the filter (where the cardboard border is). Since ...
0
votes
0answers
288 views

How can I provide my furnace with outside combustion makeup air?

I cut a 6" opening in an insulated door into the utility room then installed a 6" metal duct with a plastic exterior vent cover. I put 6" insulated flexible duct on the interior stub and let it hang ...
4
votes
1answer
6k views

Can a washer and dryer be next to a water heater?

I have a GE gas dryer (DSXH47GGWW) that is currently next to an exterior basement wall. I'd like to move it to the opposite wall (shared with the crawl space) right next to the water heater next to ...
4
votes
2answers
20k views

How can I determine why my furnace is not blowing enough heat?

During a cold spell last week when temperatures got down to -23f (-31C) my furnace started showing issues with blowing enough air and the air was not very warm. Last winter it did not have any issues ...
1
vote
3answers
14k views

Why is my Lennox g40uh series furnace not turning on?

I have a Lennox g40uh series furnace and it just stopped working today. I can reset the furnace and can see that on the control board both LEDs (green and red) are blinking together which indicates ...
1
vote
0answers
1k views

What's causing my draft inducer to stay on?

I have a new, 3-year old, high-efficiency, gas furnace in my home. I recently realized that my draft inducer, which normally kicks on before the burners and before the main blower, is not stopping. ...
4
votes
3answers
8k views

What's causing the rumbling sound when my furnace kicks on?

I have a new, 3-year old, high-efficiency furnace in my home. Last year it started making a slight whining noise that was audible during the very first stage, before the blower motor started. No ...
2
votes
0answers
315 views

Are w1 and w2 both energized during a second stage heat call from the thermostat?

Short version: does two-stage thermostat always close W1 circuit when it closes W2 circuit, or they might be closed independently? Long version: I have two-stage furnace, currently connected to older ...
2
votes
1answer
456 views

Will I see any performance gains if I reconfigure my thermostat to control the second stage of my 2 stage furnace?

Our furnace is a two stage one that was installed last year (a Bryant 80t). When it was installed, it was installed with a thermostat for a one stage furnace. This appears to be because this model ...
1
vote
1answer
3k views

Why does my pilot light go out continuously?

My furnace pilot light keeps going out. The furnace will come on and heat up to the degree set on my thermostat, then the pilot goes out and the furnace will not come back on. Could the thermostat be ...
0
votes
2answers
257 views

Furnace control board - interchangeable?

A few months ago, I had someone working on my outdoor a/c unit, and he accidentally shorted out the control board in the furnace (it's a Goodman gas furnace GKS91155DX). He replaced the board, and the ...
3
votes
4answers
740 views

Is it expensive to switch from an 80% to a 90% efficient furnace, to comply with the new mandate?

I'm told by some HVAC companies via mail flyers and websites (example) that it may be very expensive to retrofit new PVC pipes to update an 80% efficient furnace to a 90% one. Therefore, the logic ...
-3
votes
1answer
1k views

why won't my furnace turn off once it reaches the desired temperature

I have a moncrief furnace and replaced the thermostat but the furnace will not cut off once it reaches the desired temperature. What could be wrong?
4
votes
2answers
5k views

Should my thermostat's blue wire be going to W2?

I've recently moved into my first house and am looking to replace the existing basic thermostat in the home. Here is a picture of how I found it wired: Researching the wires, I've read that ...
0
votes
0answers
423 views

Can I manually run the blower on my Lennox G12Q3 furnace?

I have a Lennox G12Q3-120-6 model furnace. Does anyone know if there's a way to manually run just the blower without heat? There are no switches on the outside that I can see (other than the power ...
3
votes
1answer
303 views

Is it normal for air to be leaking from where the drain hose connects to the central A/C unit?

I'm trying to determine if I have a leak around my central AC unit. Basically when the unit is on, I feel cool air blowing outside the "furnace plenum" as I believe its called. If you look at this ...
1
vote
2answers
698 views

What could be wrong with my furnace?

The furnace started blowing cold air so I checked the furnace and the burners weren't lit only the pilot was on. This happened last year and repairman said that if it got too hot would trip a sensor ...
1
vote
2answers
1k views

Is there a filter-reminder thermostat that uses run-time instead of total time?

My HVAC filter is in my crawlspace and is a hassle to change. I don't want to change it more than needed. "Change it every month" is bogus advice because in some months (like May) we don't have to run ...
1
vote
1answer
265 views

Can I reduce the size of my hot water heater vent or direct the vent out the exterior (house has high efficiency furnace)?

The shower in my master bath is tiny. When I removed some dry wall to see if I could widen it, I found a large ~10" round vent running through the space(must be the furnace). Now that I have a high ...
3
votes
1answer
523 views

How well would a hydronic furnace work with a gas tankless water heater?

My current heating system (in Ontario) is an oil hot water tank in a closed loop with a hydronic forced-air furnace (Enerzone XAH 68). The water circulates through what is basically a heat exchanger ...