The furnace is part of an HVAC or central heating system used to generate heat. Typically this is done with gas, a heat pump, or an electric element. For hot water and radiator based heating, use the boiler tag.

learn more… | top users | synonyms

2
votes
0answers
239 views

Why won't my condenser turn on when I run my heat pump?

I have a York Affinity condenser. When I run my heat pump, I expect it to turn on somewhere in the cycle but it doesn't. It generally does this once a year. The usual fix is to cycle the power of the ...
2
votes
0answers
204 views

How do I know if my high limit and low limit are set correctly on my aquastat?

I have a boiler that is only providing heat for my forced hot water baseboard system (4 zones). I've always thought that the high limit on the aquastat was too low (the temperature on the boiler ...
1
vote
4answers
992 views

Are 5" thick filters for furnace/Central AC still available?

My furnace/AC was installed about three years ago. It uses 16" X 25" X 5" filters. The problem is when I try to find a replacement at my local home center: at Lowe's, Home Depot, (you name it), I ...
1
vote
1answer
464 views

Furnace Airflow

I have central air. When the furnace comes on, we can feel air coming out of the registers for a few minutes, then the airflow stops. If we turn it off for a few hours, we can turn it on again and get ...
5
votes
4answers
1k views

Why do I have two parallel gas pipes?

I've got a water heater and a hot water radiator furnace sitting next to each other, both on gas. The strange thing is that there are two parallel gas lines feeding each one of these which come from ...
4
votes
1answer
5k views

Can a washer and dryer be next to a water heater?

I have a GE gas dryer (DSXH47GGWW) that is currently next to an exterior basement wall. I'd like to move it to the opposite wall (shared with the crawl space) right next to the water heater next to ...
1
vote
2answers
669 views

furnace creating a ground?

our gas furnace has a junction box on the side of it for the 110 feed for the blower, the feed has no ground wire , if i put a meter on the hot wire and metal box i get 110/120 , without a ground wire ...
3
votes
2answers
158 views

What to do about furnace that's drawing gas odors into the room instead of heat?

I have a gas furnace. It was heating up the place fine and worked for years until the other day. All of a sudden it started drawing air that smelled like strong gas odors into the room rather than ...
1
vote
1answer
7k views

How do I test a furnace limit switch?

When my thermostat reaches the desired temperature, the furnace fan shuts off briefly, then cycles on and off a few times. Several internet posts pointed me to the limit switch, which seems to make ...
6
votes
1answer
696 views

Insulating ducts in a crawlspace

Consider a source duct from the furnace/AC. The ducts run in a vented crawlspace. The floors atop the crawlspace are a mix of hardwood and kitchen vinyl. The symptoms are: the longer run vents ...
5
votes
5answers
3k views

How do I prevent ice stalagmites from building up on the furnace exhaust?

I have a high efficiency furnace that exhausts via a pvc pipe out the side of the house, the trouble is the moisture from the exhaust forms an ice stalagmite in my driveway in the cold weather. Are ...
2
votes
2answers
3k views

How can I tell what kind of heating system I have?

Seems like a simple question, but I've had a very hard time finding a definitive answer to this. I went to the hardware store to buy a replacement for a faulty thermostat and when I arrived and ...
2
votes
1answer
2k views

How do I fix a condensate drain line that froze in my split electric system with heat pump?

I have a split electric system with a heat pump. It looks like my condensate drain line is frozen. I switched to supplemental heat which does not use the heat pump. Is this enough for now? Our ...
1
vote
3answers
9k views

Why is my Lennox g40uh series furnace not turning on?

I have a Lennox g40uh series furnace and it just stopped working today. I can reset the furnace and can see that on the control board both LEDs (green and red) are blinking together which indicates ...
1
vote
1answer
267 views

Massive reduction in air flow in furnance with air filters

After I put in a 3M filter into my furnace the air flow was massively reduced. So, does that mean the filter is wrong or something is wrong with my furnace.
5
votes
7answers
3k views

What should I do with old furnace filters?

I seem to be stock piling used furnace filters, are there any uses for these things once the furnace is done with them? It seems a shame to throw them out; given that I change them once a month, ...
8
votes
7answers
2k views

How can I audit my furnace?

I want to keep track of when my furnace is on, with an eye to reducing how much energy I use to heat my house. I could compare it with weather data (temperature, wind speed, precipitation). I could ...
3
votes
4answers
3k views

Why would a furnace overheat with a standard density filter?

Some time ago I found my furnace (gas, forced air, downdraft) was getting stuck on, blowing cold air. I could reset it, but it would happen again after a while. After calling out a service man, I ...
1
vote
2answers
201 views

Oil-fired furnace sight window repair

I have an 20+ year old oil burner and a tankless boiler/furnace. There is a small round (2-3" diameter) window above the burner that lets you see the flame, I assume as an aid to tuning the burner. ...
3
votes
3answers
16k views

Why is my furnace blowing cold air?

My HEIL 7000 natural gas furnace has stopped working what are the most likely causes, and how to verify faulty parts? Normal operation routine Thermostat sends "need heat" signal. Exhaust blower ...
2
votes
2answers
1k views

Is it OK to turn off power to a fuel furnace?

Is it OK to turn off the power to a fuel furnace to replace the thermostat? Will the furnace start back up once power is restored? This is on a new furnace with an old thermostat and fuse panel.
9
votes
4answers
13k views

Does lowering the blower speed of a forced-air furnace lower its efficiency?

My gas furnace has two options for the blower speed: MED, and MED-HI. It had been set on the higher speed, but that was too harsh, so I lowered it to the slower speed. Does that have any impact on the ...
3
votes
4answers
4k views

Can I connect an outdoor wood stove to my current HVAC system?

How to install a wood stove as an auxiliary heat source? (Main is electric furnace with forced air) I've read this question, it doesn't really answer what I need to know. What I would like to do is ...
3
votes
1answer
195 views

Where can I find resources on Gas Furnace manufacturers

We are going to replace a 30 year old residential gas furnace. We have estimates for furnaces from Rheem, Trane and Bryant. This is a rental, so we aren't going for the 95% with tax rebate but ...
3
votes
2answers
6k views

Why does the gas furnace blow cold air at the start of the heating cycle?

What does this problem sound like? There is a 25 year old gas furnace in the house we rent. (The guy that owns the place claims there is NO problem at all. He said the igniter is brand new and ...
2
votes
1answer
707 views

Why does my gravity vented wall Furnace keep turning off/

We have an Empire gravity vented wall furnace: That turns off. According to the instructions, this is because the vent safety switch. But when I open up the furnace, it appears to be vented just ...
3
votes
5answers
11k views

Why does my furnace need frequent power resets?

I have a NOMA Programmable thermostat attached to my furnace. The set point is usually around 21 degrees, and the room temperature is reading around 17 degrees. The furnace is not coming on. ...
2
votes
2answers
1k views

Does it matter where my furnace condensate pump gets power from?

The existing condensate pump for my furnace recently died. It was hard-wired directly into the electrical panel of the furnace but I was able to disconnect it. However, when looking for a new pump, ...
5
votes
3answers
1k views

Can I close the garage vent on my furnace?

My furnace duct system has a vent in the garage, right over the furnace. Is it necessary for the proper operation of the furnace to keep that open? I'd hate to waste the money heating up my garage, ...
4
votes
3answers
11k views

Why do our baseboard heating pipes make a loud banging noise after a new furnace was installed?

We had a new furnace installed about a month ago. The heating in our house is hot water baseboards. Ever since the new furnace was installed, when the heat comes on or turns off, there is a loud ...
0
votes
2answers
235 views

Furnace control board - interchangeable?

A few months ago, I had someone working on my outdoor a/c unit, and he accidentally shorted out the control board in the furnace (it's a Goodman gas furnace GKS91155DX). He replaced the board, and the ...
5
votes
1answer
178 views

Are discount furnaces safe to use?

More newbie questions ;-) The house we're looking to buy has an older furnace that "may be manufactured by the Permier/Consolidated furnace company" according to general inspections. We're in the ...
1
vote
2answers
175 views

How do I choose a furnace airfilter?

I have a furnace/air-conditioner that can support filters of various thicknesses: 1", 2", or 4". Filters are available in various MERV ratings. How should I decide which filter to use?
7
votes
6answers
9k views

Where should my furnace filter go in a Lennox G40UHX series furnace?

I have a Lennox G40UH(X) series furnace, which is installed in our attic (We have a single-story house on a slab). Because the furnace is installed in the attic, it is "laying down" on its side, and ...
2
votes
2answers
383 views

Are High End Furnace Filters worth the cost?

There are many levels of furnace filters. I can get cheap ones at walmart of a few bucks. Then there are ones that cost upwards of $30. I realize that if you have allergies or low immune systems, ...
4
votes
5answers
2k views

How often should the air filter in the furnace be changed?

Does the period of change of this air filter have an affect on the longevity of the heating and a/c system? What is a good rule of thumb to require replacement?
7
votes
2answers
941 views

Should I insulate steam pipes in the basement?

I have a steam-radiator heating system. The furnace is in the (unfinished) basement, and the steam-carrying steel pipes spread out across the basement ceiling before going up into the rest of the ...
9
votes
9answers
11k views

Do thermostat-controlled, auto-adjust HVAC vents exist?

The residential forced-air HVAC systems I have seen are controlled by a single thermostat in one room. One has to manually adjust the vents in order to adjust the temperature in other rooms. Is ...