The furnace is part of an HVAC or central heating system used to generate heat. Typically this is done with gas, a heat pump, or an electric element. For hot water and radiator based heating, use the boiler tag.

learn more… | top users | synonyms

3
votes
2answers
3k views

Should my thermostat's blue wire be going to W2?

I've recently moved into my first house and am looking to replace the existing basic thermostat in the home. Here is a picture of how I found it wired: Researching the wires, I've read that ...
2
votes
1answer
2k views

Why won't my Heil 7000 natural gas furnace ignite?

I have a Heil 7000 gas furnace Model: NUGK100DH12 Serial: L933050100 When we turn it on at the thermostat, the exhaust blower will kick on. We checked to be sure the gas is reaching the unit and ...
0
votes
2answers
21k views

How can I test whether my furnace issue is the limit switch or the thermostat?

I suspected this issue during the winter and confirmed it now in the summer. Regardless of the temp in my home, the blower motor runs non-stop. In the winter this must have been causing my home to got ...
0
votes
0answers
297 views

Can I manually run the blower on my Lennox G12Q3 furnace?

I have a Lennox G12Q3-120-6 model furnace. Does anyone know if there's a way to manually run just the blower without heat? There are no switches on the outside that I can see (other than the power ...
3
votes
1answer
261 views

Is it normal for air to be leaking from where the drain hose connects to the central A/C unit?

I'm trying to determine if I have a leak around my central AC unit. Basically when the unit is on, I feel cool air blowing outside the "furnace plenum" as I believe its called. If you look at this ...
2
votes
2answers
7k views

How do I wire an old furnace motor so I can use it as a garage exhaust fan?

Since last I posted, I moved WAY south (lil warm down here) and the house I moved into was a foreclosure so a few things needed done, namely the AC and furnace. When the guy did the job he said he ...
5
votes
3answers
421 views

Should the fill line be removed when decommissioning an old oil tank?

So, I have a contractor decommissioning my old 650-gallon oil tank. There is a 3" metal tube coming out of the ground from the tank that is what I believe to be the receptacle used to fill the tank ...
1
vote
2answers
799 views

Is there a filter-reminder thermostat that uses run-time instead of total time?

My HVAC filter is in my crawlspace and is a hassle to change. I don't want to change it more than needed. "Change it every month" is bogus advice because in some months (like May) we don't have to run ...
3
votes
1answer
761 views

How can I prevent water from entering through water heater/furnace exhaust vent?

I have an exhaust vent in my basement (Amerivent Type B) which takes the exhaust from my gas furnace and water heater goes out the basement wall, and up my chimney. A little bit water is coming in to ...
1
vote
1answer
206 views

Can I reduce the size of my hot water heater vent or direct the vent out the exterior (house has high efficiency furnace)?

The shower in my master bath is tiny. When I removed some dry wall to see if I could widen it, I found a large ~10" round vent running through the space(must be the furnace). Now that I have a high ...
2
votes
1answer
173 views

Is there a standard length on the PVC furnace pipes coming outside the exterior?

We have a high-efficiency furnace. Two pipes are coming outside the house as expected. However, right now, there is at least 2 feet or more of extra PVC on the exterior showing. Is there any ...
5
votes
3answers
4k views

Do I need a rain\snow cover on this furnace vent?

Just bought a house that had a new furnace installed this summer. Vent number 1 in the image is for the furnace (2 is the water heater and 3 is sump). As you can see in the image, 2 and 3 both would ...
3
votes
2answers
2k views

How do I troubleshoot an electric furnace?

I have a Coleman 3300-9051 electric furnace w/AC. The blower continually runs. Where do I find a repair manual and/or what could be the problem. How do I test it.
2
votes
1answer
298 views

Will I see any performance gains if I reconfigure my thermostat to control the second stage of my 2 stage furnace?

Our furnace is a two stage one that was installed last year (a Bryant 80t). When it was installed, it was installed with a thermostat for a one stage furnace. This appears to be because this model ...
3
votes
2answers
11k views

How can I determine why my furnace is not blowing enough heat?

During a cold spell last week when temperatures got down to -23f (-31C) my furnace started showing issues with blowing enough air and the air was not very warm. Last winter it did not have any issues ...
1
vote
1answer
246 views

Is it safe to put a gas furnace in the same room as an electric clothes dryer? [duplicate]

Possible Duplicate: Can an electric dryer be next to the gas furnace? We are currently remodeling our house. Is it safe to put a gas furnace in the same room with an electric clothes dryer? ...
4
votes
1answer
2k views

What would cause my furnace to only work with the filter removed?

My Carrier furnace works fine without the air filter in place on the return. With the filter in place it works for a while and then stops with a complaint about "limit, or flame rollout is open" ...
5
votes
2answers
359 views

Is there a way to find out how often your furnace is running?

With winter finally setting in, and being the first year in our new house I would like to put some sort of measurement on how often the furnace is working, before I get the bill. Are there any known ...
2
votes
2answers
19k views

Why does my pilot light keep going out?

My furnace pilot light keeps going out so I changed the thermalcoupler now the furnace will come on and heat up to the degree set on my thermostat, then the pilot goes out and the furnace will not ...
6
votes
2answers
690 views

Can an electric dryer be next to the gas furnace?

I intend to relocate my washing machine and electric dryer within the basement. The dryer will then be about 2 feet from the furnace. Is that OK?
3
votes
1answer
412 views

How well would a hydronic furnace work with a gas tankless water heater?

My current heating system (in Ontario) is an oil hot water tank in a closed loop with a hydronic forced-air furnace (Enerzone XAH 68). The water circulates through what is basically a heat exchanger ...
1
vote
1answer
537 views

Why won't the heat shut off in one zone?

we have a three zone baseboard hotwater furnace. a few months ago one zone would randomly stay on, we did change the thermostat we have not noticed the problem again, but in another zone we have the ...
1
vote
2answers
528 views

What could be wrong with my furnace?

The furnace started blowing cold air so I checked the furnace and the burners weren't lit only the pilot was on. This happened last year and repairman said that if it got too hot would trip a sensor ...
1
vote
0answers
206 views

How can I clean out the pressure switch port at the inducer housing on a Lennox G40UH furnace?

I have a Lennox G40UH(x) furnace, but the gas does not ignite, because water may have entered the system while raining, or the the pressure switch port at the inducer housing has just to be cleaned. ...
3
votes
2answers
7k views

Why won't my furnace turn off?

My furnace is running OK and heating the house. The problem is that I have the thermostat set to 66°F and it does not turn off when it reaches that temperature. I can turn it off manually at the ...
3
votes
2answers
2k views

What would cause a furnace to shut off prematurely?

I've got a Carrier Weathermaker 8000 furnace that shuts off about 90 seconds or so after ignition, started doing this recently. I get flashing code "33" which indicates: The code indicates: 33 ...
2
votes
2answers
4k views

Is my furnace operating normally?

I just moved into my house and I am wondering if this is normal for a furnace. So I have my furnace set to 68 degrees. The temperature on the thermostat says 66 degrees. The furnace is on, but does ...
1
vote
2answers
3k views

How do I build a firewall around my furnace/water heater?

I'm in the planning stage of finishing my basement. I'd like to section off the furnace and water heater, and am assuming that I should fireproof that section of the build. What's the best way to go ...
3
votes
2answers
1k views

Can I piggyback a thermostat with a C Wire hookup on a furnace?

I'm trying to install a new thermostat that needs a C wire hookup. There are currently 4 wires running from the thermostat to the furnace, none of them are a c wire. When I look at my furnace itself ...
2
votes
0answers
236 views

Why won't my condenser turn on when I run my heat pump?

I have a York Affinity condenser. When I run my heat pump, I expect it to turn on somewhere in the cycle but it doesn't. It generally does this once a year. The usual fix is to cycle the power of the ...
2
votes
0answers
201 views

How do I know if my high limit and low limit are set correctly on my aquastat?

I have a boiler that is only providing heat for my forced hot water baseboard system (4 zones). I've always thought that the high limit on the aquastat was too low (the temperature on the boiler ...
1
vote
4answers
815 views

Are 5" thick filters for furnace/Central AC still available?

My furnace/AC was installed about three years ago. It uses 16" X 25" X 5" filters. The problem is when I try to find a replacement at my local home center: at Lowe's, Home Depot, (you name it), I ...
1
vote
1answer
434 views

Furnace Airflow

I have central air. When the furnace comes on, we can feel air coming out of the registers for a few minutes, then the airflow stops. If we turn it off for a few hours, we can turn it on again and get ...
5
votes
4answers
1k views

Why do I have two parallel gas pipes?

I've got a water heater and a hot water radiator furnace sitting next to each other, both on gas. The strange thing is that there are two parallel gas lines feeding each one of these which come from ...
4
votes
1answer
4k views

Can a washer and dryer be next to a water heater?

I have a GE gas dryer (DSXH47GGWW) that is currently next to an exterior basement wall. I'd like to move it to the opposite wall (shared with the crawl space) right next to the water heater next to ...
1
vote
2answers
613 views

furnace creating a ground?

our gas furnace has a junction box on the side of it for the 110 feed for the blower, the feed has no ground wire , if i put a meter on the hot wire and metal box i get 110/120 , without a ground wire ...
3
votes
2answers
157 views

What to do about furnace that's drawing gas odors into the room instead of heat?

I have a gas furnace. It was heating up the place fine and worked for years until the other day. All of a sudden it started drawing air that smelled like strong gas odors into the room rather than ...
1
vote
1answer
7k views

How do I test a furnace limit switch?

When my thermostat reaches the desired temperature, the furnace fan shuts off briefly, then cycles on and off a few times. Several internet posts pointed me to the limit switch, which seems to make ...
6
votes
1answer
623 views

Insulating ducts in a crawlspace

Consider a source duct from the furnace/AC. The ducts run in a vented crawlspace. The floors atop the crawlspace are a mix of hardwood and kitchen vinyl. The symptoms are: the longer run vents ...
5
votes
5answers
3k views

How do I prevent ice stalagmites from building up on the furnace exhaust?

I have a high efficiency furnace that exhausts via a pvc pipe out the side of the house, the trouble is the moisture from the exhaust forms an ice stalagmite in my driveway in the cold weather. Are ...
2
votes
2answers
3k views

How can I tell what kind of heating system I have?

Seems like a simple question, but I've had a very hard time finding a definitive answer to this. I went to the hardware store to buy a replacement for a faulty thermostat and when I arrived and ...
2
votes
1answer
2k views

How do I fix a condensate drain line that froze in my split electric system with heat pump?

I have a split electric system with a heat pump. It looks like my condensate drain line is frozen. I switched to supplemental heat which does not use the heat pump. Is this enough for now? Our ...
1
vote
3answers
8k views

Why is my Lennox g40uh series furnace not turning on?

I have a Lennox g40uh series furnace and it just stopped working today. I can reset the furnace and can see that on the control board both LEDs (green and red) are blinking together which indicates ...
1
vote
1answer
260 views

Massive reduction in air flow in furnance with air filters

After I put in a 3M filter into my furnace the air flow was massively reduced. So, does that mean the filter is wrong or something is wrong with my furnace.
5
votes
7answers
3k views

What should I do with old furnace filters?

I seem to be stock piling used furnace filters, are there any uses for these things once the furnace is done with them? It seems a shame to throw them out; given that I change them once a month, ...
8
votes
7answers
2k views

How can I audit my furnace?

I want to keep track of when my furnace is on, with an eye to reducing how much energy I use to heat my house. I could compare it with weather data (temperature, wind speed, precipitation). I could ...
3
votes
4answers
3k views

Why would a furnace overheat with a standard density filter?

Some time ago I found my furnace (gas, forced air, downdraft) was getting stuck on, blowing cold air. I could reset it, but it would happen again after a while. After calling out a service man, I ...
1
vote
2answers
191 views

Oil-fired furnace sight window repair

I have an 20+ year old oil burner and a tankless boiler/furnace. There is a small round (2-3" diameter) window above the burner that lets you see the flame, I assume as an aid to tuning the burner. ...
3
votes
3answers
16k views

Why is my furnace blowing cold air?

My HEIL 7000 natural gas furnace has stopped working what are the most likely causes, and how to verify faulty parts? Normal operation routine Thermostat sends "need heat" signal. Exhaust blower ...
2
votes
2answers
1k views

Is it OK to turn off power to a fuel furnace?

Is it OK to turn off the power to a fuel furnace to replace the thermostat? Will the furnace start back up once power is restored? This is on a new furnace with an old thermostat and fuse panel.