2
votes
1answer
94 views

Can I properly install Roxul mineral wool batts in a mostly-drywalled stud bay by pushing them up from below?

Using my nifty thermal camera, I discovered that my furnace closet's combustion air duct (visible in this question) is getting really hot when the attic heats up, and then (being sheet metal) it ...
1
vote
1answer
112 views

What to do first in a house with poor thermal performance and high energy bills

I just moved into a house and am a little bit disappointed in its thermal performance so far. It's winter and cold outside, and the furnace heats the house up pretty quickly, but then the house gets ...
0
votes
1answer
114 views

Legal requirements regarding 100% asbestos duct work [closed]

I am renting a condo. After starting the heater, dusty air came out of the registers, so I called out a company to clean the ducts. They verified the ducts are 100% asbestos and cannot be cleaned. ...
6
votes
1answer
650 views

Insulating ducts in a crawlspace

Consider a source duct from the furnace/AC. The ducts run in a vented crawlspace. The floors atop the crawlspace are a mix of hardwood and kitchen vinyl. The symptoms are: the longer run vents ...
7
votes
2answers
910 views

Should I insulate steam pipes in the basement?

I have a steam-radiator heating system. The furnace is in the (unfinished) basement, and the steam-carrying steel pipes spread out across the basement ceiling before going up into the rest of the ...