For questions generally relating to the internal structural members of a home or other structure that form walls, ceilings and roofs, including studs, plates, headers, beams, and joists.

learn more… | top users | synonyms

4
votes
2answers
1k views

How can I build deck stairs flush with the end of the deck?

I have a deck design where I want stairs coming down perpendicular to the joist starting at the end of the joist. You can see the picture as a generic not to scale drawing of what I mean. I had ...
2
votes
2answers
2k views

How do I frame a room in my garage?

I intend to build a 15x9 room with 8' ceiling on one side of my garage to be used as a music/recording studio. I live in Phoenix, AZ area. I believe I can save money if I do all the framing and ...
0
votes
2answers
31 views

how to attach framing to this window in concrete?

I'm looking to finish my basement. I have several windows embedded in the concrete as shown in the picture below. I was planning to put framing up in front of the concrete and run some plywood all ...
3
votes
1answer
1k views

How do I install a non-load bearing wall on a carpeted concrete floor and finished drywall ceiling?

I am looking to close off a stairwell with a new drywall wall. The area it will be installed is already finished with carpet stretched over the concrete floor and a popcorn drywall ceiling. What are ...
2
votes
1answer
62 views

Do I leave this insulation up?

I am researching how to finish one room in my basement, and not sure what to do with what I think is vapor barrier or wall wrap insulation. Its only on two of the four walls which I assume is because ...
2
votes
0answers
21 views

Load considerations on framing members that are only attached to concrete?

I am building out a workshop space in my basement, and want to put up framing on the walls, as shown here: Specifically the left wall and the far wall, both of which have a lip. The foundation ...
1
vote
0answers
35 views

Sistering stingers to convert stairs from closed to open stinger

I have a set of existing closed stringer stairs with a full wall on the left and half wall on the right. I am looking to remove the full wall and modify both sides of the stairs to an open style. I ...
1
vote
0answers
37 views

How do I frame in the open front of a 12' high shop/garage building

My building is 32' wide, 26' deep by 12' high. I believe it was built as a carport for RV and other vehicles. The 3-walls use 2x4's 24"oc - the front opening has a good sturdy header that runs the ...
1
vote
0answers
188 views

frame soffit against foundation wall

I'm framing my basement and I have a duct that runs along the foundation wall. There's a little over a 1" gap between the duct and the wall, so I was planning on putting up XPS along the wall and then ...
0
votes
0answers
28 views

Can I use braces to fix squeaky floors?

I have quite a few squeaky floors in my 6-month-old house. The main floor plywood (glued and nailed) got rained on as it was being assembled. My basement is unfinished. I would like to do some repairs ...
0
votes
0answers
43 views

Installing some blocking in a load bearing wall

I'm doing some work on a bathroom and I'm planning on installing a floating vanity. I've seen suggestions to just use toggles + 1 stud and/or toggles altogether and cross your fingers, but just for ...
0
votes
0answers
30 views

How do I install a new interior partition wall?

I am adding a new interior partition wall to frame a closet. The wall is perpendicular to the cathedral ceiling rafters (angled at 40deg). Can I nail/screw the top plate of the partition to the ...
0
votes
0answers
16 views

what size and orientation of wood should I use?

I need to replace a rotted wood piece that lays on top of a masonry column and is under (and supports) a 2" X 10" joist that supports a porch with a roof on it. The existing wood support piece ...
0
votes
0answers
591 views

Replacing Load-Bearing 2x4 wall with beam and posts - Basement

I would like replace a 64" section of a load bearing wall with a beam and 2 support posts. The current wall is 2x4 pressure treated sill plate on top of poured concrete, 5 2x4 vertical supports and ...
0
votes
0answers
31 views

Costruction specs for cabin

Building a simple cabin 20 x 30 feet single story with gable roof. What size should the ceiling joists and roof rafters be? Roof rafters run across the 20' span.
0
votes
0answers
91 views

What is the minimum thickness of an insulated bathroom wall

I am trying to build a basement bathroom in the corner of the house. Where I am, basement insulation codes are R10/13. What is the minimum that I can do to frame and insulate a wall. The two ...
0
votes
0answers
36 views

Asbestos in close proximity of floor repair

I have a floor repair to make in a 1950's home that had the large in floor central heater installed that has long been removed. The owner wants the grate removed and flooring toothed back in, matching ...
0
votes
0answers
157 views

How much termite damage to load-bearing studs and sill plates warrants reinforcement or replacement?

I opened up an exterior wall and found a lot of termite damage. They did a number on two load-bearing studs and the sill plate they're resting on. To get a sense of the damage, I cleared out as much ...
0
votes
0answers
181 views

Add floor framing using joist hangers?

I have a single story ranch where a corner of the house I believe was a car port. The roof line and walls all are framed such that it was always under the roof and considered part of the house, ...
0
votes
0answers
183 views

Can turnbuckles hold a frame in tension?

I'm building a king-sized bunk bed using a loft/joist design. Basically, I've got (see below): slats nailed into joists joists joined to headers with blind tenons headers joined to posts with blind ...