0
votes
1answer
50 views

How do I frame this oddly spaced rough in

It's been a long time since I posted about this stupid rough in (dang kids), but I'm attempting to get back on it. The spacing for these pipes are driving me crazy. For a quick reference, the ...
1
vote
2answers
140 views

Can I drill a 3 1/2" hole through 5 joists?

I need to move a toilet to the other side of room approx. 6 ft I will have to drill a 3.5 in hole for the waste line in 5 floor joist on the second floor. Can I double them and still drill the 3.5 in ...
0
votes
1answer
111 views

What is this pipe - should I be worried?

We found it behind a wall, it is a bit more than 10 inches wide it has about an 3/4 inch of concrete between metal. It was jaggedly broke off on the bottom in the basement ceiling. It is also ...
5
votes
3answers
2k views

Is it OK to drill through a jack stud/full stud pair to cut a hole for water heater drain pipe?

I just had a new water heater installed in my garage. My city building / plumbing codes require that the water heater overflow drain be drained to the outside of the house. Situation: The heater ...
3
votes
3answers
383 views

What is the maximum number of load bearing studs in a row that can be notched?

I'm trying to install a new utility sink and washer hookup in my garage and am trying to plan how I'm going to run the copper supply lines. The most direct path I can think of is to notch probably 5 ...