1
vote
2answers
439 views

What header joist sizes do I need for a loft bed?

I've decided to design and build a king-sized loft bed for our bedroom. Basically, I've got an 80" x 89" frame, 54" off the floor, covered with slats instead of plywood (see image, below). I'm sure ...
3
votes
2answers
321 views

How can I build deck stairs flush with the end of the deck?

I have a deck design where I want stairs coming down perpendicular to the joist starting at the end of the joist. You can see the picture as a generic not to scale drawing of what I mean. I had ...
7
votes
3answers
918 views

How can I frame this multi-level deck?

I'm designing an addition onto my existing deck (the existing deck is not pictured below). The addition will be roughly 20' by 15', and I'm planning on making a portion of it a single step lower. ...
1
vote
1answer
662 views

How close to plumb to deck posts need to be?

I'm building a deck as the floor of a 30' yurt. Construction is 4" x 6" joists on 4" x 4" posts, on pre-cast concrete pier blocks, on tamped gravel footings. Posts are 20" - 30" long. Lumber is ...
6
votes
2answers
5k views

What are the best practices for a low deck built half on a concrete slab?

In our current place, we moved the main access door from going into the kitchen, to entering an old laundry room converted to a mud room. In order to do so, the front door was moved over about 4', ...
6
votes
3answers
2k views

Is toenailing necessary for a joist-to-ledger attachment?

Is it sufficient to rest joists on joist hangers or should you always toenail (drive screws/nails at an angle through the joist). And does the toenail have to drive into the ledger or just hold the ...
1
vote
1answer
215 views

Caulking for deck frame

To seal the seam between a doubled joist or beam, what type of caulking is best? The Home Depot Decks 123 book recommends Alex Plus (acrylic latex plus silicone) while a guy at Home Depot suggested ...