For questions regarding various types of floor coverings in general, including hardwood and laminate board, tile, carpet, and sheet flooring (linoleum/vinyl). For questions about the structure beneath this top layer, please see the "floor" tag.

learn more… | top users | synonyms

4
votes
1answer
333 views

Is this fungus? What should I do about it?

I've pulled up the masonite and tiled floor in my laundry and there's cleary water damage in the floorboards, I just pushed a chisel all the way through the worst part. The adjacent two floorboards ...
2
votes
1answer
206 views

Can I level floorboards with metal or rubber washers?

I am levelling some floorboards, with a view to painting them afterward and having a wooden floor. Previously there was a lot of scrap wood shims under there. Because these are only thin cheap wood ...
6
votes
3answers
11k views

Can I use leveling compound between plywood and cement backer board?

I'd like to install slate tiles over a pre-existing plywood floor. The plywood floor is 3/4" and sits on joists. There's a dip about 3/8" deep by 2 feet wide by 5 feet long. My plan was to fill it ...
3
votes
2answers
546 views

Is underlayment necessary in a room over a garage?

It is my understanding that underlayment beneath laminate flooring reduces sound between floors, i.e. for the room below. Is there a functional purpose beyond reducing noise in the room below? I'm ...
5
votes
1answer
3k views

What size expansion gap should I leave between my wall a hardwood floating floor?

How much space to leave between wall and hardwood floating floor? This is a unique floor. Each board is solid bamboo (never thought I'd say that) but they snap together the same way that an engineered ...
3
votes
1answer
266 views

How can I stop PVC decking from squeaking?

We recently installed a TimberTech deck using all-PVC flooring. They use a clip fastening system (non-nail and non-screw)that recommends the floor joists be spaced for 12 inches on center, if ...
3
votes
1answer
547 views

Should I install a wall before or after hardwood floor installation? [duplicate]

Possible Duplicate: Frame or floor planks first? I am building a small wall between two rooms. The existing flooring was carpet, which I have removed. I plan to install a floating floor ...
7
votes
1answer
4k views

How should I build a raised subfloor for my basement bathroom?

I've ripped out the bathroom in my basement that was finished by the previous homeowner. I'm now rebuilding, and curious to the most correct way to go about this. The whole basement was finished ...
3
votes
2answers
152 views

Identify part underneath chest

I am trying to find the name for the following part. This is underneath a chest that permits it to be moved effortlessly. I am trying to find this part to replace as they are pretty worn.
6
votes
1answer
4k views

How to stop outside rainwater from coming in under the wall and through the concrete floor of my garage conversion?

I have got a problem with an attached garage converted den in a 1978 built brick home. The heavy spring rains are redirected to the two year old perforated drain system on the side of the house ...
5
votes
1answer
481 views

Replacing a split tread on an old staircase

We have an old staircase (1900s) and after removing the carpet, before we get the new one fitted, we noticed that one of the corner steps has a lengthways split right down the middle: How easy ...
3
votes
1answer
1k views

What are the pros/cons of installing floors before doors?

I've heard contractors say to install doors first then flooring, and others suggest the opposite. I'm installing new 3/4" prefinished flooring and new doors/closets (prehung wood/ primed white). What ...
2
votes
1answer
168 views

How do I remove a stair tread under linoleum without damaging the linoleum?

I'm replacing some old 1970s railing in between my kitchen and family room (there's a step down into my family room.) I ripped that out and exposed what looks like a stair tread that was ripped down ...
5
votes
3answers
9k views

What hardwood flooring is recommended for high traffic areas?

I am having a house built and the developer wanted to charge me $10/sq ft for the cheapest $3/sq ft Bruce Oak, and more for anything better quality. There was no charge for Vinyl so, I had them put ...
5
votes
3answers
689 views

What preparation is required for tiling over poorly laid floor boards?

4" hardwood floor boards mounted on a poorly-designed frame made out of whatever wood the constructor had lying around it seems. There's a lot of bounce, some boards even drooping 1/2" when walking on ...
7
votes
1answer
921 views

Cutting a Custom Threshold: Best Tool for the Job?

I am in the process of creating a custom threshold to go from a tiled surface down to a carpeted surface. The tile is about an inch above the carpeted floor, so I decided to make a custom threshold in ...
4
votes
2answers
499 views

How to deal with a dishwasher height issue without tearing out cabinetry when installing flooring?

The house I purchased has nice new cabinetry and counter tops but cheap flooring. We plan to install 3/4" wood flooring (already purchased) but learned that installing the flooring would make it so ...
5
votes
4answers
1k views

How can I protect my hardwood floors from water damage?

I just bought a home with hardwood floors everywhere, including the bathrooms. While this is nice, I worry that they will be damaged by constant exposure to water. Is there anything I can do to ...
7
votes
3answers
8k views

Do I need to glue down linoleum flooring?

I am installing a new linoleum floor in a small bathroom (approx. 6' X 6'). This is a replacement for an old linoleum floor. The replacement will be a single piece. Talking with the local big box ...
5
votes
1answer
622 views

How to install linoleum floor under carpet?

I am replacing an old linoleum floor in my bathroom (replacing it with just another linoleum floor). It looks like the current linoleum floor was installed prior to the carpeting and the edge by the ...
4
votes
6answers
3k views

How can I fix a bathtub that was not set properly?

I think the floor was not prepped correctly. The tub creaks a lot and there is a great deal of vertical play when standing and moving around. The tub does appear to be level, so I don't think that's ...
3
votes
1answer
159 views

How do I finish my partially finished floor?

Ok here's the deal. I stained and poly'd the floor with 1 coat. I tried a floor buffer to sand after the first poly layer. Mistake.. the buffer was too strong. In a couple areas the buffer started ...
0
votes
2answers
1k views

Humidity Level for Bamboo Flooring

What are appropriate humidity levels for bamboo flooring post-installation? I've heard that most hardwoods are good between 35-50% humidity but have been unable to locate anything specific to bamboo.
1
vote
1answer
629 views

Will installing an OSB floor in the attic create moisture problems?

I installed some new OSB flooring in my attic. The area it covers is about 160 sq. ft. The total area of the attic is about 750 sq. ft. There is just blown fiberglass up there, and there is no vapor ...
3
votes
3answers
765 views

Plywood floor gets inexplicably wet, what could possibly be the cause? [closed]

House is on piers with insulation underneath. We had a plumber come look at it and he says he sees no pipes there, has no idea, cannot help. Every day there is about a 4 ftx4ft area of light water, ...
2
votes
2answers
622 views

What type of sub-floor is suitable for laminate flooring?

I'm planning to put laminate type of floating flooring on a floor. The floor has a sub-flooring of 3/4 inch planks and a sheathing of 1/4 inch plywood. I would like to remove the plywood because its ...
4
votes
1answer
217 views

What type of underlayment should be used when installing engineered floors?

I'm going to install floating engineered wood floor in a 3rd floor condo. It has plywood subfloor. My biggest concern is the noise of walking on the floor that people below me will suffer. My ...
10
votes
3answers
2k views

Should I install hardwood flooring under my kitchen cabinets?

I'm doing a total kitchen renovation with solid hardwood flooring. Do I go hardwood all the way under the cabinets to the wall or stop just past the toe kick and finish the rest with ply of the same ...
5
votes
2answers
968 views

How can I sand 1/2 inch hardwood floors?

I need to refinish the hardwood floors in my new house. I was going to rent one of those giant drum sanders to do the job, but everywhere I read says that unless the floor is 3/4 inch thick, you ...
5
votes
1answer
2k views

Filling holes in floor where heating ducts used to be?

I just bought a house which has been converted from forced air to hot water baseboard heating. Someone removed all of the ducts, but left the register covers in all of the floors on the first floor. ...
4
votes
1answer
1k views

Can I install new flooring on top of the existing hardwood floors?

I have some 30 y.o. hardwood floor (parquet type) that is overall in decent shape (firm, no squeaking, even, etc.). I'd like to install new hardwood floors, and my contractor says that new floor can ...
12
votes
1answer
903 views

Where should the floor transition from tile to carpet go?

I have 2 rooms planned, one will be tiled and the other will be carpeted with a door opening between them. Where should the tile stop and the carpet begin? In the figure below I have 3 different ...
7
votes
2answers
3k views

How do I use a floor nailer near the wall?

I have the floor nailed down in the entire room , except for the last seven courses. The pneumatic floor nailer can't get any closer than that without the mallet hitting the wall. Do I really have to ...
6
votes
1answer
502 views

How do I fit a joist in this small space?

This is a follow on question from here: Floor joists connection to eaves Since this question, I have been told I need 8" joists for my span and I have exposed my eaves area to see what space I've ...
15
votes
3answers
516 views

How can I remove a plank from the middle of the field?

My attic has tongue and groove planking down as the floor, and I need to do some work up there. I'd like to only remove a couple planks in the middle of the field, rather than pulling up half the ...
4
votes
1answer
549 views

Is slate tile suitable for exterior flooring in a colder climate?

My brother-in-law lives in Northern Alberta, Canada, and is thinking about putting slate tiling down on the front deck. However, he's getting conflicting opinions, one place is saying that it will ...
4
votes
1answer
381 views

Will my warped(cupped) oak flooring flatten out after it dries?

I have a refrigerator sitting on a solid oak floor with a plywood underlay/subfloor that had the ice maker line break and the water got under the flooring and it is cupped now about 4 feet square on ...
6
votes
2answers
2k views

What should I do about a hardwood floor that's sagging between the joists?

I recent bought an older (1890) house. On the original floors, the wood flooring is sagging between the joists--you can feel the height difference as you walk, up and down, up and down. It's firm, ...
8
votes
3answers
5k views

Is a radiant floor enough to heat the room?

I would like to know if an electric or hydronic radiant floor is enough to heat the room or if it's just to have a warm floor. And if yes, what is the efficiency (the time it take to warm the room, ...
3
votes
1answer
1k views

Do I need to put a second layer of damp proof membrane under my laminate flooring?

I'm attempting to lay some laminate flooring over a level floor made of screed. At the edges of the floor where it meets the wall I can see that under the screed it looks like the builder has already ...
5
votes
2answers
3k views

How do you build a “wet room” style bathroom floor?

20 years ago I lived in Sweden, and remember that the bathroom was designed with floors that could tolerate a lot of water. There was a tub & shower head but no shower curtain. The floor sloped to ...
6
votes
3answers
676 views

How to replace just a few boards in hardwood floor

I want to replace a few boards in our pre-finished bamboo hardwood floor. After i take the damaged boards out and put the new boards in, how do i get the last board in? How do i get the existing floor ...
2
votes
1answer
4k views

How should I add new joists and flooring to a loft space?

First off, basic floor plan of the loft: Hard lines are the walls on the first floor underneath, joists on the first floor landing run left to right so does that mean the central wall running front ...
1
vote
1answer
377 views

Do I need to do more prep work on this cement floor before putting in new tile?

In my basement i have a poured concrete floor, and we're re-doing the bathroom down there. It used to have Vinyl flooring, and we ripped it all up. The top vinyl part came up easily, but it left a bit ...
1
vote
1answer
273 views

What height of insulation should I use between joists in an MDF floor?

Background I am starting my first serious DIY project - converting our garage into a playroom for the kids. The garage floor is concrete. My plan is to run timber (Sawn Kiln Dried Timber (L)3000 x ...
1
vote
1answer
2k views

How far apart should timber joists be for an MDF floor?

Background I am starting my first serious DIY project - converting our garage into a playroom for the kids. The garage floor is concrete. My plan is to run timber (Sawn Kiln Dried Timber (L)3000 x ...
8
votes
4answers
2k views

Floor joists connection to eaves

Apologies if this is a duplicate. I'm attempting to floor my loft space. It currently has 47mm x 75mm ceiling joists, not enough for a floor. I am going to add something like 47mm x 200mm along ...
5
votes
2answers
507 views

Can I use a paint pad to apply floor varnish?

I went looking in the shop for a lambswool pad to apply floor lacquer, but they didn't have one, so I bought an Anza paint pad. Can I use this to coat a floor? Should I try to find a proper lambswool ...
12
votes
1answer
5k views

Which is better for deck flooring: 2x6 or 1x6 deck boards?

My current deck flooring is done with 2x6x10' boards, however they have degraded to the point now where they need to be replaced. I'm wondering if there are any specific pros or cons for using the ...
2
votes
2answers
281 views

Ideas for levelling partial flooring for kitchen furniture

My kitchen flooring consists of a click-type wood floor laid on top of an old vinyl layer, which again rests on concrete. After tearing down the previous owner's kitchen, I learned that the cabinets, ...