For questions generally relating to the structure and construction of floors in buildings, including designs, materials, support mechanisms, load-bearing calculations, etc. For questions specifically about the top-layer covering of a floor (tile, carpet, hardwood) see the "flooring" tag.

learn more… | top users | synonyms

4
votes
5answers
15k views

How can I locate floor joists?

I want to use some stop squeak screws that pull the subfloor tight to the joists, then break off beneath the surface of the floor. I am having a difficult time locating the joists: my stud finder ...
1
vote
1answer
26 views

Is this an asbestos floor?

My wife and are just bought an old house (1927) and we are concerned about a floor mat in one of the bedrooms. We have been told that it could have asbestos so we would really appreciate any feedback. ...
4
votes
2answers
1k views

What can I do about a house with internal concrete floor with no DPM?

My partner and I have just bought our first home.A 1950's bungalow which is need of refurbishment. So far it has thrown us a ton of surprises! The worst so far being the floor in one of the bedrooms. ...
3
votes
0answers
42 views

Can a slab under load be concrete jacked or otherwise supported without taking down the wall?

I have an issue with soil erosion below the front corner of my garage floor which has caused a crack to form and a piece of the slab (~4sq.ft) to sink. This in turn is affecting the portion of the ...
0
votes
1answer
40 views

How to transition between 2rooms when gap is wider than standard 2“ ” t molding strip laminate

How can I transition between 2 rooms if gap is wider than standard 2"t molding strip for laminate floor? Looked for wider strip but could not find one.
0
votes
1answer
40 views

Self-leveling alternatives to gypsum concrete (Gyp-Crete, Pyrofill, Securock) over OSB?

Replacement options for < 1.5 inch pour? Details: Bathroom remodel (new tub, tile wall/floor, toilet, vanity). Old tile floor came up with finger pressure, found that the gypsum concrete ...
0
votes
2answers
32 views

Can I lay peel and stick tiles over existing, old vinyl?

I am renting a place which has a very old and dirty vinyl flooring. Since I don't own that place, I don't want to spend a lot of money. The vinyl is in bith the kitchen and the entrance. I have found ...
3
votes
2answers
45 views

What Cement Based Product Is Used for Smoothly Finished Floors?

I recently replaced a floor drain in my basement around which I had dug out the concrete, gravel and clay soil. When I sealed it back in, I laid down a bed of gravel and sand, and then used a ...
1
vote
3answers
49 views

How do I begin to lay out floor tile in a small bathroom?

I have a small bathroom 58x52 Do I need to start in center of room Can I start on wall. Less cutting. How do I make sure tile is square on the floor in case wall is not plumb. Tile is 12x12. ...
0
votes
2answers
49 views

How to remove stains from tile?

I have a very weird stain on the bathroom floor of an apartment I just moved into. Is there an easy way to remove this stain? Also, what is the material of this tile? Is it like a concrete tile? ...
1
vote
0answers
30 views

Redoing shed base

I have a 12x16 shed, in which is built on a skid. The skid bottom is starting to rot. Is it possible to remove the floor inside the shed, dig out six holes, and put 4x4 posts cemented in, and attach ...
1
vote
2answers
68 views

What is causing the defined ridge and sunken surrounding floor on my second story floor?

House was built in '87. A defined warp (or ridge) has gradually appeared on my second story floor, in line with the load bearing wall. It appears that the surrounding floor has sunk while the load ...
0
votes
1answer
18 views

Tile floor installation on top of hardwood

Can I lay the backerboard for a tile floor on top of hardwood floor that is glued to 3/4 inch plywood subflooring?
0
votes
1answer
23 views

Can I use 1x4 boards for raised platform support?

I'm making small mini golf modules for use at home that will be 24"x24" each and just be placed on the floor next to each other. I wanted to make them as lightweight as I can for a reasonable cost. ...
1
vote
3answers
105 views

Do I need to replace water damage or just let it dry out?

I had a water leak under my kitchen sink. It happened pretty slowly over the course of perhaps 8 weeks. The bottom of the cupboard was saturated and about 6 " up the sides of the same cupboard unit. ...
5
votes
5answers
39k views

How can I transition between these floors?

I have recently fitted some new laminate flooring to my living room floor. This floor meets directly with the tiled floor of the kitchen. I'm looking to fit some sort of transition bar between the ...
4
votes
2answers
14k views

What kind of screws are used for plywood subflooring?

I have removed the old bathroom lino and cleaned the parts that adhered to the floor. I want to screw down the existing plywood subfloor because the nails are old (45yrs) and sparse. What kind of ...
0
votes
3answers
55 views

Painted concrete floor surface leveler alternatives

It seems there was a miscommunication and a contractor painted the concrete floor by mistake. I know that the proper way would be to remove the paint but I try to avoid that because overall project ...
5
votes
2answers
820 views

How can I repair a crumbling shed base?

I think I know the answer to this already but its worth a punt. I laid a 4mx3m shed floor (clearly badly), with about 10 cm of hardcore and 7.5cm of cement, that whilst in the middle appears fine, on ...
0
votes
0answers
14 views

Can I firm up a soft/squeaky floor by adding a plywood subfloor?

The hardwood floors in my old house sit directly on the joists. Can I make them firmer and quieter by screwing plywood into the boards from below? Do I need to account for expansion and contraction of ...
5
votes
4answers
9k views

Can I use drywall screws to stop floor squeaks?

I've got an old squeaky hardwood floor with access to from below. I can feel the hardwood boards moving under my feet when they squeak so I just plan to drill up through the subfloor into the ...
2
votes
2answers
98 views

Is there a better method for fixing UPVC floor trim to skirting, other than the adhesive tape provided?

Can anyone recommend a better method of fixing UPVC (e.g. Homelux) floor trims to skirting other than the adhesive tape provided? Can you mechanically fix them or is it just down to adhesives?
2
votes
3answers
26 views

How can I completely remove all traces of mastic from old concrete?

My original aim was to end up with a, possibly stained, clear-coated cement floor. After removing old floor tiles, I rented a floor grinder which took care of most of the old mastic. There were still ...
3
votes
3answers
78 views

First floor of house wobbles!

I've seen similar questions but I'm still stuck for an answer, so I hope someone can help... I've just built what is essentially a two-storey cube, 6m x 6m x 6m. It's a steel construction, a little ...
4
votes
4answers
8k views

Is it possible to refinish floors one room at a time?

I live in a small townhouse and would like to refinish the floors in the upstairs of my home. It is very difficult to do all of the rooms at once, but a friend suggested that unless I do this, the ...
0
votes
0answers
25 views

Basement Floor Installation - Do I need a subfloor or can I use underlayment for warm floor

Live in Vancouver, BC. I'm in the drywall phase of my basement project and we would like to put down vinyl flooring. My unfinished basement has been ultra dry for the last 8 years as it has great ...
6
votes
2answers
134 views

How to improve wooden joists without removing them

First floor bathroom in a Victorian terrace house. Floor joists run left to right with floorboards laid front to back. Joists are approx 10 foot long. At some point in the past, the previous owner ...
36
votes
8answers
79k views

Should I use a subfloor for a finished basement's floor?

We are refinishing our basement and have not yet decided what to do for the floors. Part of the basement will be tile, and we are all set. However, the rec room side is going to be carpet. The ...
1
vote
0answers
17 views

Sistering joists supported by concrete block on each side

I am going to start a kitchen remodel on a mid 40's home that is constructed with concrete block on all exterior and filled concrete block center wall up to the second floor. Floor joists span approx ...
1
vote
1answer
28 views

Adding a layer of concrete and tiles in the garage

I just wanted to get opinions on my plans to fix the somewhat sunken slab in our garage. We bought the house two years and (it's about 50 years old) and I have been monitoring the slab since day 1. ...
1
vote
1answer
22 views

What is the best way to protect a burnished concrete floor during construction?

I am doing a new build. The floor is burnished concrete done by High Trowel finish during concrete pour. I need to protect the floor afterwards. What is the best way to protect a burnished concrete ...
5
votes
6answers
11k views

Any ideas on how to keep a refrigerator from moving without wheel locks?

I've got a frig on a tile floor without any wheel locks, and it likes to slide forward every time I open a refrigerator door quickly. So far I have tried: toilet shims shoved under the wheels. ...
0
votes
2answers
75 views

Replacing a crawl space with concrete slab

I have a 1970 rental house that is prone to flooding the crawlspace approximately 1 week a year. To clarify, the whole section of land, yard, and streets are under a foot or more of water, due to ...
4
votes
2answers
206 views

Basement shower tiled floor not sealed by builder what now

So I have recently had a tenant move out and have found water damage around the basement shower floor. Looks like black mold so I started ripping it out. Now I am at the point where I have found ...
0
votes
1answer
30 views

Leveling floors and Installing windows

I have a sagging 1930s house and plan to level the floors using I-beams and jacks. I've read that the process is very slow and I'm also wanting to install windows. Will it cause any kind of problems ...
4
votes
5answers
16k views

How should I prepare a plywood subfloor for floating vinyl plank flooring?

The floor of my laundry room was three layers of hideous vinyl flooring of various vintages, a layer of 3/4" plywood underlayment (to match the height of the vinyl to surrounding hardwood flooring) ...
2
votes
1answer
86 views

Is This Wood Still Good? (Water Stained or Rotten)

I have an attachment on the side of my house, basically an enclosed porch but could also be a mudroom. One of the doors leads to a deck where the prior owners let the gutter downspout fall out of ...
0
votes
2answers
1k views

Possible To Put an Epoxy Coating on Particle Board?

Is is possible/recommended to put an epoxy such as Rust-Oleum Epoxy Garage Floor Coating on particle board? Any help would be appreciated! ...
0
votes
4answers
94 views

Best way to fix an uneven floor

We have an uneven floor that when we first moved in tried to repair but were unsuccessful. The root of the problem is a foundation slab which is uneven. We could not even it because there is an ...
2
votes
2answers
51 views

What power tool is the best and fastest to take up floor tile?

I need to pull up the floor tile in my kitchen. i've tried using a hammer and chisel and the tile pops up easily, but it's too slow. what power tool is the best and fastest to take up floor tile? is ...
1
vote
1answer
92 views

How to fix gaps between bamboo flooring planks

About 8 months ago I laid down a floating bamboo floor. The planks are solid carbonized strand bamboo. We allowed the planks to acclimate for over two weeks in the apartment and then laid down the ...
0
votes
1answer
33 views

Advise on proper placement of floor threshold

I have just widened my kitchen by two feet. As well I removed a small 45 degree wall and straightened out the doorway into the bedroom. As you can see in the Before Image, the threshold between the ...
0
votes
0answers
34 views

Are Slick Strips (UHMW tape) slippery enough to slide a car

I have a small sports car (~500kg/1100lbs) which takes up too much room in my garage and I want to build a system to slide the car to one one side to free up some space. I have heard that Slick ...
0
votes
2answers
109 views

What can I do about a low spot in my bathroom floor?

I have water standing on a specific area of my bathroom floor. The whole floor dries out except for this area. It has stagnant standing water. What can be causing this problem, and is there a solution ...
1
vote
1answer
39 views

what is the best low maintenance finish for a hardwood floor

Home made mesquite flooring. What is the best floor finish? Low traffic but subject to spills...this is for the man cave. Installing diy mesquite floor tiles, 4 - 6" width, random lengths. Aprox ...
0
votes
2answers
77 views

Sealing OSB subfloor from moisture? Patching small gouges?

What are some methods that can be used to seal an OSB subfloor from moisture? And patch small gouges (quarter sized)? Background: Small Bathroom remodel. Tile came up with finger pressure, ...
1
vote
1answer
35 views

Where to install underfloor heating under tile; thinset layer or concrete?

Putting in either a thermal wire/mesh (SunTouch) type underfloor heater or carbon film under tile. The subfloor is OSB. Going to pour 3/4" of LevelQuik Self-Leveling Concrete (replacing Gyp-Crete ...
0
votes
1answer
56 views

New Hardwood Floors Chipping

I just bought a newly built house in Maryland and have been living in it for about three months. Most of the house has hardwood flooring that for the most part looks really good. However, I've found ...
1
vote
2answers
41 views

How to get stains completely out of carpet?

So I have accumulated a disappointing amount of stains in my carpet (some of them even grease stains as I work with food) and I would like to know some sure fire ways to remove them with out ruining ...
1
vote
3answers
83 views

New Basement Floor, house not framed yet

We are building a new house with an exposed basement. I had the floors poured a week ago while still warm in December. We have not framed the house up yet, meaning no deck, walls, roof, or HEAT. My ...