The tag has no usage guidance.

learn more… | top users | synonyms

1
vote
2answers
56 views

Replacing a few boards in a hardwood floor: sanding and refinishing?

I'm replacing a half dozen board ends in a hardwood floor due to water and carpenter ant damage. Each is about 4-6" long. I have the old boards cut and removed, and in fact I can slide the new boards ...
1
vote
2answers
135 views

Can I put gypsum and paint finish on top of a concrete fast set repair mortar?

I have a finished concert pillar in my living room that I need to be patched and pained. The pillar has final gypsum and paint on top of concrete. Since the concrete is chipped off I need to use a ...
1
vote
0answers
59 views

How do I frame in the open front of a 12' high shop/garage building

My building is 32' wide, 26' deep by 12' high. I believe it was built as a carport for RV and other vehicles. The 3-walls use 2x4's 24"oc - the front opening has a good sturdy header that runs the ...
0
votes
0answers
63 views

Transition laminate with t-molding to tile

I need to transition where the laminate is higher than the tile. The laminate is 12mm so the tile is about 1/8" below the laminate. I have t-molding and metal track but there is a gap on tile side. ...
0
votes
0answers
53 views

What finish type is most often used for furniture drawer interiors?

I recently completed building a cabinet drawer to convert a free standing vanity into a dresser. I'm aware that drawer interiors are often left unfinished, but it's quite humid where I live and I ...