1
vote
0answers
68 views

How should I support a large gate in a vinyl fence?

I'm adding a new gate in my vinyl fence; a full width (6') gate. I'm concerned about support. The fence posts are decently moored, but there is still some wiggle. Would it be better to dig out and ...
5
votes
2answers
894 views

How do I drill into an existing galvanized fence post?

I have an existing metal fence post, set in concrete, in which I'd like to drill a new hole in that post. Normally, I would use a drill press to drill into a curved surface like this. Since the post ...
0
votes
2answers
478 views

How do I place a terminal fence post next to my house?

I'm about to begin setting all of my terminal posts for a chain link fence. However, upon digging the post hole for the terminal post that goes up against the house, I ran into a possible problem. ...
0
votes
1answer
346 views

What are the steps for pouring more cement around metal fence posts that are leaning?

When the wooden fence was built, they used metal posts but only filled the 2' hole with one bag of concrete. The posts are leaning at about a 25 degree angle. I want to dig out the hole again, then ...
1
vote
0answers
119 views

h-brace corner posts in rocky ground

We live in Austin and are putting in a livestock fence with stretched woven wire and barb wire top and bottom with t-posts between corner braces, plus 300' of sold privacy fence in the front needing ...
1
vote
1answer
233 views

Can a conical form for pouring shorter concrete footers be used for fence posts?

The frost line is 1.2m deep in my area. That seems like a lot of concrete to pour for a fence post. I'm wondering if a better way is to make a shorter footer following the suggestion that's used in ...
1
vote
1answer
3k views

Are there any advantages to using metal post spikes set in concrete when building a privacy fence?

My neighbor and I are considering alternatives to wood-in-concrete fence posts for a privacy fence that can have significant wind load in an area that gets up to -30 degree frosts in winter. The ...
1
vote
1answer
497 views

Do I have to remove the existing 6' fence posts to install an 8' metal fence?

I would like to replace a 6 foot fence with a 8 foot fence. The current fence has metal post. Will I have to dig up the current post or can I weld an extension to the existing post.
2
votes
5answers
13k views

How do I replace a wooden fence post that was set in concrete?

I need to replace a wooden fence post that was set into concrete. The post has snapped through rot at the base and the rot has set in so far that the post snapped about 2 inches beneath the surface. ...
2
votes
3answers
1k views

Should a post in a circular concrete form go through the bottom?

I am replacing a fence post that was in a circular 2-ft form. The old one had rotted where the concrete and post meet at the top - the next one will have the concrete above water level! But - I ...
4
votes
2answers
6k views

Fixing broken fence posts with Simpson Strong-Tie E-Z Mender and concrete

With a recent wind storm, most of backyard fence fell over in the adjoining school yard. The fence posts were set in dirt I believe and snapped; we didn't build the fence... In the past, I have used ...
2
votes
2answers
26k views

How to set metal fence posts?

I am getting ready to build a 6' tall 80' long wooden fence, but instead of 4x4 wooden posts I am going to use metal fence posts. The fence will have 1 walk through gate and a larger gate that can be ...
9
votes
3answers
5k views

Why did a gate post rot after just 6 years?

My friend put a 4 inch treated wood gate post in the ground and we filled the hole with concrete. A neighbor built a fence around the same time, using similar-looking posts. Six years later, the ...
10
votes
8answers
34k views

How do I remove a 4x4 fence post that is snapped off at ground level?

I'm trying to come up with a cheap and easy way to remove a broken-off fence post. It's a 4x4 lumber post that's snapped off flush to the ground, without any concrete around it.* I'd like to pull it ...
3
votes
1answer
164 views

Wooden pale fencing

I want to replace some fencing in the back garden. Ideally (if I can find it) I want to do this with Convex Pale Fencing. The fence is around 3 ft high x 6 ft wide, and I'll be using 3 panels ...
4
votes
2answers
2k views

Setting posts for a sturdy garden fence

So spring has arrived, and we have decided to build a 20' x 40' enclosed area in which to place a garden (we have many deer, rabbits and other garden veggie thieves in the area). The plan is to build ...