1
vote
1answer
89 views

How to replace bathroom supply line?

Question 1 - I am replacing my bathroom sink faucet. The supply line is 1/2" and the instructions for the new faucet states that a 1/4" supply line is needed. The current supply line is a grey solid ...
1
vote
1answer
270 views

How do I replace the water supply line that appears to be built in to the shutoff valve?

We're preparing to replace our bathroom faucet. We were able to easily disconnect the cold water supply line from the shutoff valve to the faucet by simply loosening the nuts holding it in place. ...
1
vote
1answer
31 views

How can I sand the underside of an enamel sink?

we need clearance to install stem valves because the faucet hole was drilled too close to the sink. We need about 1/2" extra clearance. The counter top guys drilled too close to the sink and did not ...
0
votes
0answers
64 views

How to remove a ValleyII water faucet cartridge?

I have a garden tub in my master bathroom. The faucets have been dripping for a while now so I have elected to do the fixing myself. The two sinks were easy enough. However this bathtub has me ...
0
votes
1answer
196 views

What type of faucet is this?

I cannot for the life of me figure out what kind of faucet this is. I need to replace the stems as they are leaking but without knowing the brand I am stumped!
2
votes
1answer
453 views

How can I loosen a tight sink handle?

I recently replaced the pivot rod in my bathroom sink drain. Over the course of the 3 days it took me to finally come to a resolution for it, the cold water handle has gotten tight. The hot water ...
2
votes
0answers
330 views

Why does my bath faucet drip for a few minutes after it's shut off?

I have a traditional two handled (one hot and one cold and they are separate) bath faucet. I recently had it reseated and the washers replaced, however, what I noticed was that immediately after shut ...
0
votes
2answers
382 views

How do I get even water pressure from a bathtub mixer faucet?

I just bought my house and noticed there is a problem in the bathroom tub faucet and that is: the valve starts from the cold toward hot and as it goes toward the hot the water pressure increases and ...
1
vote
0answers
165 views

How to remove flex hose from a single-control, tall faucet?

I have a faucet that is leaking down the flex hose. The one flex hose unscrewed easily. The second is turning but not coming out. I assume the nut has become separated from the crimp on the hose. ...
4
votes
1answer
683 views

How can I disassemble this old bathroom faucet to fix a leak, without damaging the decorative chrome piece?

Update 4: Once I followed Michael's suggestion I was able to remove the cartridge. Closest match was a Moen 1224, 131222. Inlet and outlet were very different, and rotation of valve was much greater ...
3
votes
1answer
432 views

How Can I re-attach my bathroom fixtures which are hanging loose from the wall?

Please see the two pictures below. I'm trying to re-attach the two faucets so that there is no gap between them and the wall. These faucets work perfectly fine its just that they aren't attached to ...
2
votes
2answers
895 views

How can I repair peeling finish on a faucet handle?

I've got a faucet in my bathroom that has a bit of the finish peeling off after what appears to be some kind of oxidation has built up underneath it. I'd like some suggestions as to how to repair this ...
6
votes
2answers
1k views

What could cause water hammer after changing a valve cartridge?

I fixed my delta 1400 series shower faucet the other day by replacing the valve cartridge with a non-delta brand. Everything went well, until I turned it on, now the shower pipe is hammering. The ...
9
votes
2answers
2k views

How can I remove stuck anti-vandal rings in tap head?

Most of the taps in my new house are fitted with so-called "anti-vandal" screws in the tap heads, as shown in the image. These screw into the tap head to tighten them onto the stem. I can't remove ...
2
votes
0answers
54 views

How can I fix my leaky bathtub faucet with minimal damage to the wall? [duplicate]

Possible Duplicate: How to fix a bathtub faucet that leaks only when the shower runs? Our bathtub faucet leaks a steady stream of water. Sometimes this will temporarily slow to a drip if I ...
8
votes
3answers
2k views

Should I create my own faucet aerator?

I installed some new "fancy" faucet, and am quite happy with it, except it lacks an aerator, and water easily splashes out of the sink. Obviously, this faucet is calling for an aerator. Unfortunately, ...
1
vote
2answers
607 views

Who makes this shower faucet handle (logo identification)?

Who makes this shower faucet handle? It's slightly broken, I'd like to get a replacement part, but I have no idea what company this is. Does anyone recognize this logo, or know how I might go ...
3
votes
1answer
2k views

Why does the pop-up on my sink's drain keep popping up?

After 3 years of good service, the plug in the pop-up waste in a bathroom basin won't stay down/closed for more than 30 seconds. It takes me 2 minutes to shave, and in that time the plug pops up 4 or ...
3
votes
1answer
219 views

How do I dismantle a faucet assembly to replace a leaky valve?

A bit embarrassed asking this, but... I'm trying to replace a leaking valve off my faucet assembly, but am unable to unscrew the faucet cap. Here is the faucet assembly - Taboret® widespread lavatory ...
6
votes
3answers
11k views

How can I fix a Moen faucet that is still leaking after replacing cartridge?

I had a leaky Moen faucet (Moen 4600) so I removed the old cartridge and replaced it with a new brass replacement cartridge (model 1200.) Since replacing the cartridge I now have a leak from the valve ...
2
votes
2answers
5k views

What is causing the minor leak in flex supply line under sink?

I had new shutoffs and new flex supply lines installed by a professional plumber a few months ago. Today, I installed a new faucet because mine was very old and starting to fail. I installed ...
1
vote
2answers
345 views

Bathroom faucet drip

I had a faucet drip in my bathroom sink. I determined it was the hot water (confirmed by the warm drip and it stopped when I shut off the hot under the sink). I assumed that the stem went (which ...
1
vote
2answers
310 views

Shutoff in shower very tight all of the sudden

I have a Symmons hot/cold shutoff in my shower. Normally, when I shut it off it goes a little beyond "12 o'clock" (more like 12:30/1:00). Anyways, I've noticed lately that it stops at exactly "12 ...
6
votes
2answers
3k views

How can I easily fix or replace the broken knob handle on bathtub faucet control?

DIY amateur here. The single handled plastic knob that controls the bathtub faucet recently fell off, along with a screw from its interior and a cap covering the screw. I wish I could post a picture, ...
3
votes
3answers
317 views

How can I straighten pipes behind a wall?

The original builders did a shoddy job when they installed the plumbing in the bathroom, causing the taps/faucets to come out of the tiled plasterboard wall at a slight angle - about 5 degrees - so ...
6
votes
1answer
198 views

Why does it take a long time for water to start draining from my tub faucet?

Sorry for the awkwardly worded title, I couldn't really describe the issue in one sentence. My shower has a handle that controls both pressure and temperature. To begin showering, I turn the handle, ...