3
votes
2answers
205 views

What type of insulation is needed for exterior walls on a brick house?

I have a government grant (2,440$) to insulate all of my exterior walls. The issue is, I cannot access them from the outside because I have a brick house. My first guess was that I will need to take ...
1
vote
2answers
105 views

How can I secure a metal frame to polyurethane foam?

I have used polyurethane foam to cover a 5 cm (2 inch) horizontal gap between a metal door and the ground. Polyurethane foam , as I know , needs to be covered with cement in order to withstand the ...
1
vote
1answer
127 views

How do I cover the attic rafter bays after installing baffles from the soffit before replacing the siding?

Should I be covering exposed fiberglass batts I stuffed into rafter bays below stapled in plastic baffles with an air barrier, such as with foil faced rigid foam board or house wrap, before replacing ...
4
votes
2answers
608 views

Should I add a vapor barrier when re-siding?

I am removing the siding on my house in Montana, which was built in 1964. From inside out I have sheetrock, 4" studs with R-11 paper backed fiberglass insulation and gypsum board sheathing. I want ...
7
votes
3answers
11k views

Is super insulating exterior walls with rigid foam board insulation possible?

2" rigid foam-board insulation can have an R-value of up to R-10, layering 4 boards would create a R-40 value, right? However that creates an 8" foam wall above the actual wall. What would be a ...
4
votes
2answers
409 views

My kitchen has no real walls. Is this going to be a problem?

I recently redid my kitchen, which included removing the back splash and putting in new tile, but when I went to remove the old tile, I found that the tile is only attached to drywall. Knowing this ...