Distribution and use of electricity throughout the home. Electrical standards vary greatly worldwide, so providing your location in your question or your profile helps ensure you get answers that are relevant to you.

learn more… | top users | synonyms

26
votes
9answers
8k views

Should old knob and tube wiring be replaced?

I have been doing some electrical work in my house and I noticed it has old knob and tube wiring that is still hot, should this be replaced as found or is it fine to just leave it? It seems really ...
10
votes
5answers
43k views

How do I install a GFCI receptacle with two hot wires and common neutral?

In my kitchen, I want to replace a regular 120V receptacle with a GFCI-protected receptacle. The instructions describe what to do with a regular 2-wire + ground feed, with and without daisy chaining ...
2
votes
2answers
8k views

Where does the ground wire go in a 3-prong dryer cord configuration?

We moved to a new place where the dryer connection is 3-prong instead of 4-prong. The dryer was originally 4-prong, so we bought a 3-prong cord and installed it. It works fine, except I am not ...
17
votes
4answers
4k views

Is it OK to borrow a ground wire from a different circuit?

I've got a circuit in the basement carrying a handful of outlets. This circuit has no ground wire. I want to add a couple of outlets and want them to be grounded. I may even want gfci outlets on ...
32
votes
9answers
57k views

How do I run wires for a wall-mount flatscreen TV?

Like a lot of you, we have several wall-mounted LCD HDTVs in the house. The TVs have two wires -- power and HDMI -- running down the wall to the power outlet and cable box. I've historically been too ...
9
votes
2answers
2k views

What are the pros and cons of different types of smart switches (that are on the US market) ?

When putting in a new switch for a light it is often less work to put in a smart switch than run the mains cables. However, how do you choose the type of smart switch to use? See also "What are ...
13
votes
4answers
5k views

Is there a way to simply splice in an additional length of 12/2 NM-B cable?

Is there a way without using junction boxes to simply splice in additional length of 12/2 NM-B cable? Can I use twist caps? I'm putting in a dog door and as it so happens, there is some 12/2 right in ...
5
votes
1answer
13k views

How do I wire a GFCI/Switch Combo?

I'm replacing an old GFCI/Switch combo. In the old one there are two wires coming into the line side, a hot wire and a neutral. On the load side there is one wire leading up to the lighting fixture. ...
10
votes
4answers
18k views

Is using 15 amp components on a 20 amp breaker against code?

I have noticed in a few different houses in Oklahoma that 20 amp breakers are used, but all of the outlets and switches only seem to be rated for 15 amps. This goes against everything I know to be ...
11
votes
2answers
23k views

How do you plan capacity for electrical circuits?

I'm finishing a section of my basement, which currently only has one bulb for bare light. In planning the electrical arrangement of things, how do I estimate the load of light fixtures or electrical ...
14
votes
3answers
26k views

How should I rewire a miswired 3-way switch?

I have a 3 way switch that was wired incorrectly when the switches were replaced with a different color switch. Is there a methodical way for me to identify which wires represent which piece of the ...
6
votes
2answers
11k views

What wire gauge do I need for a 100 Amp subpanel at the end of a 60' wire run?

I am adding an attached garage to my house. I'm going to be putting in a 100 Amp subpanel which is about 60 feet away and run through the basement joists. What gauge wire do you recommend for ...
19
votes
6answers
2k views

How best can I discover what is up with my electrical bill?

This might be subjective, I don't know. However, it's a serious problem for me. My electrical bill is outrageous. It's three times as large as my next-door neighbor, and four or five times the size of ...
10
votes
1answer
3k views

Can I add a standard receptacle on a GFCI circuit

So, I want to add a receptacle in the bathroom (I tend to run out of batteries on my phone while crapping at the end of the day). There's a GFCI outlet on the other side of the crapper wall that ...
10
votes
3answers
7k views

Do I really have to fasten interior-wall electrical wire to a stud to keep it from moving?

I am fresh out of cable staples and would rather not go all the way to Lowe's just to get a box. What are the implications of not fastening loose electrical wires to a stud? It's not like there's ...
9
votes
5answers
6k views

Do the breaker amp readings sum up to dictate my current panels total / possible amperage?

So I know practically nothing about houses having rented for many years, just bought a house and was told by my inspector the panel is only a 70 amp panel and will need to be upgraded before I go to ...
11
votes
4answers
3k views

I have a 3-pronged receptacle but no ground wire connected to it. Is this ok?

I removed the plates from outlets to paint walls and noticed that some of my electric boxes have ground wires connected to outlets while others do not have a green wire at all. Is this ok? I know ...
8
votes
1answer
1k views

Can Romex (NM-B) be run through conduit?

A few days ago I asked an electrician if I could run Romex through conduit - he gave me a funny look and said "No, Romex is not allowed in conduit." When I searched online, there seems to be a wide ...
5
votes
1answer
154 views

How can I replace 2-prong receptacles in a code compliant way?

I have some 2-prong non-grounding type receptacles, and I'd like to replace them with 3-prong grounding type receptacles. According to National Electrical Code, what are my options?
5
votes
0answers
263 views

What are the pros and cons of different types of smart switches on the UK market? [closed]

When putting in a new switch for a light, it is often less work to put in a smart switch than run the mains cables. However how do you choose the type of smart switch to use? See Also "What are ...
12
votes
7answers
2k views

Is there a wall outlet power meter that I can interface with from a computer?

I'm wondering if there is a wall outlet power meter that I can somehow interface with from a computer. I'm aware of all the google power meter products, but those are for an entire house. I'm trying ...
12
votes
4answers
38k views

Is it ok to have mixed grounds and neutrals on bars in a breaker box?

So to continue my line of electrical questioning (and perhaps narrow down my flickering light problem), I took a look through the two panels in this house. There is a 200amp main service in the ...
6
votes
3answers
2k views

Is this an acceptable way to add a light to a 3-way circuit?

I have three way switches at the top and bottom of my stairs. There is a light at the top of the stairs controlled by the switches and I wish to add a light at the bottom. A 14/2 runs first to the ...
5
votes
1answer
820 views

Is it safe to install a three pronged wire into a four pronged dryer?

I just moved into an old home that has a three pronged wall jack as shown below: I have a newer dryer that has a four pronged wire. Please see the back of the dryer, I've removed the four pronged ...
2
votes
1answer
3k views

Does the NEC allow electrical wiring to run next to a ventilation duct?

I am about to install a vent to the outside for the range hood exhaust in the kitchen. In the same bulkhead that will have this vent, there is some electrical wire (some 12/2 NM and some low voltage ...
0
votes
3answers
2k views

How can I wire an exhaust fan to turn on from multiple locations?

I just bought a Panasonic FV-20NLF1 inline bath exhaust fan that I planned to used to exhaust 2 different bathrooms. I want each bathroom light switch to control the fan, so when the lighting turns ...
13
votes
4answers
3k views

What should I use to secure/organize data cable runs?

I am running Cat-6 and Coax in new construction. I am looking for advice/best practices on how to organize and secure the cables during the runs. I will be running 2 Cat-6 and 1 Coax to a ...
14
votes
4answers
6k views

Are push in connectors up to code?

Just came across a neat product at the local hardware store, but I wonder if they are up to code and safe to use. They are a wire nut that allows you to simply push the wires in, instead of twisting ...
11
votes
4answers
8k views

Extension cord and power strip safety

I've heard that there are some safety and building code issues involved with using extension cords or power strips (surge protectors) for anything other than temporary use. What are the issues, and ...
9
votes
2answers
5k views

How should I address my bathroom's flickering lights and GFCI tripping mysteriously? (Schematic included.)

So I inherited a bit of a nightmare for wiring in my bathroom. I'll be calling in an electrician, but wanted to have an understanding of the problem first, as not to be ripped off, lead astray, etc.. ...
6
votes
9answers
15k views

How do I put a fluorescent light on a motion sensor?

I have a couple closets in my basement that I have outfitted with a fluorescent light attached to a motion sensor (this one). The idea was that when you open the closet door, the light comes on ...
11
votes
3answers
10k views

When to use holes instead of side terminals to wire an outlet

This question comes from Shirlock's comment on this GFCI wiring question. When and why should you use the holes on the back of an outlet rather than the side terminals? I always assumed the holes on ...
6
votes
1answer
453 views

What do I need to replace 4 light switches on the same circuit?

So we have a single light in our living room that can be turned on/off from four different switches at various entrances to the living room. We're currently replacing all the switches in our house as ...
6
votes
2answers
3k views

Is it unsafe if some three prong outlets don't properly test as grounded?

It's me again -- the pest ;-) On the general inspection report for the house we're looking at buying, there's a note about the house's electrical: Some three prong outlets did not test properly ...
5
votes
2answers
2k views

How do I wire my wall-mounted HD TV?

This image wall-mount setup should give a good idea of the current TV set up on the wall. I wanted to use a SmartStrip to power my TV and all the other devices (receiver, BluRay player, Wii, cable ...
8
votes
2answers
3k views

How do I install an electrical outlet on a live circuit?

In my dorm room closet, there is a junction box with a blank plate (no outlet). Inside there are three wirenuts (hot, neutral, ground). I know it is generally unsafe to do any work on a live ...
7
votes
2answers
2k views

How do I run a wire underground to an outdoor post lamp?

I live in Geauga county Ohio. My question is three part. First what type of wire do I need to run from the house underground to a post lamp 100 feet away? Second,does it need to be in conduit and ...
6
votes
3answers
1k views

Can I run a ground wire of a single circuit to the panel outside the house?

This is a follow-up to this question. I am adding (outlets) on to a 2-wire 12AWG (no ground) circuit and I want the new outlets grounded. Can I run a ground wire to the panel along the outside of ...
5
votes
2answers
3k views

Is it code-legal to have a circuit breaker box within a storage room?

I am currently in the process of planning a room remodel to convert an existing bedroom into a home office and storage room. One thing that makes this conversion a little bit tricky, is the existence ...
1
vote
1answer
104 views

What could cause two of my receptacles to stop working?

Problem: No power in two receptacles. Note: Both receptacles on same circuit. What I have done: Checked the 15 amps circuit breakers with a volt tester. Each breaker reads 125 volts. Bought a ...
22
votes
3answers
1k views

If DC adapters are so prevalent, why is AC used in construction by default?

I'm not sure if there's a better place to ask this or not. Why, at least here in America, is the standard electrical system set up for alternating current (AC) rather than direct current (DC)? I'm ...
11
votes
3answers
34k views

What is a GFI outlet used for, and where should I install them?

What purpose does a GFI serve? Where should they be used?
9
votes
8answers
6k views

Does a homeowner need a permit for electrical work in Massachusetts?

Does a homeowner need to obtain a permit from the town in order to do electrical work on his own house in Massachusetts? The unofficial answers I can find online (e.g., this forum and the websites of ...
6
votes
5answers
3k views

Why would my TV image turn black when electrical appliances turn on?

I have my computer connected to my TV via HDMI. Every time something electrical happens (fridge turns on, stove sparks, etc), the image on the TV goes black for a second and then comes back on. And ...
5
votes
3answers
4k views

Why is it safe to use 15 A receptacles on a 20 A circuit?

OK, the one answer I got was way off target, and another commenter couldn't figure out what I was asking, so I'm restating the question... Are 15A 3-prong grounded outlets actually rated to 20A, ...
5
votes
2answers
2k views

Why does using a dimmer with this ceiling fan and lights cause energy saving bulbs to flicker?

At a hotel I manage we purchased 34 ceiling fans with two integrated light sockets that operate on a dimmer all controlled by a remote control. Obviously using a dimmer with fluorescent bulbs won't ...
7
votes
2answers
543 views

How can I ground old 2-prong receptacles? (120V)

I have several old receptacles that are 2-prong. There is armored cable running from the breaker panel to each receptacle. What do I need to do in order to install and properly ground new 3-prong ...
6
votes
3answers
292 views

Why am I getting strange results when using a power meter to measure CFLs?

Over the years we have replaced just about every bulb in the house with a CFL. But here is the problem. Our electric bill is going up and not down. When I moved here 3 years ago we spent about ...
5
votes
2answers
903 views

How can I extend a wall outlet?

I have a interior brick wall, with wall outlet in it, I am covering the wall with 1/2" sheet rock. But I am ancoring 1x2's on the brick so I can hang the sheetrock. How would I extend the wall outlet ...
5
votes
1answer
3k views

How do I convert a light circuit with a single pole switch to use two 3-way switches?

I have a box in the hall which includes a 3-way switch (with another switch at the other end of the hall), a single pole switch to the garage lights and a single pole switch to the exterior lights on ...