The tag has no usage guidance.

learn more… | top users | synonyms

2
votes
2answers
2k views

Suitability of flexible metallic conduit serving as ground

EDIT: The attached photo is the most easily accessible example of the conduit used in the entire house. This shows the conduit attached to the garbage disposal with the previously mentioned 3/4 set ...
1
vote
3answers
9k views

How many lighting circuits are needed in the LED era…? (US - NEC)

This is in a two story, ~1000square foot per floor building. With the advent of affordable, decent (IMHO) LED fixtures (finally!) the entire lighting load for the structure looks to be 500W - 1000W at ...
3
votes
1answer
618 views

Does the circuit providing a light at the electrical panel have to be ONLY for that light?

Does the circuit providing a light at the electrical panel have to be ONLY for that light? I'm fairly sure there specifically has to be a light at the panel, as well as a circuit with an accessible ...
3
votes
1answer
982 views

Unused electrical duplex box, soon to be hidden behind a bookcase?

I'm getting ready to install bookcases for my home office (SouthWest USA). One wall floor to ceiling consisting of four units screwed together. In one place there is a duplex outlet right behind the ...
3
votes
2answers
136 views

why is a service neutral grounded but not the subpanel-neutral?

I know it's code (refer to NEC 250.24(A)5 and 250.32), but I don't understand why you can't use a bonding jumper to connect the ground bus and neutral bus in the subpanel? I've been told it's because ...
1
vote
1answer
118 views

How many “layers” of surge protection is considered useful?

I want to make my whole house surge protected, there are several solutions available You can install MOV based surge protection on the entire house in line entry point - first line of defense You ...
1
vote
1answer
419 views

GE Load Center Q's

I have an old GE meter socket load center (see picture). I have no idea what the model number is because the paper label on the inside of the lid is unreadable, and I have been unable to find any ...
0
votes
2answers
2k views

How can I connect a 120V compressor to a 3 phase WYE 208 electrical system?

I have 4 cables from a power supply which are 3 phase WYE 208 volt. so if I measure between neutral and hot I get 120V. The problem is that I need to hook up a compressor for 110V single phase (just ...