5
votes
5answers
532 views

Nice looking on-wall wiring

I need to run some standard AC wiring for wall lights etc. in the living room and some telephone/broadband wiring too. The problem is I can't do it in-wall for various reasons. The only option I am ...
2
votes
3answers
278 views

Soft crumbling walls, electrical mounting box

I wonder if anyone can help. I'm having my kitchen refurbished including the electrics but when my partner tried to insert and secure the mounting boxes into the wall the plaster around it has ...
3
votes
1answer
3k views

How can I mount a security camera on the outside of the house?

I'm tasked with mounting a security camera on the outside of the house and I'm not sure what would be the right way to do this. There are two basic problems: how to mount the thing and how to run the ...
4
votes
2answers
180 views

How can I recess an electrical outlet that protrudes from a glass mosaic tile wall?

The electrical outlet in my newly installed glass mosaic tile backsplash protrudes. How can I recess it without damaging the glass tile? It is a wall switch that runs to my disposal.
4
votes
3answers
229 views

What material to use to close a too wide wire tunnel?

During the cold days I noticed a little draft coming from the light switch next to my house door. Removing the switch revealed that the tunnel for the cables was widened to fit the cables for the ...
2
votes
1answer
475 views

What should I use as a base for my wall mounted PC case?

Here is an example of what I am trying to put together: What material could I use as a base onto which I can mount the motherboard, hard-disk and other wiring?
5
votes
2answers
1k views

How can I extend a wall outlet?

I have a interior brick wall, with wall outlet in it, I am covering the wall with 1/2" sheet rock. But I am ancoring 1x2's on the brick so I can hang the sheetrock. How would I extend the wall outlet ...
2
votes
2answers
1k views

What are the current and voltage limits when determining low vs. high voltage wiring?

I'm trying to figure out what is considered a power line( for outlets) and data communication line. What are the qualifying factors here. I know outlets have 120V AC at 60Hz and data lines have ...
11
votes
3answers
11k views

What's the minimum depth that an electrical box can recess into a finished wall? Does it have to be flush?

Do electrical boxes have to be flush to the finished surface? Can they recess any depth into the wall by as much as 1/8" or 1/4"? Edit: I appreciate everyone offering alternative solutions to ...
1
vote
1answer
116 views

Is there a remote switch I can use to replace a switch located in a wall being removed?

I am removing two walls that contain light switches for the dining, and kitchen ceiling lights. Is there a wireless switch I can use for control, without fishing wires into the existing walls?
9
votes
1answer
660 views

How do I get to the wall cavity above a double floor joist from below?

I am running some new romex for a couple of electrical outlets. One of the outlets is on one side of a wall in one bedroom and the other outlet is on the other side of the wall in another bedroom. ...
6
votes
3answers
1k views

Is there an easy way to make a square hole in plaster/brick to put an electrical outlet box in?

I am about to fix a few new sockets, I can run the cables down the back of some built in cupboards, but would rather not use surface mounted sockets. I do not have a SDS drill, just a standard ...
3
votes
4answers
8k views

How do I install a receptacle box in lath/plaster wall?

I have a room with ungrounded electrical receptacles and I need to install a grounded outlet. The walls are lath and plaster. What I want to do is install a new receptacle box for the outlet. Is there ...
32
votes
9answers
61k views

How do I run wires for a wall-mount flatscreen TV?

Like a lot of you, we have several wall-mounted LCD HDTVs in the house. The TVs have two wires -- power and HDMI -- running down the wall to the power outlet and cable box. I've historically been too ...