0
votes
1answer
908 views

Replacing a standard 2-gang light switch with an electric dimmer switch

I'm looking for a some assistance in fitting a new electric dimmer light switch. I'm in the UK if that makes a difference. I am trying to replace my existing two-gang light switch with a LightWaveRF ...
2
votes
2answers
147 views

Do z-wave products suffer any limitations in the UK because of radio limits?

I'm looking into home automation and I think I'm settling on z-wave as my choice. however, I was slightly worried by this comment on wikipedia; In Europe, the 868 MHz band has a 1% duty cycle ...
-1
votes
2answers
214 views

Any way to monitor load on a power outlet and receive notifications of usage? [closed]

My sump pump float sometimes sticks. This is an issue because the pump can easily run dry and burn out, especially if we are away for an extended period of time. Ideally I'm looking for something ...
0
votes
1answer
386 views

How to replace a single light switch with an electric dimmer switch

This is a very similar question to one I asked yesterday, which Ryan Walkowski kindly helped out with. This time, I'm looking for a some assistance in fitting a a single electric dimmer unit. I am ...
9
votes
1answer
1k views

How to replace a standard 2-gang light switch with an electric dimmer switch

I'm looking for a some assistance in fitting a new electric dimmer light switch. I'm in the UK if that makes a difference. I am trying to replace my existing two-gang light switch with a LightWaveRF ...
3
votes
1answer
1k views

What debuzzing coil should I use to get rid of lamp hum?

I have two lamps which use these big 300W bulbs that I am dimming with Insteon LampLink modules. They buzz quite a bit, and I previously asked a question about reducing the buzz which led me to ...
2
votes
3answers
2k views

How can I replace a two way switch with a ZW4001 Z Wave enabled light switch?

I am trying to replace a single switch connected to a single light bulb with a Z Wave enabled switch, model ZW4001Z; a link to the manual for the switch is at the bottom. There is a wiring diagram on ...
2
votes
4answers
2k views

How can I control a circuit breaker remotely?

We have a house in the country that largely sits abandoned. We have a large family, and we like to go visit for the weekends. When we leave the house, we turn off the circuit breakers to prevent high ...
3
votes
2answers
313 views

Alternatives to signal on power for home automation systems (such as UBP) - low-voltage circuits, wireless…?

I am kind of averse to using signal on power for home automation systems such as UBP as this seems to be shared with the outside world (I read somewhere that the signal can travel as far as the ...
5
votes
1answer
716 views

What's the best/official way to draw a building's electrical system?

We are installing home automation systems, and we have serious problems with electricians. Short: they are stupid and lazy. So, we have to do something. There're some stories: We have a spreadsheet ...
5
votes
0answers
263 views

What are the pros and cons of different types of smart switches on the UK market? [closed]

When putting in a new switch for a light, it is often less work to put in a smart switch than run the mains cables. However how do you choose the type of smart switch to use? See Also "What are ...
9
votes
2answers
2k views

What are the pros and cons of different types of smart switches (that are on the US market) ?

When putting in a new switch for a light it is often less work to put in a smart switch than run the mains cables. However, how do you choose the type of smart switch to use? See also "What are ...