1
vote
1answer
61 views

Are licensed electricians required to perform code-compliant repairs?

A California licensed electrician replaced a circuit breaker for a friend. He removed the living room AFCI breaker and replaced it with a used non-AFCI breaker. When I heard this I was upset enough ...
1
vote
1answer
23 views

Code compliance for outdoor 20 amp receptacle?

Looking to add a 20 amp receptacle on the outside of my house, on a separate circuit. I don't know what NEC codes to look out for. It will be on the outside wall of the house, if that helps. The code ...
0
votes
0answers
40 views

What codes are invovled in running an overhead subpanel feeder to a detached garage?

This subfeeder will be going to a detached garage about 30ft away, and powering a 100amp subpanel. I'm not sure what codes are involved in this feat. I'd like to know the codes involved for ...
1
vote
2answers
28 views

Testing and proper breakers for a multi wire branch circit?

How do you determine if an outlet is part of a unidentified multi-wire branch circuit? Also, does code say MWBCs need to be on double throw circuit breakers and is it permissible to link CBs with that ...
6
votes
1answer
104 views

Can a private electromechanical meter be placed between the utility's meter and the main breaker?

I want to run an experiment which compares the readouts of the newer electronic smart meters against older electromechanical meters. Is there anything in the NFPA 70 or any other law or code which ...
3
votes
2answers
336 views

Can I drive a ground rod near a gas meter?

I am redoing the electrical in my 1940s house. The house has no grounding electrodes but the meter and panel are grounded to my water pipe outside in the front of the house. (This actually looks like ...
0
votes
0answers
26 views

Can two ground rods be bonded via a PVC conduit above ground?

According to my understanding, if a supplementary ground rod is installed, it must be bonded to the existing rod via a buried 6 AWG cable (NFPA 70). However, because virtually every side of my house ...
0
votes
2answers
82 views

Is it okay to drill a ground rod through pavement?

All the sides of my house are paved, and I need to drive a new ground rod for an antenna. Would it be against code (NEC) to drill a hole in the concrete to pound in a ground rod? Bonus question: How ...
0
votes
3answers
200 views

2-wire switch loop controlling 2 outlets - replacing with 3-wire to fix?

I am in nearly this exact situation: Can I use a switch loop to power a ceiling fan? We are trying to install a fan, but instead of having a single duplex outlet on the same wall as the switch, we ...
3
votes
2answers
88 views

What's involved in an electrical inspection to obtain a Certificate of Occupancy?

In an 80 year old house with no original certificate of occupancy (C of O). I have to obtain a C of O, which requires an electrical inspection. What should the inspection involve?
3
votes
1answer
132 views

Is it allowed to connect 14 awg ground wire to 12 awg ground

I have a 20 amp circuit and a 15 amp circuit coming together in a 2-gang box. I have to connect all the ground wires together. Is it ok that I am connecting 14 gauge wire to 12 gauge wire for the ...
1
vote
2answers
145 views

When there are multiple circuits in a junction box do all grounds get connected

If I have a junction box where there are splices from several circuits, do I connect all ground wires from all circuits together in one bundle or do I do that for each circuit within the junction box? ...
3
votes
1answer
126 views

Is Schedule 80 PVC Conduit Suitable for Short Directional Boring?

I'm running some electrical wire around where I'm building my house. There are two places that I'd rather not dig through: A driveway and a creek. The creek is the most important, because the state ...
3
votes
1answer
256 views

Unused electrical duplex box, soon to be hidden behind a bookcase?

I'm getting ready to install bookcases for my home office (SouthWest USA). One wall floor to ceiling consisting of four units screwed together. In one place there is a duplex outlet right behind the ...
0
votes
1answer
86 views

Add new outlet in pantry to one of the two existing 20 amp small appliance branch circuits

I am doing some remodeling in my kitchen. I currently have the required two 20-amp small appliance branch circuits powering the kitchen counter outlets. I have a small pantry/closet directly off the ...
2
votes
1answer
494 views

Is it against code to create a romex to thhn junction inside a conduit body?

I'm installing a 60A subpanel in my detached garage. I'll be running 2GA conductors, to leave the possibility of upgrading to 100A service in the future open. The Breaker I'll be using on the main ...
1
vote
3answers
182 views

Is a plywood backer required for all breaker panels?

I read online that a plywood backer may or may not be required behind a breaker panel, and that it must be painted black. What are the rules for this? And why must it be painted black? I'm in MI, USA ...
1
vote
1answer
292 views

How to determine what type and gauge of wire should used for underground wiring to a detached subpanel?

I Will be installing a subpanel in a detached garage. The subpanel will be 60 amp. The garage is about 30' from the main-panel in-house, and I will of course get an exact length before selecting the ...
1
vote
3answers
143 views

How do I determine the fill rating of a conduit?

I Will be installing a subpanel in a detached garage. The subpanel will be 60 amp. The garage is about 30' from the main-panel in-house, and I will of course get an exact length before selecting the ...
0
votes
1answer
215 views

How to properly ground a subpanel in detached building?

I Will be installing a subpanel in a detached garage. The subpanel will be 60 amp. The garage is about 30' from the main-panel in-house, and I will of course get an exact length before selecting the ...
0
votes
1answer
108 views

How do I wire a door bell?

Can anyone make an educated guess on how to wire so the door bell rings? The flat used to have door phone entry system, but it doesn't work anymore. So it is used as normal bell. In flat we had a ...
2
votes
0answers
39 views

Is it ok by code to enclose a residentail breaker box in a finished basement as long as there is an access door and what are the requirements? [duplicate]

I am finishing a basement and want to enclose the 200a service box and wiring with a framed cabinet of some sort. Is there any requirements for clearances and what you can enclose it with? I am in ...
4
votes
1answer
478 views

Can I install a receptacle outlet below a window?

I need to add a receptacle outlet to an existing line. I will run the line from an existing receptacle outlet. Is it okay to locate the new outlet below an existing window?
4
votes
3answers
199 views

Is it okay to protect NM Cable in an unfinished basement with ENT?

Adding a 20 amp subcircuit (120V) to furnace room to turn it into a workshop. Initially it will have one duplex and 2 fourplex receptacles, the fourplex receptacles will be on cement walls, the duplex ...
4
votes
1answer
315 views

What should I do about old cables that have been damaged?

I was replacing some drywall and noticed the wiring underneath has a couple of surface tears. House is from the sixties, but has been rewired with new Romex, except this circuit. Wire seems to be old ...
3
votes
2answers
227 views

Is it acceptable to splice a circuit in two opposite directions for outdoor recepts/lighting?

Per the 2011 NEC, is it acceptable to... Splice a circuit (using a junction box indoors) as long as I leave it exposed, use the correct wire connectors, and have it covered? Use this run one side ...
-2
votes
1answer
116 views

Residential electrical installation, at what voltage is a licensed contractor required?

I'm trying to figure out regulatory requirements for residential electrical installations. Specifically, when is a licensed electrician required by code to perform an installation? Obviously you don't ...
2
votes
1answer
117 views

How to reroute a circuit that goes through a return air plenum

Old house, need to replace a wire where the insulation has been stripped off from when the original installer pulled it through a joist. Normally I'd just follow the original path of the old wire, ...
1
vote
1answer
131 views

Do smoke detectors have to be hard wired in New Jersey?

I'm rebuilding after a fire, and I need to know if the new smoke/co detectors need to be hard wired.
5
votes
1answer
285 views

How can I replace 2-prong receptacles in a code compliant way?

I have some 2-prong non-grounding type receptacles, and I'd like to replace them with 3-prong grounding type receptacles. According to National Electrical Code, what are my options?
1
vote
2answers
118 views

What's the proper procedure for replacing ungrounded circuits?

I have a house that has several ungrounded circuits that uses the older 2 wire romex (pvc insulation, black woven jacket). I'd love to have AFCI protected circuits for the bedrooms, and grounded ...
6
votes
1answer
1k views

How many cables are you allowed to run through a single hole in a wooden floor joist?

How many cables are you allowed to run through a single hole in a wooden floor joist? For example, could I run five 12-2 cables through a 1-1/8" hole? I know they physically fit, but is there a code ...
5
votes
2answers
2k views

Can I wire a refrigerator and dishwasher on the same circuit?

Can I wire a refrigerator and dishwasher on the same 20 amp circuit?
3
votes
2answers
934 views

Can I terminate a ground wire to the neutral bus if the ground bus is full?

I have a Crouse-Hinds main load center. The ground bus is at the top left of panel and the neutral bus is at the bottom right of the panel. I want to add a 15 amp circuit for two outlets in my ...
1
vote
2answers
367 views

Can I mix 12 gauge and 14 gauge wire in the same 15 amp circuit?

I have 12/3 wire from a switch to 3 light fixtures; can I feed the switch with 14/2 wire from a 15 amp breaker?
2
votes
1answer
161 views

What are the code requirements for installing a ceiling fan alongside a fire sprinkler?

I have a fire sprinkler in my bedroom ceiling which is right in the middle. I want to install a ceiling fan. What are code requirements to follow?
2
votes
3answers
308 views

Any problem with installing two identical circuit breakers in series?

Suppose I want to reduce risk of a circuit breaker malfunctioning and failing to disconnect a shorted circuit. What if I install two identical breakers sequentially (one after another) so that if one ...
3
votes
2answers
194 views

Does NEC allow for recessed lighting to be placed in a vertical wall?

I am about to start running electrical in my bathroom remodel and I am considering options for lighting. I have a wall on one side that has 5.75" of space (this was for recessed shelving in an ...
0
votes
2answers
127 views

Are electrical subpanels safe in the bedroom?

If not, how do you correct it, or can it be moved without making too much work?
1
vote
2answers
171 views

Is it code to have electrical wire going no where?

I have a wall open in the center of my house. I am going to run some 14-2 up it and and to about 5 feet from my panel, leaving plenty of extra wire to hook up in a few months. On the other end I am ...
5
votes
2answers
1k views

How do you secure electrical outlets in a concrete block wall?

I have an old home that has several outlets in the exterior wall. These outlets are not secured to the block, they just dangle in the opening and are only secure (or appear to be firmly in place) due ...
1
vote
0answers
84 views

Can I attach a metal box for a vanity light to a wood cross?

I am redoing a new bathroom. I have a metal electrical box that I want to replace (because it is an odd size from the 50s). The current one is simply screwed to a wood cross (2x4) running ...
0
votes
2answers
147 views

According to NEC 2008 can you use non-metallic boxes in framing that transports environment air?

In the Home Owner's electrical test, the term "environmental air" is used. What does this term mean, and where is it defined? and can you use a non-metallic box? Also when reading the question do ...
2
votes
2answers
290 views

What do I need to know before taking the home owner's electrical test?

Inspector came over and checked out my basement today. He suggested that I take the `local home owner's electrical test to sign off on that part of the permit. They give you the NEC 2008 handbook, ...
1
vote
1answer
499 views

Can I connect the generator neutral to my mains neutral permanently?

I have a 3 phase 15KW generator with four wires. I want to use it as a standby generator for my house. My house uses 1 phase 220 volts on two wires (no ground as the house is quite old). I have a 3 ...
2
votes
2answers
250 views

What type of wiring should bedroom overhead lighting have?

On the phone with a friend in Cali this morning. He said that some municipalities are requiring /4 (12-3 or 14-3 romex) wiring for all new construction or rewiring for overhead lighting components. ...
2
votes
3answers
216 views

Is it safe/compliant for one circuit to supply grounded wall outlets in both a kitchen and a living room?

On one side of my wall (in kitchen, not the refrigerator or stove plug) is a three prong grounded outlet. Would it work without overloading a circuit to put a new outlet on the other side of the wall ...
2
votes
1answer
297 views

Can I run an unrelated electrical cable under a bathtub?

I have an older house with a mixture of grounded and ungrounded outlets. Every room has at least one grounded outlet in it, except one. I've long wanted to run a new cable to that room and at least ...
4
votes
2answers
6k views

How do I properly ground my subpanel that only has one neutral/ground bar?

I am adding a sub panel in an unattached building. My sub panel has the connection for the 2 hot wires coming from the source panel (a 40 amp double breaker) In addition it has one neutral/ground bar ...
1
vote
2answers
887 views

Can I install lights on a 20 amp circuit that has receptacles already wired?

I have never been able to ask the following question and get a simple straight answer and would like to know why there is a controversy, and what the answer really is. The question: Can a 20 amp 12 ...