0
votes
0answers
28 views

Why is my bathroom vent fan tripping the GFCI when being shut off?

I have a GFCI tripping when a vent fan is being shut off. I saw in KeithS's answer to a similar question that the blades rotating after shut off causes an imbalance, tripping the GFCI. In my case the ...
3
votes
3answers
263 views

What should I do if my vacuum trips my AFCI device?

I have a vacuum that trips the AFCI device of the circuit that services my bedroom. The vacuum has some age on it, and there is some wear on the motor's commutator. This wear causes electrical ...
2
votes
1answer
148 views

Can I plug a 15A snow thrower into a 15A receptacle?

I'm planning to buy a snow thrower with a 15A motor in it. I have an outside receptacle that's rated for 15A and so is the breaker in the electrical panel. I'm wondering if this will work without ...
1
vote
4answers
4k views

How do I re-wire a ceiling-fan to reverse its direction?

One of the ceiling fans at home was spinning in the opposite direction (clock-wise) and so was sucking up the air rather than blowing it. I live in a hot climate so we always have the fans spinning in ...
2
votes
1answer
1k views

How does a multi-tap motor speed control work?

I have a Home Depot, undocumented, no-name ceiling fan and I've messed up the speed control connections, and I'm trying to understand how the circuit works. I found a circuit on the internet which ...
2
votes
0answers
150 views

Why would my microwave continually rotate when connected to a voltage stabilizer which is also used for a refrigerator?

When I connected my microwave oven to a voltage stabilizer which is being used for refrigerator,the microwave oven motor starts working without any functions provided.The motor keeps on rotating at ...
7
votes
2answers
418 views

Why were only some of my tools damaged when connected to a 240V receptacle?

I live in the US and recently bought a home. There are several electrical outlets in my garage. I have recently had two tools that have burned up and gone to an early grave. It turns out that the ...
0
votes
1answer
481 views

How can I connect a 120V compressor to a 3 phase WYE 208 electrical system?

I have 4 cables from a power supply which are 3 phase WYE 208 volt. so if I measure between neutral and hot I get 120V. The problem is that I need to hook up a compressor for 110V single phase (just ...
8
votes
1answer
922 views

How do I wire this motor with 240V?

I have 240 plug with a switch dedicated for Air compressor. I have compressor that supposedly can be wired for 240V 2 pictures show sticker and current wiring. How do I update wiring to make it 240V? ...
8
votes
4answers
10k views

Should I put a dimmer switch on a ceiling fan?

I have a ceiling fan on our bedroom's vaulted ceiling. Since we don't want 7' pull-cords, the speed is stuck at full-tilt, which is no good. The fan has separate switches on the wall for lights and ...
0
votes
1answer
3k views

What could cause a ceiling fan to lose rotation speed?

I have two identical ceiling fans in my house that were installed around 4 years ago. One no longer rotates as fast as it used to at top speed. At a guess I would say it has lost 30 or 40% of its ...
3
votes
3answers
13k views

How much less power does a three-phase A\C unit use as apposed to a 220v unit?

I'm planning to install a 5 ton central AC. I'm deciding between a condensing unit that runs on 220V and a costlier unit that runs on 207Y three-phase. My understanding is that three-phase motors use ...
2
votes
2answers
316 views

How much current should I expect this motor to draw when it's running steadily?

This fan lists its "Max. Amperage" as 3.2. I assume the motor draws that much when it's first turning on, then settles down to some lower current. How much current should I expect it to draw when ...
2
votes
1answer
606 views

What would cause a ceiling fan to stop while the light still works?

Installed a new fan/light today. Wiring appeared to be identical to old fan we removed. green ground to green ground on mounting bracket. white to white. black and blue to black. Turned it ...
0
votes
2answers
2k views

salvaging DC motors from home appliances [closed]

In what home appliances I can find a 40V (or so) DC motor?