For questions about drywall (aka plasterboard) installation, repair & finishing.

learn more… | top users | synonyms (1)

2
votes
1answer
67 views

Can I use a toggle bolt if there's no space behind the drywall?

While trying to install a 14lb metal shelf to the wall, I had learned from a previous installation mishap to upgrade from plastic anchors to something stronger. I picked up a few toggle bots (3/16" w ...
0
votes
1answer
31 views

Need help with choosing primer

What kind of primer should I use on my kitchen walls that I scraped clean of old texture? I put a number of gouges in the dry wall. Is that bad?
0
votes
1answer
523 views

Can I use a paint+primer to fix a bad paint job?

We didn't prime walls the first time after putting up drywall and we painted it. We put two coats on it already and can still see drywall patches. Can we use paint with primer to fix this using same ...
14
votes
10answers
6k views

Is fiberglass mesh tape a good choice for drywall?

I'm going to be doing some drywalling shortly and was wondering what experiences other have had with the self adhesive fiberglass mesh tape. Is it a good choice or am I going to regret using it?
4
votes
5answers
3k views

How can I hang heavy objects on a wall, without leaving any marks?

Command Hooks don't hold very much weight wise and I would like to mount heavy objects - e.g. a whiteboard ... any ideas? (yes this is drywall - I cannot leave any marks in it ). context: college ...
0
votes
0answers
18 views

Hanging a Ceiling Fan from a drywall ceiling with aluminum profiles

The ceiling in my bedroom is made of 1/2" drywall suspended with 2" aluminum profiles from a concrete ceiling. I want to hang a ceiling fan in this room, but I'm wondering how to support the weight of ...
0
votes
1answer
35 views

Draft from under baseboard - pull back carpet or remove baseboard to caulk?

Using an infrared thermometer/camera, I found what seems to be a draft coming from beneath a baseboard in the corner of a carpeted room. I understand that caulking can stop drafts from under ...
3
votes
1answer
788 views

How do I install a non-load bearing wall on a carpeted concrete floor and finished drywall ceiling?

I am looking to close off a stairwell with a new drywall wall. The area it will be installed is already finished with carpet stretched over the concrete floor and a popcorn drywall ceiling. What are ...
3
votes
3answers
2k views

How do I repair a drywall ceiling when there is blown in insulation above?

I was finishing the space above a garage. The space was buried in blown in cellulose insulation and we framed in some walls, laid a subfloor, and finished the room. During framing two different ...
1
vote
2answers
103 views

Can I insulate my exterior walls myself using blow-in?

I live in western Washington, where we see plenty of rain, but only a month or two of freezing temperatures each year. My exterior walls are drywall with horizontal wood siding. I feel crazy as I ...
2
votes
1answer
84 views

What insulation should I use in my attached garage?

I'm currently tearing out the sheetrock and everything in my attached garage to do general repairs to other things. I quickly found that there wasn't a single bit of insulation (which explains a lot ...
1
vote
3answers
107 views

Mold in my bathroom is spraying bleach and painting over with Kilz enough?

I live in an apartment and I noticed what I believe to be mold growing on my bathroom ceiling. I have a daughter with asthma and I now know it's the cause of her constant coughing since we moved here. ...
2
votes
1answer
78 views

Are there differences to drywall joint compound and plaster?

The drywall store near me told me the they don't have (or use) joint compound for drywall seams, they use something called "slow plaster" (free translation) for over the drywall tape with the same or ...
2
votes
0answers
39 views

Can you use a hopper gun to spray finishing plaster?

I'm intrigued by spray plastering. It seems that most people use machines like this, costing thousands, to spray finish plaster: ...
4
votes
5answers
16k views

How should I remove the texture from the ceiling *without* tearing it out?

We want to get rid of the texture on our ceiling. It's a very ugly stipple effect. However, there's a foot and a half of insulation over this ceiling. Knocking it down to install new drywall is ...
0
votes
1answer
184 views

How do I prevent interior doors from sticking in the winter?

We have several interior doors that only stick or won't completely close in the winter. We also get cracks in the drywall mud above the doors so I think something else is going on besides just ...
2
votes
1answer
54 views

Better to have single butt joint or 2 tapered joints when hanging drywall?

I am in the process of hanging drywall for my basement. Due to the length of the walls there are a couple situations where I could either hang the sheets to have a single butt joint.. or to have 2 ...
0
votes
1answer
32 views

What's the best way to fix skirting board without nails / screws?

I need to put some skirting board up which will be fixed to some skimmed, dot-and-dabbed plasterboard. I need to fix it without nails / screws however, as it's in a basement/cellar conversion, and ...
2
votes
1answer
2k views

How do I prepare a ceiling for restomping?

I had to cut access panels in the ceiling of a 7' x 11' room to make several plumbing repairs. The ceiling has the slapbrush/stomp texture: I have patched the drywall and I plan on restomping the ...
1
vote
1answer
185 views

How do sound-dampening drywall clips affect the ability to hang objects on the wall?

I'm evaluating options for sound-proofing drywall, and am considering sound-dampening clips such as Genie Clips. In this approach the drywall isn't directly mounted to the wall studs. How would I ...
3
votes
1answer
2k views

Can furring strips be installed diretly to a cinderblock wall not in a basement?

I've tried finding a definitive answer but it's far more common for folks to have block walls in basements that need to be furred out, so the information deals primarily with that and I believe this ...
2
votes
3answers
847 views

Do I install my green board before I install my shower pan?

I have had to take my old corner unit shower out and about to install a bigger shower. What I'm going back with is Cultured Marble. This will be the pan and the walls. I was told I needed to ...
2
votes
2answers
253 views

What should I know before having bathroom fixtures installed?

I recently removed the old towel rack in the bathroom (which was badly installed because it left huge holes inside and the rack was hanging and I had to literally tug it out, which took me ages!) and ...
1
vote
0answers
78 views

Mounting a 32" LED TV to Dry Wall without Stud Support

We're looking into mounting our current TV on the wall in the bedroom, however we've hit a minor snag, it appears there's no stud in the area where the TV would be mounted. I've searched the wall ...
1
vote
2answers
118 views

Tape or corner bead where Hardi meets Drywall?

I need to finish the outside corner above the shower alcove. The shower ceiling is hardibacker and the wall outside the shower is drywall. Where these two meet, what is the proper way to finish it so ...
1
vote
3answers
69 views

Can I change the fire rating of 1/2 inch drywall?

I currently have 1/2 drywall on my wall sepating the garage, which is now an accesory apartment. The house was built in 1975. Code says it must be 5/8. It is not possible to take everthing down to ...
1
vote
1answer
31 views

Tile Shower Surround—Cement Backerboard Location?

I'm in the process of remodeling an old bathroom and I'm coming up on the point where I'll need to drywall/install backer-board. I've been reading up on this and I just want to make sure I have my ...
0
votes
1answer
39 views

Is their a Radiator Safe expanding Foam?

So I live in an apartment building and I have a Bug problem, go figure. I have had my place spray repeatedly to try and get rid of them, but with in a few weeks there always back, worst than when the ...
2
votes
2answers
45 views

What should I use to cover the walls of an alcove for a water heater?

My water heater is located in an alcove on the back corner of the house. Today I found water line leaking from the heater, replaced and it is good now. I have always just assumed the walls and ...
0
votes
2answers
37 views

Any way to mount this diffuser without screws?

I needed to unmount a drywall ceiling diffuser to do a small fix. The diffuser is a "traditional" stainless still box mounted using two screws driven straight into the sheetrock. Unfortunately the ...
2
votes
2answers
49 views

How to fix plaster on ceiling due to screw coming loose?

A builder did a bad job when painting and the ceiling vent came loose, upon inspecting it seems that they broke the ceiling plaster by unscrewing it, tried to hide it by screwing it in another place ...
12
votes
5answers
3k views

How do I consistently drive drywall screws to the correct depth?

Is there a special technique or tool for consistently placing drywall screws correctly? I'm using a standard Dewalt DWD115K (with no auto-stop mechanism) so I'm usually paranoid of going too deep ...
0
votes
1answer
64 views

How can I fix a cabinet to plasterboard with brick wall behind?

I aim to fit a (fairly heavy) kitchen wall cabinet to a plasterboard wall. Behind the plasterboard there does not appear to be any studs. So I guess the plasterboard (what I would call drywall - ...
2
votes
2answers
9k views

Could this cracked drywall be caused by a shifting house?

We are in southern Illinois and last Sunday my wife noticed a crack above the kitchen cabinets. We started looking around and have found cracks all over the house in different areas that were not ...
0
votes
0answers
32 views

how to fix the dry wall inside of the outer wall ? and what is brown glossy paper in between drywall and insulation? ?

I just found a mold in the bottom corner of my house inside of outer wall. I cleaned mold with bleach and cut the corner. is there any specific way to fix the dry wall of outer wall. Also plz what ...
2
votes
1answer
39 views

How to skim (plaster) a tight corner under stairs?

I need to skim an area of wall below some stairs. There's a tight corner where the boards below the upstairs stairs meet a length of trim: Annoyingly, this is pretty much at eye level for anyone ...
1
vote
2answers
38 views

What is the best way to replace a large section of 3/4" plastered drywall?

I had some water damage at the base of a wall. I ended up tearing out the bottom half of the wall, about 55" high. I now need to close it back up. The wall that I tore out is about 3/4" thick. It ...
1
vote
1answer
66 views

How can I avoid hitting wood when cutting through drywall?

I was working on concealing some TV wires, and when I cut through the drywall I noticed this wood behind. I did not have this problem in the bedroom.
1
vote
0answers
35 views

What's the strongest way to tie drywall into Rock-Lath/plaster with an embedded mesh?

I'm replacing our utility door that goes out to garage, and want to know the best way to tie the new drywall in with the old Rock-Lath/plaster. Usually I just put a backer board in, but with this ...
1
vote
1answer
43 views

What is causing this water on the drywall and how concerned should I be?

I noticed some light lines on the dry wall of one my internally facing walls. Here is a picture of the water lines: It's tough to tell from the picture (make sure to view in high resolution), but ...
2
votes
3answers
115 views

How do I hang drywall where the wood is uneven?

I need to hang some drywall; my ceiling has a couple spots of uneven-ness. There's a few spots that are about 1/4" out of whack and another spot where joists+hanger are a little less than 1/2" down. ...
1
vote
0answers
39 views

How can I insulate an already converted attic space?

A couple of years ago we had our attic converted to a spare bedroom, It became obvious after the first winter that there was a problem, after inspection it was confirmed that there is no insulation ...
1
vote
1answer
52 views

How can I remove a stone fireplace that is attached to drywall?

I wish to remove a fireplace and the mantle above it. Can I just pry it off portions at a time or is there a better way?
1
vote
0answers
60 views

What could I be getting stuck on when drilling into a stud?

I was trying to drill a hole for bolts for a TV mount, using a 7/32 bit. About 1" in, the drill wouldn't go any further. It as was in the middle of where my stud finder indicated a stud (but it was ...
2
votes
3answers
258 views

Is it possible to move a vent from the floor to the wall without ducts?

my contractor needs to move the floor vent to the new closet wall. His plan is to simply partially close off the floor vent, then build the closet wall over the remaining portion, allowing the air to ...
6
votes
2answers
20k views

What dangers are there with disturbed asbestos drywall?

We had a repipe job done on our home 5 years ago. I was stupid and did not research the company before they destroyed drywall throughout the house. After the pipes were replaced they informed me ...
1
vote
1answer
66 views

Remove a screw with a broken head

Used an impact driver to screw into a (pre-drilled) stud. The head of the cheap screw broke off, just about flush with the drywall. How do I remove this screw?
8
votes
4answers
4k views

Can I hang a TV with one stud and drywall anchors?

I have read several questions on here regarding this topic but my situation is slightly unique. I have a TV mount that is about 20" wide. The studs in my wall are 24" apart. I am mounting a 55" tv. ...
3
votes
3answers
3k views

How can I find places to nail/screw into walls of ICF (insulated concrete form) home?

The home I bought has exterior walls made of ICF (insulated concrete form). I don't know the brand or type, I just know that somehow the builders attached the drywall to the styrofoam/concrete. I'm ...
8
votes
3answers
7k views

How do I prepare patched drywall to be painted over?

I am in the process of painting my room. I have some big patches on the drywall. I am yet to begin painting that wall. Before i start i wanted to take advice. Is there anything i need to do with those ...