For questions about drywall (aka plasterboard) installation, repair & finishing.

learn more… | top users | synonyms (1)

3
votes
1answer
968 views

How do I solve my problems with a paper faced outside corner bead coming loose?

I'm doing drywall work around where the outside corner of my tray ceiling vertical meets the regular ceiling. I bought paper-faced metal corner beads and spray adhesive thinking it would be quicker ...
5
votes
2answers
11k views

LCD TV mounting bracket does not “fit” the studs location in the drywall - how can I overcome that?

I would like to mount my 32" LCD TV to a wall using a swivelling bracket that I bought. The wall it needs to go to is plasterboard so I need to mount it on the studs. However, I've got a problem - the ...
5
votes
3answers
3k views

Using fire rated drywall/sheetrock in a partially finished basement

Background: We have a full basement and I have recently completed about half of it as a hang out spot for my teenage boys and their friends. The other side I use as a workshop and a place to store ...
6
votes
1answer
786 views

Paper joint tape VS. Mesh joint tape

What are the pros and cons of each type of drywall joint tape? Are there situations where one should always be used over the other?
5
votes
2answers
3k views

Drywall - final joint compound coat

While remodeling an older house (where nothing is quite straight) we used fiber glass mesh joint tape and 3 coats of joint compound. The first coat was applied with a 4 inch knife, the second with an ...
4
votes
2answers
2k views

What's the best material to patch gaps between moulding and the wall?

I am installing new moulding (aka baseboards, woodwork, etc). A few of the walls sort of dip inward, so a gap is left in between the moulding and drywall. What's a good material for patching this ...
5
votes
1answer
488 views

How can I refinish an interior chimney pipe to make it appear rounded?

Right now my interior chimney pipe is hidden behind a wall and I want to remove that wall and expose the pipe, but the pipe itself is not so pretty. My fireplace is a wood fireplace with a double ...
17
votes
11answers
3k views

What should we look for when buying a fixer-upper house?

My fiance and I are considering buying a fixer-upper house rather than an apartment when we get married. Obviously things like location, neighbors etc. are important, but; what should we be looking ...
5
votes
1answer
626 views

How to close a doorway between two apartments?

I own two adjacent condo units and I opened a small doorway (24"x80") on the common wall for convenience. Now I've sold one of the units and need to close the doorway. I recall the wall was simply ...
6
votes
3answers
2k views

Can I hang a 60 lbs TV on 1 inch drywall?

Can I use drywall screws with plastic contraption 3/8" diameter to put a TV on the drywall? What is the load limit for 1 inch drywall and how many screws and how close apart they can be put to carry ...
5
votes
1answer
955 views

Why is my (white) painted plaster going brown on the borders of the underlying plasterboard?

We've recently had our spare bedroom ceiling plastered, and there was a loosish bit of plasterboard that was secured by the plasterer before skimming the entire ceiling. After painting it I observed ...
2
votes
2answers
472 views

How do I replace ceiling drywall over cabinets?

I recently had some water damage to my ceiling after a storm. For the most part, it's a simple cut out and replace procedure, but I'm stuck wondering what to do in the kitchen. There's about 1'x2' ...
3
votes
6answers
21k views

What is the cheapest way to add texture to a wall

The previous home owners used a perforating tool to remove wallpaper, and just painted over all the holes and lines. I am in desperate need of some texture with no budget. I need to put a new baby ...
4
votes
1answer
343 views

Which drywall screws to choose

1 1/4", 1 5/8", 2 1/2", bugle head, trim head, drill point, sharp point, coarse thread, fine thread... With so many different kinds of drywall screws available, how is anybody to know which type and ...
24
votes
4answers
15k views

Should I use nails or screws for hanging drywall on the ceiling?

I'm replacing water-damaged drywall on my ceiling and was considering using screws. Other than cost, is there any other reason I should use nails instead? Or am I too paranoid that nails won't have ...
6
votes
2answers
824 views

Wet Room walls, is plasterboard (Gyproc or Drywall) OK to use?

Looking to build a new wet room style bathroom. Is it better to use cement sheeting for the walls that will be tiled, or will plasterboard (Gyproc) just as good to use? Obviously whichever surface is ...
3
votes
3answers
2k views

Remodeling a pre-1920's home with planks on the interior walls

I own an older home in central PA; my guess it is pre-1920's and I was going to remodel the living room and insulate the walls and run new wiring. The walls are horse hair plaster; when I removed the ...
3
votes
4answers
193 views

What to do with small patch of wallpaper in middle of wall?

I have a patch of wallpaper in the middle of a wall I am trying to paint. Its only about 18 inches tall and 6 inches wide. It doesn't seem to want to come off, I tried using a razor blade to take it ...
0
votes
2answers
7k views

Should I install a moisture barrier behind drywall in house with T1-11 siding?

My home interior walls are thick redwood paneling in the bay area mountains. i'm about to start removing the wood in my second bedroom and want to install a moisture barrier on the 1 outside wall of ...
1
vote
2answers
684 views

How do I install a 2 gang low voltage bracket?

Purchased varying 1 gang and 2 gang low voltage screw-in type brackets as seen here. Upon inspection they appeared to simply sit in the wall with the the screws being screwed into the side of the dry ...
5
votes
3answers
4k views

Mild water damage on drywall from leaky roof

We have a fairly new house (built in 1997). Cheap roof and we had a big windstorm a few years back that resulted in some lost shingles that I had patched -- no major problems. Recently we had a much ...
2
votes
1answer
376 views

Garage Fire Wall

I'm in the process of selling my home and the Home Inspector has said the follow: The fire rating is compromised due to missing drywall at the access opening to the area under the front entry (wood ...
3
votes
2answers
4k views

Should I replace or patch a plaster ceiling?

My house is about 109 years old, excellent condition, other than cracking in the plaster ceilings. I've had one 3x3 section even fall out in my dining room. I want to replace the ceiling in the ...
3
votes
1answer
400 views

Kitchen Cabinets And Dry Wall Screws

I've got some kitchen cabinets that were hung using 4", course threaded, dry wall screwed. At every stud there is a screw at the top and bottom of the cabinet. Additionally, each cabinet is joined ...
4
votes
2answers
409 views

My kitchen has no real walls. Is this going to be a problem?

I recently redid my kitchen, which included removing the back splash and putting in new tile, but when I went to remove the old tile, I found that the tile is only attached to drywall. Knowing this ...
3
votes
1answer
170 views

How bad is a leak-through?

I replaced a Fluidmaster in a toilet, and I suspect the fill valve was slightly loose because, after about 12 hours there was a small puddle in the bathroom and the ceiling below was damp. I turned ...
2
votes
2answers
738 views

How can I mask water damaged ceiling drywall with faux painting?

My tub upstairs leaked a large portion of water directly above the middle of the kitchen ceiling. The ceiling drywall doesn't have a hole in it, and the paint isn't bubbling. However after I fixed the ...
10
votes
2answers
7k views

How do you bend a sheet a drywall into a curve?

How do you bend a sheet a drywall into a curve? I tried wetting the back surface with a paint roller, letting it soak for 30 minutes, then scoring the back paper in parallel lines about an inch apart ...
4
votes
1answer
787 views

What wall material should be used behind the Kerdi system in a tub/shower?

I know from my previous question that in most cases a cement board of some kind needs to be used. However, when the Kerdi membrane system is being used behind the tile, is it still necessary to use a ...
5
votes
3answers
10k views

How should I level (flatten) ceiling joists for drywall?

My kitchen ceiling joists are old and at varying heights. I'm trying to make it level, or at least flat, in preparation for drywall installation. Would you suggest installing strips of wood to the ...
6
votes
1answer
1k views

Will my pocket door affect my installation of a tub surround?

My wife and I have decided to install a tub surround around our tub (best place to put it!). We are planning on removing the tile and the drywall behind the tub and installing one of the surrounds ...
4
votes
1answer
4k views

How do I repair a canned light that's falling down?

I apologize if the term is not "can light", but I don't know what these types of lights are called. Anyhow, the "can" of one of our lights has fallen out from the drywall ceiling (just a bit), and ...
2
votes
6answers
17k views

How do I cover large gaps in drywall?

We've just completed our first drywall project and the outcome wasn't so great in places. There are a couple spots in particular that have 1/2-1/4" gaps. I was wondering, is there a nifty way to ...
3
votes
2answers
899 views

How do I install drywall when the door is too close to a concrete wall?

I'm looking for suggestions to finish one of the walls in my basement. I've included the pictures of the wall below. As you can see the doors are right up against the wall on both sides. There's ...
1
vote
2answers
10k views

How does wood paneling compare to drywall?

what does wood paneling do better or worse than drywall? For example cost ease of installation ease of modification maintenance longevity fire resistance noise insulation heat insulation etc.
7
votes
5answers
32k views

How do I repair a curtain rod anchor that was ripped out of the wall?

My children managed to pull on the curtains hard enough to yank the bracket which attached the curtain rod to the wall out. What is the best way to repair this? Here's what it looks like:
5
votes
1answer
315 views

What material to use to patch a hole near a heater?

The previous owner installed a base-board heater in the bathroom, but did a really poor job. Below the heater, there is a hole in the drywall where the wiring goes into the wall about the size of ...
5
votes
2answers
2k views

Can water-damaged drywall be repaired, or does it have to be replaced?

We have a basement bathroom that has water damage from the bathroom above. The damage is old, so it has completely dried, however it has bubbled the paint so the damage is obvious. Mold is not a ...
3
votes
2answers
2k views

How do I repair a drywall ceiling when there is blown in insulation above?

I was finishing the space above a garage. The space was buried in blown in cellulose insulation and we framed in some walls, laid a subfloor, and finished the room. During framing two different ...
2
votes
2answers
435 views

Tips for texturing ceilings?

I'm getting ready to texture ceilings for the first time using an air-compressor / hopper. I plan to practice first on some old sample sheets of drywall I have laying around but was also hoping to ...
5
votes
1answer
727 views

How do I splice a drywall metal outside corner bead?

When re-finishing my ceiling (formerly popcorn, now smooth) I had some trouble with the edge of the tray ceiling in the master bedroom. Since the length of the tray was longer than a standard metal ...
2
votes
1answer
233 views

How large are in-wall heating vents that connect to registers?

I'm curious how large heating vents can typically be when connecting to in-wall registers. Do they fill up the entire space between studs? I'm framing for some drywall patches and would ideally not ...
11
votes
5answers
3k views

Is there a technique or tool for consistently placing drywall screws correctly?

Is there a special technique or tool for consistently placing drywall screws correctly? I'm using a standard Dewalt DWD115K (with no auto-stop mechanism) so I'm usually paranoid of going too deep ...
6
votes
3answers
3k views

Can quick-drying mud be used on the same drywall joints where slow-drying mud was used?

I think I phrased the summary/title poorly but essentially, I'd like to know if all drywall mud coats need to use the same type of joint compound for all coats or if I can transition to quick drying ...
4
votes
2answers
727 views

How should I repair drywall where heating registers used to be?

We recently had an asbestos abatement crew remove heating ducts in our house that had asbestos-lined duct insulation. Part of the process required them to remove the duct registers in the wall as ...
5
votes
2answers
3k views

What are the pros and cons of rolled-on wall/ceiling texture paint?

I just recently learned that some wall/ceiling textures can be applied with a paint-roller and special texture "paint". Here are a couple examples from Home Depot: I was hoping to get more ...
7
votes
3answers
3k views

How can I keep leftover drywall mud from drying out in the box?

I'm not quite sure how much drywall mud I'll be using for my upcoming project so I'm planning to buy a box of it. Assuming that I have some left over, is there a technique for not wasting it? Will it ...
7
votes
3answers
6k views

What consistency should drywall mud be?

I've been reviewing various drywall videos and documentation but I haven't found clear details on what kind of thickness the joint compound should be. Is there a definitive answer for this? Or does ...
10
votes
3answers
402 views

Why are progressively larger drywall knives used after each mudding pass?

I've been researching drywall finishing techniques and have noticed that when a first coat of mud compound is used, a smaller 6 inch taping knife is used... then on the second mud application, a ...
2
votes
1answer
8k views

What are some tips/techniques for applying knockdown texture to drywall?

I'd like to get advice on applying knockdown texture and fixing my own mistakes in the process. The consistency I'm looking for is something similar to this: As per an eHow article, I think the ...