For questions about drywall (aka plasterboard) installation, repair & finishing.

learn more… | top users | synonyms (1)

1
vote
2answers
9k views

How does wood paneling compare to drywall?

what does wood paneling do better or worse than drywall? For example cost ease of installation ease of modification maintenance longevity fire resistance noise insulation heat insulation etc.
7
votes
5answers
29k views

How do I repair a curtain rod anchor that was ripped out of the wall?

My children managed to pull on the curtains hard enough to yank the bracket which attached the curtain rod to the wall out. What is the best way to repair this? Here's what it looks like:
5
votes
1answer
298 views

What material to use to patch a hole near a heater?

The previous owner installed a base-board heater in the bathroom, but did a really poor job. Below the heater, there is a hole in the drywall where the wiring goes into the wall about the size of ...
5
votes
2answers
1k views

Can water-damaged drywall be repaired, or does it have to be replaced?

We have a basement bathroom that has water damage from the bathroom above. The damage is old, so it has completely dried, however it has bubbled the paint so the damage is obvious. Mold is not a ...
3
votes
2answers
2k views

How do I repair a drywall ceiling when there is blown in insulation above?

I was finishing the space above a garage. The space was buried in blown in cellulose insulation and we framed in some walls, laid a subfloor, and finished the room. During framing two different ...
2
votes
2answers
408 views

Tips for texturing ceilings?

I'm getting ready to texture ceilings for the first time using an air-compressor / hopper. I plan to practice first on some old sample sheets of drywall I have laying around but was also hoping to ...
5
votes
1answer
674 views

How do I splice a drywall metal outside corner bead?

When re-finishing my ceiling (formerly popcorn, now smooth) I had some trouble with the edge of the tray ceiling in the master bedroom. Since the length of the tray was longer than a standard metal ...
2
votes
1answer
227 views

How large are in-wall heating vents that connect to registers?

I'm curious how large heating vents can typically be when connecting to in-wall registers. Do they fill up the entire space between studs? I'm framing for some drywall patches and would ideally not ...
11
votes
5answers
3k views

Is there a technique or tool for consistently placing drywall screws correctly?

Is there a special technique or tool for consistently placing drywall screws correctly? I'm using a standard Dewalt DWD115K (with no auto-stop mechanism) so I'm usually paranoid of going too deep ...
6
votes
3answers
3k views

Can quick-drying mud be used on the same drywall joints where slow-drying mud was used?

I think I phrased the summary/title poorly but essentially, I'd like to know if all drywall mud coats need to use the same type of joint compound for all coats or if I can transition to quick drying ...
4
votes
2answers
655 views

How should I repair drywall where heating registers used to be?

We recently had an asbestos abatement crew remove heating ducts in our house that had asbestos-lined duct insulation. Part of the process required them to remove the duct registers in the wall as ...
5
votes
2answers
2k views

What are the pros and cons of rolled-on wall/ceiling texture paint?

I just recently learned that some wall/ceiling textures can be applied with a paint-roller and special texture "paint". Here are a couple examples from Home Depot: I was hoping to get more ...
7
votes
3answers
2k views

How can I keep leftover drywall mud from drying out in the box?

I'm not quite sure how much drywall mud I'll be using for my upcoming project so I'm planning to buy a box of it. Assuming that I have some left over, is there a technique for not wasting it? Will it ...
7
votes
3answers
6k views

What consistency should drywall mud be?

I've been reviewing various drywall videos and documentation but I haven't found clear details on what kind of thickness the joint compound should be. Is there a definitive answer for this? Or does ...
10
votes
3answers
375 views

Why are progressively larger drywall knives used after each mudding pass?

I've been researching drywall finishing techniques and have noticed that when a first coat of mud compound is used, a smaller 6 inch taping knife is used... then on the second mud application, a ...
2
votes
1answer
7k views

What are some tips/techniques for applying knockdown texture to drywall?

I'd like to get advice on applying knockdown texture and fixing my own mistakes in the process. The consistency I'm looking for is something similar to this: As per an eHow article, I think the ...
3
votes
1answer
613 views

How do I replace missing drywall strips after an asbestos abatement?

I'm getting ready for my first major DIY project (about a week away). Here's a summary: We confirmed the presence of Asbestos in our house heating vent insulation and acoustic ceilings. We're ...
8
votes
1answer
1k views

How should I mount a TV stand on a wall covered in drywall?

How should I mount a TV stand on a wall covered in drywall? Should I trenail it to the wall?
2
votes
5answers
1k views

Should I install baseboards before or after skimcoating?

My bathroom walls were a mix of plaster and drywall with various layers of paint, primer, and skim coating. I attempted to skim coat the walls myself to prepare for priming and painting, but I wasn't ...
3
votes
5answers
303 views

What quick and dirty tool/method should I use for cutting scrap drywall?

I have a pile of drywall scrap that's been sitting in my garage for a few years after a remodel, "just in case". My buddy came up with the idea of turning it into "karate boards" for our kids to ...
5
votes
3answers
4k views

What are some alternatives to wall anchors?

I've used these anchors in the past...I really like them for heavy duty mounting in drywall (for things such as vertical standards for shelves). However, these make pretty big holes in the drywall. ...
5
votes
3answers
8k views

What kind of wall material should be used in wet areas in a bathroom?

I'm replacing a one piece fiberglass tub with a two piece (tub + surround) unit. In the bathroom right now, there's just drywall, no special material. Should I replace the drywall with greenboard, ...
5
votes
5answers
2k views

How can I finish this “peeled” drywall?

While doing some work in my bathroom, one thing led to another and paint started peeling. I found that under many layers of paint was some wallpaper so it seemed natural to pull... I started peeling ...
2
votes
1answer
450 views

Installing a shelf on a stucco-covered wall

We have a wall in the workroom next to our kitchen where we'd like to put a long, shallow shelf. The wall is stucco, and I'm a little concerned about the wall crumbling or cracking around the pilot ...
4
votes
4answers
2k views

What should I do about a gap between hardwood and drywall?

First-time home-owner - house less than 1 year old. We had our home built last December, and have been discovering all sorts of problems with it. The latest was a trail of ants within our kitchen ...
3
votes
4answers
5k views

Why does the plaster crack beneath the window sill?

Sorry if this is an obvious question. Can anyone tell me why the dry lined plaster in our house so frequently cracks beneath the edge of the windows? At first I thought it may be relating to the ...
17
votes
8answers
82k views

How much weight can screws in drywall withstand?

I've always had the question of how much weight can a single screw into a drywall withstand? For instance, I would like to do things like this: It's hanged with 5 screws. The whole thing weights ...
32
votes
9answers
61k views

How do I run wires for a wall-mount flatscreen TV?

Like a lot of you, we have several wall-mounted LCD HDTVs in the house. The TVs have two wires -- power and HDMI -- running down the wall to the power outlet and cable box. I've historically been too ...
11
votes
5answers
14k views

What are the different types of drywall anchors, and what are the advantages of each?

I recently put up wire shelving in my pantry, and spent forever figuring out what type of drywall anchor I should use. I even found several types that I didn't even know existed. It might be good to ...
3
votes
2answers
2k views

How can I find places to nail/screw into walls of ICF (insulated concrete form) home?

The home I bought has exterior walls made of ICF (insulated concrete form). I don't know the brand or type, I just know that somehow the builders attached the drywall to the styrofoam/concrete. I'm ...
19
votes
5answers
4k views

What is the best method to patch a large hole (2-3 inches) in drywall?

I have a large hole where a TV wall mount once was (I believe the hole was used to run power and coax cable to the TV). I have since moved the TV and would like to patch the hole. What is the best way ...
4
votes
1answer
1k views

How well do metal inside corner beads work?

I'm currently doing some drywalling in my basement, and the biggest PITA for me is always finishing the inside corners. Recently I saw at Home Depot they have these metal inside corner bead pieces. ...
17
votes
4answers
5k views

How do I find studs when stud finders won't work?

I was trying to hang my TV at my new place, on an interior wall (between living room and a bathroom). Using the stud finder on other walls worked fine, but on this wall I got some very strange ...
14
votes
6answers
7k views

How do I remove wallpaper from drywall?

I know there are a lot of different ways to remove wallpaper, ranging from elbow grease to chemicals and steam machines. What way(s) work(s) best?
12
votes
8answers
4k views

Is fiberglass mesh tape a good choice for drywall?

I'm going to be doing some drywalling shortly and was wondering what experiences other have had with the self adhesive fiberglass mesh tape. Is it a good choice or am I going to regret using it?