For questions about drywall (aka plasterboard) installation, repair & finishing.

learn more… | top users | synonyms (1)

1
vote
0answers
140 views

Fixing minor tape blemishes/bubbling after a fresh paint job

Unfortunately 1 week after a new paint job was done with a decent job of skimming and all, there was a small flood in a laundry room above. Some water came down, but we averted disaster. It's very ...
2
votes
1answer
220 views

Possible Electrical Short After Drywall Installation

I just finished tearing my office down to the studs, insulating, and then having drywall installed. The crew did the drywall install today. I have a light switch which is a dimmer that powers 4 "cans" ...
0
votes
0answers
37 views

Drywall Type for Conditioned Basement

In my conditioned basement, should mold and moisture resistant drywall be used? I've read varying accounts, including use it everywhere, use it on the walls (but not ceiling), use it on the bottom row ...
1
vote
3answers
356 views

What's the best way to run a wire from inside my garage to the outside?

I'm installing an underground fence for my dog, which requires putting the receiver inside the garage (plugged into an outlet) and running the insulated fencing wire to the outside where it will be ...
2
votes
3answers
242 views

Should I expect a level ceiling when my kitchen was completely gutted?

My contractor is giving me the runaround. I really like the guy, but I feel like this is unacceptable. My new cabinets look off because of it. What should I do?
3
votes
2answers
98 views

Is drywall replacement necessary where a bulkhead was removed?

Is drywall necessary when bulkheads are removed and new cabinets will cover the space made by the removal? Are there safety issues if the drywall is not replaced?
9
votes
5answers
43k views

How do I repair a curtain rod anchor that was ripped out of the wall?

My children managed to pull on the curtains hard enough to yank the bracket which attached the curtain rod to the wall out. What is the best way to repair this? Here's what it looks like:
1
vote
1answer
86 views

Fixing a hole in the wall

I punched a very large hole in the wall. I think I know how I should go about fixing it, but I am asking here in order to double-check. I've cut circular hole into a slightly larger rectangle. I plan ...
0
votes
2answers
211 views

How do you hang something on sheetrock if you have metal wall studs? [duplicate]

How do you hang something on sheetrock if you have metal wall studs? The item is a very heavy shelf, so anchors aren't going to cut it.
5
votes
1answer
412 views

How to properly fix dry wall tearing away

How can I properly fix dry wall that is tearing away from the seam, which is a window sill? There is a point were it meets the window and window sill, and it seems to be tearing away. I have added a ...
0
votes
1answer
147 views

Should I remove existing drywall before framing a wall around HVAC ducts?

My friend has soft AC ductwork running up an interior wall. He wants to build a wall around it to hide the ductwork. My idea is to pack out the wall by nailing in framing between the ductwork right ...
1
vote
1answer
1k views

1“ x 2” Furring Strips for Drywall Ceiling

In my basement, there's currently a tile ceiling that's installed on furring strips attached to the joists. The furring strips are 1"x2", attached to the joists by nails. We're currently replacing the ...
4
votes
3answers
632 views

How do I insulate space in loft to create music studio

I have 3 DIY created rooms in my large live/work studio/artist loft. They are made with 2x4 and 2x6, framing with drywall walls and plywood ceiling. The apt has 14' 7" ceilings so we just have ...
1
vote
1answer
435 views

Can I glue a second layer of drywall?

I want to attach a second layer of drywall to old, partly damaged and crumbling drywall, with construction adhesive. I cannot use screws only because my patch's edges do not fall on studs (the patch ...
2
votes
2answers
152 views

What's the point of a thin (1/4" width) piece of wood set diagonally between two studs?

What's the point of a thin (1/4" width, ~2-3" wide) piece of wood set diagonally between two studs? I just took out a piece of drywall for some other work I'm doing, and between two studs, there's ...
1
vote
1answer
94 views

Can this sheetrock be repaired or does it need to be replaced?

Removed formica backsplash made a huge mess. Can it be repaired, and if so, how?
1
vote
3answers
677 views

How can I check for drywall behind wood panelling?

What's the best way for me to know whether there is drywall behind wood panelling walls? The wood panelling looks inexpensive, and it's in a big room (a converted garage).
4
votes
2answers
2k views

How can I remove plaster board/drywall rawl plugs?

I have used red head metal plaster board rawl plugs. The kind that flare out flat when you screw the bolt in. I now need to remove them. Is there a trick to remove them so I can reuse them or take ...
2
votes
2answers
232 views

Is it OK to liquid nail drywall in a hard-to-reach corner?

I need to drywall around an 8" air spiral pipe coming out of a wall at a 45 deg angle and there is very little room on the side between it and the wall the pipe runs parallel to. So it is very very ...
0
votes
2answers
122 views

How to prevent outdoor wall touching concrete fom getting moisture issues?

In my house the drywall is contact with the concrete. This is putting lot of moisture in the drywall and eventually it will start to rot. What is the best solution in this case to isolate the wall ...
3
votes
2answers
7k views

How do I get my recessed light fixture flush?

I installed two new recessed LED light fixtures using 4" new construction IC housings. The problem is that both fixtures are not flush against the ceiling after installation, they are dipping down on ...
17
votes
11answers
4k views

What should we look for when buying a fixer-upper house?

My fiance and I are considering buying a fixer-upper house rather than an apartment when we get married. Obviously things like location, neighbors etc. are important, but; what should we be looking ...
1
vote
5answers
675 views

Can i leave existing drywall alone when adding two small walls to a finished basement?

I am building two small walls in a finished basement to create a enclosed landing at the bottom of the stairs. The new walls will meet at 90 degrees, both will be coming off studs in the existing ...
2
votes
3answers
510 views

Make new walls match thickness of old walls

I'm working in a 1952 house and the studs used then are apparently 3 5/8" thick instead of the studs today at 3 1/2". I know it's really close so I'm wondering if I fill in door ways along a wall to ...
4
votes
2answers
189 views

What should I do about this unfinished corner?

I've got this bit next to my back door that looks like it was never properly finished. There doesn't seem to be any structural issue, so I'd feel comfortable fixing it myself. Trouble is, I have no ...
0
votes
2answers
235 views

How can I hang ceramic art on drywall?

Artist recommends using 4" dry wall screws inserted at an angle to hang his art. This does not look sturdy. Any ideas ? The art is a large ceramic tic tac where 2" of the screw is inserted in one ...
2
votes
3answers
636 views

How to (portably) mount warped plywood artwork on apartment drywall?

I have a 4' x 4' piece of plywood artwork (acrylic painting) that has become warped. It used to be mounted to drywall using velcro strips, but now the outward force of the warp is strong enough that ...
2
votes
2answers
741 views
0
votes
2answers
3k views

How to adhere drywall to cinder block

I have just purchased a home which I will be renovating prior to moving in. The house was built in 1950 and has cinder block ex/interior walls. I have an area going into the hallway which attaches to ...
6
votes
1answer
874 views

How much drywall should I cut to re-route some wires?

I am just looking for advice on how much drywall to cut to move some wires. There's a wire in the ceiling that has incoming power, and a switched leg for the light in the entry way, and another ...
1
vote
0answers
262 views

Am I going to die of Cancer from Asbestos if not handled correct? What more should I do? [closed]

So I have scrapped down old pop corn ceiling and removed staple on tile on drywall attached to plaster, that can be only lord knows how old. I didn't hang any barriers up as we are planning to do ...
0
votes
0answers
77 views

Replacing drywall above boiler… to Code? Inspection?

I own a mid-1800's house in New England, with a fieldstone foundation and dirt floor basement. I now have a mold problem in the basement. There is lone sheet of drywall above the boiler & water ...
0
votes
3answers
3k views

Drywall over plaster with furring strips

So I just removed staple on ceiling tiles from my curling to find they were done on top of plaster, my questions are: 1) is there any fear in any case of the drywall adding to much weight to the ...
3
votes
0answers
311 views

What materials and spacing should I use for ceiling joists/strapping in this conversion?

I have an old two bay garage that's 28'x50', that I would like to convert into a home. One thing I'm trying to figure out is how to do the ceiling. The ceiling is held up by metal joists approximately ...
1
vote
1answer
926 views

Can a condo interior room walls have steel studs that are paper thin?

I'm a bit puzzled about what's behind the drywall in my high rise condo built 3 years back. When drilling into an interior room wall supposedly where a stud should be(found by a stud detector and yes ...
3
votes
2answers
4k views

Should I cover a skylight well from the inside?

I made the mistake of having a Velux skylight installed in my bedroom. The installation was done by pros, both inside and out, and it has never leaked through 2 hurricanes. The installation was done ...
1
vote
1answer
988 views

Painting on drywall that has been stripped of wallpaper?

We stripped wallpaper off our bathroom wall and found that the builder did not size up the wall first, he papered directly onto the drywall. We have sanded the drywall best we could to try to smooth ...
0
votes
0answers
49 views

Is tile primer suitable for plastering in bathroom?

I've plasterboarded using moisture resistant board and plan to title round the bath using Tile Adhesive Primer first. I was wondering whether this primer is also suitable for plastering the opposite ...
9
votes
4answers
12k views

Should I be worried if I missed the studs while mounting my TV?

I think I missed the studs based on how easily the drill moved through the drywall. My LCD only weighs 27lbs and the mount itself is 5lbs (rated to hold 165lbs, and uses 4 8mm lag bolts). I pulled as ...
2
votes
1answer
53 views

Shellac, Texture, and Smoke Damage

We have a 4-plex that started on fire. The sheetrock in a couple of units was saved. To lock in the smoke odor, we were told we need to use a shellac primer. However, we would like to texture the ...
0
votes
0answers
35 views

Why use drywall tape when you can just mud over the crack? [duplicate]

Got a semi-small drywall project with several "joints" and just wondering what would happen if I didnt use the tape? (corners and "butt-joints")
2
votes
2answers
549 views

How to fix over-tightened metal drywall anchor?

I was installing a metal drywall anchor for the first time, and accidentally over tightened it. Now it isn't tight on the wall, and is unusable. I can not remove the screw from the wall, and am ...
3
votes
1answer
624 views

Is it possible to remove and replace base molding, and not have to repaint the wall?

I am dealing with recent flooding in my apartment. As you can imagine, I am doing repairs myself. The work is financed by my insurance company, which has been pretty good about it. There is just one ...
1
vote
4answers
260 views

How can I repair this damage to the walls in my garage?

The walls in my garage look terrible, they are ripped at the bottom all around the entire garage. I have no idea what caused this. What's the best way to fix something like this? I've also got foam ...
1
vote
0answers
343 views

What to do first: prime walls or install baseboard? [closed]

I have a brand new wall, taped and sanded smooth, ready to paint. What should I do next, prime it first and then nail the baseboard? Or the baseboard first, then prime? I noticed that professionals ...
7
votes
3answers
9k views

What consistency should drywall mud be?

I've been reviewing various drywall videos and documentation but I haven't found clear details on what kind of thickness the joint compound should be. Is there a definitive answer for this? Or does ...
1
vote
2answers
1k views

How do I add fire protection to a common (shared) wall?

I own a condo, built in 1961. I've started remodeling and in tearing out my kitchen I discovered the wall between me and my neighbors is only that: a wall. No fire protection just drywall, regular ...
1
vote
3answers
909 views

How to poke coaxial cables out of a wall nicely?

I have coaxial cables that are poking out of walls in numerous places all over the house. I don't use them and I don't know why there's so many coming out of each hole. These were left by the previous ...
0
votes
3answers
994 views

How to repair garage ceiling?

The attic of my house is unfinished. My son accidentally fell to the filing and caused the garage ceiling broken. Please see the images. Can you advise me how to repair this?
2
votes
1answer
412 views

How can I tell if this is wood or drywall?

I am trying to mount speakers on the topmost part as you can see here: Basically I am mounting it on that thin vertical area that you can see. Is this part wood or drywall? From tapping it, it ...