For questions about drywall (aka plasterboard) installation, repair & finishing.

learn more… | top users | synonyms (1)

1
vote
0answers
84 views

How can I make a smooth transition from granite to drywall?

I had solid sheets of granite installed for shower. Looks good except for the adjoining areas. First shower does not run width of room - so there is a support wall for the right hand side of ...
4
votes
3answers
212 views

How can I paint over an existing paint design without making it permanent?

We have a baby on the way. We are currently designing the nursery. The room currently has a diamond-shaped pattern that we'd like to keep, since it is unique and cool looking, plus it came that way ...
2
votes
1answer
998 views

How do I prepare a ceiling for restomping?

I had to cut access panels in the ceiling of a 7' x 11' room to make several plumbing repairs. The ceiling has the slapbrush/stomp texture: I have patched the drywall and I plan on restomping the ...
1
vote
1answer
245 views

How can I block off a doorway with studwork on a brick wall?

I'm blocking up a doorway in a brick wall. I've decided to block it up using a stud wall as that should be a bit easier than bricking it up. I know that the bricks are 11cm depth plus approx 2cm ...
4
votes
3answers
698 views

Can my drywall act as an air barrier?

I am preparing to improve a building in a cold climate zone. Since it does not seem to be properly insulated, I am reading a book about insulating and weatherizing. That teaches me that I should ...
3
votes
1answer
2k views

How to tile over shower wall surround flange?

Background I've been following this guide from Family Handyman on installing a fiberglass tub surround, and am to the point where I need to tile over the nailing flange. They say to put 1/4" tile ...
3
votes
2answers
3k views

What should I do after mistakenly using moldy paint on drywall?

I was painting my basement and used a six year old five gallon bucket of paint. It had about 4 gallons of paint in it. The surface was black, but it didn't smell bad. I thought it was the dye ...
4
votes
2answers
328 views

How do I locate studs in my wall?

First, I'm not the handiest of men, but can usually figure this sort of thing out. I just moved into an apartment in Manhattan and we're wanting to mount shelves, desks, and televisions to the wall to ...
4
votes
4answers
376 views

Is this a good drywall hole cutter?

Has anyone used this: Stanley Drywall Hole Cutter There are no reviews for it and I can't seem to find any on the web. I like the fact that it has two saws, though since I've never used a cutter ...
2
votes
1answer
204 views

How can I hang a heavy mirrored bathroom cabinet?

I purchased a bathroom cabinet today that is 1200 mm wide, by 750 mm tall, and 150 mm deep. When I brought it home, I discovered it weighed nearly 40 kg (88 pound) empty. I was told that I could use ...
2
votes
2answers
738 views

How can I prepare a wall for reasonably heavy tiles in a shower area?

I'm renovating a bathroom in my apartment and would like to fit 12mm Travertine tiles in a bath/shower area. For most of the walls in this area I have used cement board (Hardibacker 500) attached ...
2
votes
1answer
162 views

Is it hazardous to leave a hole in the wall for a week or two?

Yesterday in a fit of manliness I accidentally punched a hole in the wall of my bedroom. I will eventually get some putty to fill in the hole but I'm concerned about the fibrous dust that may be in ...
2
votes
2answers
938 views

How can I figure out what material my row home's interior and party walls are made out of?

I'd like to hang some shelving on the wall in my kitchen that separates my home from my neighbor's. How can I figure out what material this wall is made of? The home was built in 1950. The party wall ...
3
votes
3answers
2k views

How do I fix drywall around wall box so switch plate covers damage?

In my house, there are maybe three or four outlet boxes and switch boxes where there was damage done to the drywall surrounding the box at some point. There are no structural or electrical issues ...
2
votes
1answer
556 views

How do I mount curtain rods securely into crumbling plasterboard?

I am trying to hang curtains and am using a medium weight wall plug which screws directly into the plaster. I live in an old Victorian mansion block, and every time I try and screw the plug into the ...
2
votes
1answer
2k views

Why is the joint compound cracking around a repaired patch in my ceiling?

Backstory: We had a leak in our roof that damaged some of the ceiling drywall. When we put new drywall up, the pre-existing drywall "sagged" a bit lower than the fresh piece that was screwed into the ...
1
vote
2answers
281 views

How do I replace a 7' drop ceiling so it matches an 8' ceiling with 2 layers of drywall and popcorn texturing?

I would like to remove a dropped ceiling and give the room an 8 foot ceiling. The great room ceiling has 2 layers of drywall already. I need to repair many areas of the ceiling (remove an attic fan, ...
2
votes
1answer
262 views

Is it normal to have a bulge along the seam between pieces of drywall?

We are just finishing up (cross our fingers) our first Wisconsin winter in our new (to us) home and the other day notice something strange along the exterior walls. Roughly 4 ft up from the floor a ...
6
votes
2answers
229 views

Is the back section of this house salvageable or should it be knocked down?

My grandfather's house is getting to be in bad shape after years of neglect and more so the back section of the house is falling apart. Now the back section of the house, if I remember correctly, was ...
1
vote
1answer
2k views

What is the proper way to install a exterior door in brick/drywall wall?

A little background: in Brazil drywall is kind of novelty yet, mostly used on comercial building. Houses here are still built only using bricks, with the jambs of door being affixed to the bricks ...
1
vote
1answer
2k views

How can I attach a light fixture to plasterboard?

After some water damage and a ceiling repair I cannot locate the joist to refix the light fitting. It is a circular fluorescent light weighing about 3 and a half pounds. Is it safe to fix all 3 ...
2
votes
2answers
6k views

Could this cracked drywall be caused by a shifting house?

We are in southern Illinois and last Sunday my wife noticed a crack above the kitchen cabinets. We started looking around and have found cracks all over the house in different areas that were not ...
1
vote
2answers
434 views

How do I add fire protection to a common (shared) wall?

I own a condo, built in 1961. I've started remodeling and in tearing out my kitchen I discovered the wall between me and my neighbors is only that: a wall. No fire protection just drywall, regular ...
2
votes
1answer
736 views

How should I treat a rusty corner bead in the bathroom before covering it again?

The paint got scraped off the corner bead in my bathroom, and now it's rusty. How can I treat it before spackling and repainting?
0
votes
0answers
58 views

Rewiring House (Coax and Ethernet) [duplicate]

Possible Duplicate: How do I run ethernet, speaker wire, and coax through a wall into a crawlspace? When my family moved into our house, there were holes in the floors where the coax cables ...
2
votes
2answers
979 views

How do I tape a joint between drywall and plaster?

I have old old plaster (on lath) bordering new drywall. Is it better to use mesh tape or just paper?
2
votes
2answers
552 views

How do I patch my wall with tile along the seam?

I just removed the top 6" of tile from my bathroom wall which is tiled from the floor to about 4 feet up. I just didn't like the pattern of tiles at the top. The tile seems to have been attached to ...
3
votes
2answers
497 views

Will this moisture problem persist after drywall is installed?

we remodeled a trailer home recently, removed the aluminum siding, put up osb in place of the siding, then used the Lowes brand of house wrap. we installed new vinyl siding over that without using any ...
2
votes
2answers
297 views

How should I prepare drywall for wallpaper?

If I am posting wallpaper, is it still necessary to apply joint compound? I though that corner could be cut because the surface won't be exposed especially if i cut all the beveled edges off and ...
9
votes
1answer
814 views

When finishing drywall, is it a common practice not to mud the bottom of horizontally-hung drywall?

I hung drywall horizontally in my bedroom and hired a company to mud and tape it so that I could prime and paint. As you know, drywall sheets are recessed along the edges in order to hold drywall ...
2
votes
1answer
216 views

Can I use 2-1/2“ metal studs to hang 1/2” drywall?

I am in the process of remodeling my basement, & it's ready for studs; the basement is small, so to maximize as much space as possible I was thinking of using 2-1/2" metal studs opposed to the ...
2
votes
1answer
1k views

How can I cover water stains on this wall

During sandy storm I had some water leakage in my home. The damage isn't much in the sense that the drywall is still hard. It just has water stains that I'd like to get rid of. Here is a pic of what ...
2
votes
3answers
723 views

How do I reduce the number of screw pops in my drywall?

Background: I'm gluing and screwing 5/8 in drywall on the ceiling in my own home. I'm attaching it with screws and construction adhesive directly to the attic joists -- which are 16 in OC. I'm ...
0
votes
1answer
97 views

how to find out my primer color

I have some scratches on the drywall which was primer'ed dry wall from moving furniture. I'd like to just apply a coat of primer on the spots where the scratches are. I don't plan on painting just ...
2
votes
1answer
801 views

Which primer to use on an old drywall?

I have a dry wall in the kitchen that has some stains on it. I would just like to put a new coat of white primer on that dry wall so it doesn't look stained. My questions are: Should I sand the ...
2
votes
1answer
781 views

Is this asbestos in my ceiling drywall?

While looking through a hole in the drywall, I saw this... Is this asbestos?
1
vote
1answer
2k views

How do I properly prepare newly-finished drywall for priming?

What is the minimum amount of dust that can be left on a wall before it adversely affects primer application? If it has to be completely free of dust, how do you get it all? Taking a damp rag over ...
3
votes
2answers
1k views

Can drywall with ripped paper be repaired?

I damaged some drywall when doing demo in a bathroom. Some of the paint peeled back and exposed the paper, which ripped off of the drywall. Can I do a thin coat and sand? please help, already ...
5
votes
1answer
524 views

How do I mount this non-standard wall plate to a completed drywall wall?

I have this But it only has what you see in that pic. I was told I needed the box thing to go behind it to mount it to in the wall. There is no hole in the wall right now, so how do I get this to ...
6
votes
1answer
290 views

How do I install an old work junction box around fire blocking?

I have an interior wall with a one-gang light switch; it contains a dual dimmer. I'm trying to change this to a single dimmer, and to add a new switch (to drive the other load) on the opposite side ...
2
votes
1answer
338 views

Is it common for professional drywallers to tape narrow corners, but not mud over the tape if it's going to be covered with moulding?

Sorry to spam SE with questions relating to a job done by a company I hired to finish the project in my room, but some things seem very questionable to me. In the below pics you will see a narrow ...
3
votes
1answer
2k views

Can I hang a bathroom cabinet on a single stud and drywall anchors?

I have a 15-20lb wood bathroom cabinet (24 inches wide, few feet tall) and I'll be looking to load it up with heavy bathroom supplies. Problem is there is only one stud available. Do you think one ...
4
votes
2answers
1k views

can i paint my bathtub wall?

One of our bath walls is green Sheetrock with a white semi gloss paint finish. As you can see on the pictures attached, the paint has started to bubble and strip. What can we do now? shall/can ...
9
votes
2answers
953 views

Are these drywall screws properly driven/countersunk?

Related to this question. Even though I might be cluttering up SE with questions about driving drywall screws, I feel they will ultimately be helpful since I have been unsuccessful in finding images ...
1
vote
1answer
1k views

Should I primer my walls/ceiling before I spray on texture?

I have removed a wall and upper cabinet, replacing some sheetrock. I have skim coated and sanded the existing walls and removed the "popcorn" ceiling. My question is: do I need to primer the walls ...
11
votes
1answer
1k views

Are these drywall screws driven too deep into the sheet?

First off, I apologize for the asking and deleting my previous question about this. I thought it was more of a dupe of this question that I asked a while back. I'll be more central to the actual ...
9
votes
4answers
6k views

Should I be worried if I missed the studs while mounting my TV?

I think I missed the studs based on how easily the drill moved through the drywall. My LCD only weighs 27lbs and the mount itself is 5lbs (rated to hold 165lbs, and uses 4 8mm lag bolts). I pulled as ...
3
votes
2answers
918 views

How can I remove plaster board/drywall rawl plugs?

I have used red head metal plaster board rawl plugs. The kind that flare out flat when you screw the bolt in. I now need to remove them. Is there a trick to remove them so I can reuse them or take ...
3
votes
1answer
2k views

How should I insulate around pipe/cable holes in drywall?

Notice the gaps between the pipes and the drywall in the pictures above? These gaps appear in both the walls and the ceiling, and I feel like in at least one case, I've noticed a difference in air ...
7
votes
4answers
17k views

How can I repair a towel rack that was ripped out of the wall?

The towel rod has been ripped out of the wall. It looks like it was attached to the wall by two dry wall anchors which were not attached to the stud. Basically a very junky installation in my ...