For questions about drywall (aka plasterboard) installation, repair & finishing.

learn more… | top users | synonyms (1)

5
votes
1answer
2k views

Mold on drywall. Should I clean-up or replace?

Apartment next door got flooded and some water sipped underneath the wall. The floor buckled and had to be replaced. After removing floor trim I discovered some mold under the baseboard. I cut out a ...
5
votes
1answer
845 views

How do I mount this non-standard wall plate to a completed drywall wall?

I have this But it only has what you see in that pic. I was told I needed the box thing to go behind it to mount it to in the wall. There is no hole in the wall right now, so how do I get this to ...
5
votes
3answers
371 views

Can I make an existing dog door bigger for our new larger dog?

We have an existing dog door that we had installed in the wall for our beagle. We have since acquired a larger dog and she has out grown the door. I'm worried about injuries, so any advice will be ...
5
votes
3answers
6k views

Mild water damage on drywall from leaky roof

We have a fairly new house (built in 1997). Cheap roof and we had a big windstorm a few years back that resulted in some lost shingles that I had patched -- no major problems. Recently we had a much ...
5
votes
1answer
450 views

What material to use to patch a hole near a heater?

The previous owner installed a base-board heater in the bathroom, but did a really poor job. Below the heater, there is a hole in the drywall where the wiring goes into the wall about the size of ...
5
votes
1answer
2k views

How do I mount TV through 3 layers of drywall and into studs?

I have a 65lb 46" LCD television and a Sanus "flush" style wall mount. The mount instructions suggest that it shouldn't be mounted anywhere where there is more than the thickness of a single sheet of ...
5
votes
3answers
5k views

Using fire rated drywall/sheetrock in a partially finished basement

Background: We have a full basement and I have recently completed about half of it as a hang out spot for my teenage boys and their friends. The other side I use as a workshop and a place to store ...
5
votes
2answers
4k views

Is there an easy way to replicate this ceiling texture?

I have the swirly-tiny(stress the tiny)-bump texture on my ceiling on the first floor. I will be doing some major drywall repairs on the ceiling and would like tips on how to replicate the pattern. ...
5
votes
2answers
2k views

Can I put rigid foam on studs to prevent thermal bridging?

I'm re-insulating an interior wall & putting up drywall to replace the old plaster walls. Rather than screwing the drywall directly into the studs, I'm toying with the idea of putting a 1/2 inch ...
5
votes
1answer
5k views

How do I seal a leaky roof and repair the minor ceiling damage it caused?

We recently had some very heavy rains and during the worst of it we had some leaks. When I noticed the problem, I went into my attic and found out that the leak was coming from around a vent in the ...
5
votes
1answer
519 views

How can I replace ceiling gypsum board and loose fill insulation at the same time?

I lost most of a ceiling panel due to water saturation and collapse. It was removed along with insulation residue and a temporary fiber board panel tacked in in its place. Now I would like to install ...
5
votes
2answers
13k views

How do I repair drywall around a bathtub?

I have an area of drywall that is next to my bath tub that has gotten soft and crumbly. Mostly held together by paint & caulk now. I'm reasonably sure I understand why. We're getting some water ...
5
votes
3answers
6k views

What is eating my drywall?

Something is leaving scars in my drywall and deposits on the outside that I presume to be wood. These deposits are flat, stick out from the wall, an inch or more square, with a gap between the top and ...
5
votes
1answer
762 views

How do I mitigate moisture problems when putting up drywall over stucco with torn tar paper?

I'd like to finish my 56-year old garage with drywall but I have concerns about moisture. The wall construction looks like stucco over tar paper with metal wire support, then the frame. My main ...
5
votes
1answer
562 views

How can I refinish an interior chimney pipe to make it appear rounded?

Right now my interior chimney pipe is hidden behind a wall and I want to remove that wall and expose the pipe, but the pipe itself is not so pretty. My fireplace is a wood fireplace with a double ...
5
votes
1answer
1k views

Why is my (white) painted plaster going brown on the borders of the underlying plasterboard?

We've recently had our spare bedroom ceiling plastered, and there was a loosish bit of plasterboard that was secured by the plasterer before skimming the entire ceiling. After painting it I observed ...
5
votes
2answers
4k views

What are the pros and cons of rolled-on wall/ceiling texture paint?

I just recently learned that some wall/ceiling textures can be applied with a paint-roller and special texture "paint". Here are a couple examples from Home Depot: I was hoping to get more ...
4
votes
7answers
2k views

How do I deal with glued-on drywall?

I'm in the process of gutting a bedroom. I had to remove a pocket door, move the light switch, add a couple of receptacles, and deal with some rot/mold/insects on the exterior wall. I found that ...
4
votes
3answers
18k views

Can I hang a bathroom shelf with command strips or something similar?

I'm currently living in an apartment that doesn't allow me to put anything larger than a finishing nail sized hole in the wall. I have a small bathroom shelf that I would like to put up that consists ...
4
votes
4answers
2k views

How do I cut drywall on the ceiling accurately?

I want to cut the drywall on the ceiling accurately. The thing is that the drywall is thick and it is on the top. I have to stand on the ladder; one hand use utility knife and the other hand hold the ...
4
votes
4answers
7k views

Second layer of drywall on textured ceiling: Do I need to sand down or remove the texture before second layer goes on?

I have a textured ceiling similar to this: Some of the texture peaks at 1/8", but it mostly peaks at 1/16". I am going to be applying a second layer of drywall with Green Glue in between and I ...
4
votes
4answers
20k views

Is there a way to trace water pipes through walls?

I recently purchased my house and I am trying to find my internal valve to turn on my external faucet. Unfortunately the previous owner put in a bathroom in over where the water line enters the house ...
4
votes
3answers
40k views

Paint got ripped off when trying to remove double-sided foam tape

I was trying to remove a picture frame which was adhered to the wall with some double-sided foam tape. Unfortunately, the foam tape was so sticky and ripped some of the paint off the wall (see ...
4
votes
3answers
3k views

How do I repair a drywall ceiling when there is blown in insulation above?

I was finishing the space above a garage. The space was buried in blown in cellulose insulation and we framed in some walls, laid a subfloor, and finished the room. During framing two different ...
4
votes
2answers
3k views

What's the best material to patch gaps between moulding and the wall?

I am installing new moulding (aka baseboards, woodwork, etc). A few of the walls sort of dip inward, so a gap is left in between the moulding and drywall. What's a good material for patching this ...
4
votes
4answers
4k views

What should I do about a gap between hardwood and drywall?

First-time home-owner - house less than 1 year old. We had our home built last December, and have been discovering all sorts of problems with it. The latest was a trail of ants within our kitchen ...
4
votes
2answers
12k views

Do I need to remove existing drywall before framing an interior wall?

Below is a rough diagram of the interior wall I'd like to build. The wall is in green, and the rooms are in white. The grey offset around the edges of the walls represents 3/8" drywall. My question ...
4
votes
3answers
38k views

Under what circumstances is 5/8" drywall required?

From what I understand the code usually discusses things like fire rating (not specific thickness) as they relate to required material, and also the fastener pattern and what thickness to use versus ...
4
votes
1answer
621 views

How do I get invisible edges on my spackle jobs?

I have a basement that I am looking to eventually paint. The basement has spackle in various places on the walls, in many cases, way too much spackle appears to be applied, in a rather messy way, ...
4
votes
3answers
1k views

What's the best way to hang this large picture on insulated plasterboard?

I would like to hang this fairly large framed picture on my living room wall. The frame measures 167x75cm, and weighs roughly 8.5kg. Both top and bottom of the frame had snapped previously (while ...
4
votes
4answers
1k views

I'm looking for a drywall finish that will hold a magnet

I want to modify a wall so that small magnets will stick, and even hold a small dead weight. I would prefer that the magnetic area not look all that different from the rest of the wall, I don't want ...
4
votes
4answers
680 views

Is this a good drywall hole cutter?

Has anyone used this: Stanley Drywall Hole Cutter There are no reviews for it and I can't seem to find any on the web. I like the fact that it has two saws, though since I've never used a cutter ...
4
votes
1answer
5k views

Can I hang a bathroom cabinet on a single stud and drywall anchors?

I have a 15-20lb wood bathroom cabinet (24 inches wide, few feet tall) and I'll be looking to load it up with heavy bathroom supplies. Problem is there is only one stud available. Do you think one ...
4
votes
2answers
3k views

can i paint my bathtub wall?

One of our bath walls is green Sheetrock with a white semi gloss paint finish. As you can see on the pictures attached, the paint has started to bubble and strip. What can we do now? shall/can ...
4
votes
6answers
29k views

How should I remove the texture from the ceiling *without* tearing it out?

We want to get rid of the texture on our ceiling. It's a very ugly stipple effect. However, there's a foot and a half of insulation over this ceiling. Knocking it down to install new drywall is ...
4
votes
2answers
3k views

How to fit clothing rails into plasterboard to hold adequate weight?

I am converting hallway storage into a wardrobe. The dimensions are h 234cm W 132cm D 45cm I would like to put up two rails for clothing and some shelving for loose items My question is how would ...
4
votes
1answer
210 views

What advice would you offer somebody who is building a laundry chute for the first time?

I'm looking to build a laundry chute from our bedroom closet to the laundry room below. The positioning is such that the wall of our closet is shared with a storage closet in the loft above our ...
4
votes
1answer
248 views

How to fix numerous holes in drywall?

I bought a property for relatively cheep, the one bedroom has about 8 holes or so ranging from about 2-3 inches and others 4-8 inches most of which are in a 4 foot square area. I don't know the exact ...
4
votes
2answers
4k views

What thickness drywall do I need for 24" OC wall studs in a detached garage?

I am currently finishing an older 3-car detached garage. Both the wall studs and the ceiling trusses have 24" OC spacing. I know that for the ceiling, I'll need to use 5/8" thick drywall, due to the ...
4
votes
2answers
1k views

How should I repair drywall where heating registers used to be?

We recently had an asbestos abatement crew remove heating ducts in our house that had asbestos-lined duct insulation. Part of the process required them to remove the duct registers in the wall as ...
4
votes
1answer
239 views

How to salvage this ruined wall so it can hold paint?

We have a big wall plastered with clay. It was originally brown, and we wanted to paint it white or a light pink, using lime paint. Lime paint is said to be an ideal match for clay plaster, and has ...
4
votes
1answer
498 views

What is the purpose of a vapor barrier?

I live in southern Brazil and I don't really know if I need a vapor barrier, mainly because I'm still confused about its purpose. The house in question have brick exterior walls and interior drywall. ...
4
votes
3answers
2k views

Can my drywall act as an air barrier?

I am preparing to improve a building in a cold climate zone. Since it does not seem to be properly insulated, I am reading a book about insulating and weatherizing. That teaches me that I should ...
4
votes
4answers
5k views

How should I insulate the walls and ceilings of this 1920's semi-detached brick house?

I'm renovating a 1920's semi-detached house. The plaster on the walls was slapped straight on the wall about an inch thick, and the ceilings were lath and plaster which had been overboarded. Most of ...
4
votes
4answers
702 views

How do I insulate space in loft to create music studio

I have 3 DIY created rooms in my large live/work studio/artist loft. They are made with 2x4 and 2x6, framing with drywall walls and plywood ceiling. The apt has 14' 7" ceilings so we just have ...
4
votes
2answers
604 views

How do I keep drywall around a patch from crumbling?

While patching my kitchen ceiling, I cut the hole larger to get to the joists and install my drywall "normally". On one of my edges the old drywall keeps crumbling away. My plan is to make the hole ...
4
votes
1answer
899 views

What wall material should be used behind the Kerdi system in a tub/shower?

I know from my previous question that in most cases a cement board of some kind needs to be used. However, when the Kerdi membrane system is being used behind the tile, is it still necessary to use a ...
4
votes
5answers
9k views

Why does the plaster crack beneath the window sill?

Sorry if this is an obvious question. Can anyone tell me why the dry lined plaster in our house so frequently cracks beneath the edge of the windows? At first I thought it may be relating to the ...
4
votes
2answers
10k views

How do I get my recessed light fixture flush?

I installed two new recessed LED light fixtures using 4" new construction IC housings. The problem is that both fixtures are not flush against the ceiling after installation, they are dipping down on ...
4
votes
2answers
215 views

What should I do about this unfinished corner?

I've got this bit next to my back door that looks like it was never properly finished. There doesn't seem to be any structural issue, so I'd feel comfortable fixing it myself. Trouble is, I have no ...