For questions about drywall (aka plasterboard) installation, repair & finishing.

learn more… | top users | synonyms (1)

2
votes
4answers
333 views

Is it okay for one curtain hanging bracket to be screwed into drywall with no anchors?

I'm trying to hang curtains from near the ceiling. I have 5 brackets. 4 of them have successfully been screwed into wood, at least with the top screw (the bottom screw was as a wall anchor into ...
0
votes
3answers
581 views

How to prevent half wall (drywall, steel studs) from wobbling

I want to make a half wall beside a staircase (on the edge of the upper floor). One end will be attached to a concrete column, but the other will be (so far) unsuported. Something like the picture ...
1
vote
1answer
69 views

Drywall Repair in Ceiling

My contractor replaced a section of a ceiling with a new section of drywall (about 2' x 3'), he then built a floor to ceiling closet which covered most of the repaired area. The entire section was ...
2
votes
2answers
67 views

1“ S-Type Screws OK for hanging 5/8” Drywall on short wall in basement?

I recently had my basement framed/rocked/finished, and stupidly told the contractor to leave one small wall unfished. That decision came back to bite me as I now want to finish that wall... It's a ...
2
votes
2answers
129 views

Insulating between boiler room and bathroom

Part of my bathroom is directly above the boiler room. The boiler room is only accessible via an external door and is well ventilated with wall and door vents, so I consider it more like an outhouse ...
0
votes
1answer
46 views

Can I hang over-the-door organizers from exposed drywall?

One of the walls in my laundry closet is open into the adjacent closet between the ceiling and the raw edge of the top of the drywall (about a foot gap). Is it safe to use over-the-door hooks to hang ...
1
vote
1answer
63 views

Ideas for 1" of ceiling/crown trim?

I'm drywalling around a window. The window has a 12" deep "frame", which I plan to drywall on the sides and the top, and then make a wooden sill on the bottom. The problem is that the top of the ...
0
votes
0answers
42 views

How close to the roof can I drywall in my garage?

I'd like to drywall the entire garage ceiling and I have a tall peak in the roof near the back where the garage roof meets the house roof. I'd love to keep the high ceiling, make some high shelves or ...
0
votes
3answers
388 views

Knee Wall Without Top Plate

I'm finishing our attic and I can't quite figure out the best approach. The house came with the attic already "framed" with a kneewall, but the studs are just just angled directly into the rafters ...
0
votes
2answers
91 views

2-3kg blinds into drywall/plasterboard

I want to mount my 120cm long blinds into the face of the wall above my 110(ish) cm PVC window recess, but I don't feel like standard plugs would be sufficient. There are three brackets, each held ...
2
votes
1answer
62 views

Sand Texture Ceilings

What is the easiest and efficent way to smooth a sand textured ceiling? this house is a prebuilt house about 40 yrs old with ceilings 7 1/2' high.
1
vote
1answer
83 views

Distance to leave between drilled holes in plaster

I've drilled 3 6mm holes in a wall, about 30cm away from each other. They were meant to be vertically aligned but the measurements were off and it's on about a 5-10 degree slant. Because of this I ...
1
vote
1answer
120 views

How to fix wall with paint and wallpaper?

I recently bought a house and was removing the TV mount from a wall. The wall shows signs that it's paint over wallpaper and the mount was stuck to the wall so I had to use a scrapper to get the mount ...
1
vote
0answers
35 views

matching part of drywall with fiberboard

In the basement, I've got little room behind a door, that would only facilitate something like fiberboard, but the rest of the room is using drywall. I also don't have the ability to add a backing ...
1
vote
2answers
128 views

Are these studs intended to hold a drywall ceiling, or just for foam insulation?

I just bought a house and the basement looks like this: I was wondering what those "studs" across the main floor joists are for? Are they intended to just hold acoustic foam perhaps? They're ...
3
votes
3answers
425 views

Door jamb wider than wall

I wanted to run electric into my mudroom for a ceiling light and a exterior light. Unfortunately the walls were all painted wood paneling so while doing that I figured I would switch to drywall ...
2
votes
1answer
68 views

How to make chalkboard on the cheap

I am a long-time user of Math SE but first time user here. I have a small corner of my home turned into a studio where I do math tutoring via video conferencing. I have a big wall-mounted melamine ...
2
votes
2answers
73 views

Is this cement board / Sheetrock still ok to use in my bathroom?

Our builders are putting up cement board in the bathroom, and we noticed the pieces on the left have some stains, they look very different to the rest that looks the same as the ones on the right of ...
4
votes
1answer
138 views

How Much Weight Can My 1/2" Drywall Ceiling Take?

Okay, so, I'm doing a DIY home improvement project; I do not have access to the attic as my home is on the second floor of my building. The project: Installing a beaded ballchain/shimmerscreen ...
1
vote
3answers
74 views

mounting 60 inch TV with steel plates?

Mounting a 60 inch TV where studs are 22inches apart. Can I use 2 steel plates that are each 48 x 1 1/4 x 1/8 inch thick and then bolt them to my bracket and to the wall studs at each end and one ...
0
votes
0answers
91 views

Painted drywall with spoiled zero-VOC paint. Does Bin Shellac work to seal mold/bacteria? Some posts say no

My mother painted drywall with “spoiled” zero-VOC Banjamin Moore Paint (Natura). It was 5-year old paint, which had been opened/used years prior without a problem. The result was serious allergies and ...
0
votes
0answers
36 views

Is this likely to be plasterboard and what to look out for when drilling a hole?

I'm fitting curtain tracks in a loft conversion in a Victorian townhouse (London). I was surprised to see the outside of the wall seems to be just a piece of wood i.e. no brick. The wall is hollow ...
0
votes
0answers
119 views

Drywall over 2x2 Studs in Basement

I have a basement that is a complete product of the 70's. Faux ugly wood paneling, brass ugly sconces, old school metal work boxes, and a beautiful white drop ceiling. I know I could just drywall over ...
0
votes
0answers
41 views

Installing one piece stand alone shower

I am installing a shower, I ripped out all the previous sheet rock and cleaned up the wood then I put up hardie board my question now,is that my standalone shower is flush with the hardy board how do ...
0
votes
1answer
41 views

Interested in home will mold problem . Can mold be in carpeting? Howe do i remove

Interested in purchasing a home that has been empty for several years. Has a little mold on upstairs walls able to take care of that. One room has ceiling repairs with mold. Can the mold go up into ...
1
vote
1answer
144 views

Correcting silicon between plasterboard

I had a contractor come in to build an internal wall, and without me agreeing to it, he used silicone between the drywall panels. The issue is that there is a clear line down the wall where the ...
2
votes
1answer
68 views

how to drill through two different materials

I installed blinds in my kitchen. I put the screws into the wall. The wall was plaster and inside it was a thin metal sheet. The screws were 1/8 inches. So I drilled two holes of 1/8 inches through ...
0
votes
1answer
86 views

My wall is over 25mm (1 inch) thick, what kind of screw/fastener do I use?

So initially I thought I had a regular plasterboard. But I have a small measuring thing for wall depth, and after drilling a hole it seems it's deeper than 25mm. The plastboard thickness I see is 10 ...
0
votes
2answers
66 views

Can I raise the ceiling Without having joists visible

I would like my plaster board ceiling to be raised in my children's bedroom as we are installing a loft bed and do not have a comfortable amount of space between the bed and the ceiling. Is there any ...
1
vote
1answer
104 views

how to find out if wall is plaster, wood or drywall?

I want to install blinds in my kitchen. However, I can't figure out if the wall is wood or plaster. I need to know this before starting to drill because the holding mechanism for the blinds, it ...
0
votes
1answer
161 views

Can I use 12/2 NM-B wire for basement outlets?

Can I use 12/2 NM-B wire for basement outlets? Also can I use 15 AMP outlets and switches with 12/2 NM-B wire?
1
vote
2answers
172 views

How should I retape an inside drywall corner when the wall is heavily textured?

We just bought a house built in 1992 and need to retape the ceilings in some of the rooms where the ceilings are angled and the tape is coming loose. We have already removed the popcorn ceiling to do ...
0
votes
2answers
292 views

Exterior Fire-rated Wall Assembly?

I am renovating a 100+ year-old house that sits less than 5 feet from the property line on two sides. The renovation involves re-sheathing and residing the whole house. In order to bring it up to ...
0
votes
1answer
273 views

Killing mold IN drywall using Borax solution - what now?

My family is renovating an apartment and someone thought there was mold inside some drywall that showed water stains from when there was a leak in upstairs apartment. This person prepared a Borax ...
1
vote
1answer
96 views

Replacing Tall Baseboards with Smaller Baseboard

I am installing new baseboards along my walls but the baseboard I removed was really tall (probably about 5 inches). The new base moulding is only about 3 1/4 inches tall. The walls where the ...
0
votes
1answer
163 views

Water Damage on Ceiling of Shower

Today I noticed that a good little chunk of my ceiling in my bathroom had fallen into the bath tub. It appears to be some water damage, though the only thing above the ceiling is an attic that I'm ...
3
votes
3answers
1k views

Used circle cutter in wrong place in drywall, best repair method?

I'm mounting a TV and used a circle cutter attachment on my drill in the wrong location. I cut through 2 1/2" sheets of drywall and still have the discs of drywall. What is the best method to ...
3
votes
3answers
575 views

Leveling drywall patch

Due to a problem with my furnace, I recently had a lot of moisture get behind a wall and of course, mold to follow. All said and done I will need roughly 3 4x8 sheets to replace the damaged drywall. ...
0
votes
1answer
146 views

Painting Over Wall Blemishes

Album First Background: I have some walls that were once covered in wallpaper and my wife and I removed them when we bought our house. We then casually patched and sanded some of the blemishes left ...
0
votes
0answers
93 views

Preparing an old plaster surface for paint

I have two internal walls that I am repainting. Both were wallpapered, but stripping the paper off has revealed a load of old paint - I've got most of that off, but some is being rather stubborn. ...
0
votes
2answers
74 views

Which Product to Use for Repairing My Drywall

Can someone recommend which product I should use in this case?... I removed the backsplash tile in my kitchen and, in doing so, some of the tiles also pulled the top layer of drywall off along with ...
3
votes
2answers
675 views

Newly framed bathroom wall not square, how bad will the tile look?

I'm in the middle of a new bathroom install and have hit a bit of a snag with a bathroom wall being out of square. This bathroom was just framed from scratch, and as you can see from the attached ...
1
vote
1answer
99 views

Would a sheet of aluminum help with mounting a <20lb computer monitor to wall without studs?

I want to mount a 27inch 12lb computer monitor to a wall where the position of the stud doesn't work. I'm thinking of going with this mount and Toggler Snaptoggles. I know the optimal thing to do ...
3
votes
1answer
253 views

Max gap size for effective drywall joint compound

I am getting ready to mesh tape and apply joint compound to my drywall patch but I am wondering if my replacement piece is not snug enough. After doing a bunch of adjustments and trying to cut for my ...
1
vote
2answers
342 views

Concerns with washer and dryer in walk in closet

We are looking to do a remodel and move the washer and dyer into a walk in closet. I am curious of any concerns or issues regarding having a washer and dryer inside a walk in closet. Mainly, in terms ...
3
votes
2answers
317 views

Can I demo plaster walls but somehow keep the window casing?

My house was built in 1915. It has cracked (original?) plaster over lathe, poor insulation, leaded paint, and knob and tube wiring. To fix all of these things, I'm demo'ing the upstairs down to ...
1
vote
4answers
107 views

Drywall tape required for patch to small hole?

Is drywall tape required for a patch to a small hole that's fastened only to the surrounding drywall sheet? Specifics - I have a round hole, about six inches in diameter. I've patched it with a round ...
0
votes
1answer
77 views

how do you install a glass door on a drywall?

I have made a cabinet style cutout in the drywall and finished with dry wall. Now I want to install a glass door to this drywall and want to know how and best way to do it.
2
votes
2answers
88 views

Stud finding for window curtains — what does it mean that the whole side of the window frame is magnetic?

I had originally hung up window curtains by putting plastic anchors into the plaster and screwing into those. After a year, that fell out. Searching online, it seems if I find the studs / wood ...
3
votes
1answer
671 views

Plywood plate for mounting to wall

I would like to attach a projector arm to my drywall, but the mounting plate of the arm is a bit wider than a wall stud. ...