1
vote
1answer
112 views

Are these foundation issues significant?

My wife and I are in the process of purchasing our first home. It is 8 years old. We have found one that we like, but I am a little hesitant about going through for two reasons. The foundation ...
1
vote
2answers
76 views

How can I hang drywall from a ceiling made out of aluminium insulated panels?

I am closing in my Florida room. I want to drywall the ceiling. It is made out of aluminum insulated panels. I can't get any drywall screws to grab. No studs to drill into. I can leave it as is, but ...
3
votes
2answers
796 views

How do I get my recessed light fixture flush?

I installed two new recessed LED light fixtures using 4" new construction IC housings. The problem is that both fixtures are not flush against the ceiling after installation, they are dipping down on ...
1
vote
0answers
133 views

Am I going to die of Cancer from Asbestos if not handled correct? What more should I do? [closed]

So I have scrapped down old pop corn ceiling and removed staple on tile on drywall attached to plaster, that can be only lord knows how old. I didn't hang any barriers up as we are planning to do ...
2
votes
0answers
136 views

What materials and spacing should I use for ceiling joists/strapping in this conversion?

I have an old two bay garage that's 28'x50', that I would like to convert into a home. One thing I'm trying to figure out is how to do the ceiling. The ceiling is held up by metal joists approximately ...
0
votes
0answers
34 views

What are the resilient channel support specifications?

The local suppliers don't seem to have specification sheets for the resilient channel they sell. Only info is "Steel Resilient Channel 1/2 x 12' 25 gauge". Can it support ceiling drywall on 24 ...
8
votes
2answers
555 views

Can I leave drywall floating in the corners of my basement ceiling?

I was planning on installing drywall on my basement ceiling and realized that I have nothing to screw the drywall on after the last joist. On one corner of the room there is 12 inches from the last ...
3
votes
2answers
197 views

Drywall installation on the ceiling without help

I bought a piece of drywall(48x26 inches) and ready to install it. Please see the images. The height of the ceiling is about 11.35 foot. I tried to hold it with my hand, but it is heavy. I can't ...
4
votes
4answers
290 views

How do I cut drywall on the ceiling accurately?

I want to cut the drywall on the ceiling accurately. The thing is that the drywall is thick and it is on the top. I have to stand on the ladder; one hand use utility knife and the other hand hold the ...
0
votes
3answers
458 views

How to repair garage ceiling?

The attic of my house is unfinished. My son accidentally fell to the filing and caused the garage ceiling broken. Please see the images. Can you advise me how to repair this?
4
votes
2answers
123 views

Is there an easier way to remove a double layer of drywall on the ceiling?

I'm pulling down the ceiling and am having difficulty pulling down the drywall because it is 2 layers thick. I'm using a hammer and a wrecking bar but it is going a lot more slowly than I'd hoped. Is ...
5
votes
2answers
1k views

Is there an easy way to replicate this ceiling texture?

I have the swirly-tiny(stress the tiny)-bump texture on my ceiling on the first floor. I will be doing some major drywall repairs on the ceiling and would like tips on how to replicate the pattern. ...
0
votes
1answer
275 views

How do I use a Stanley IntelliSensor to locate the joists/crosspieces in my ceiling?

Six months ago I posted a question about fixing a circular light fitting to my plasterboard ceiling and thank you to bib for a really detailed answer. Returning to the problem I have borrowed the ...
6
votes
2answers
10k views

Should we skim-coat or drywall over a textured plaster wall to smooth it out?

Our new house has textured plaster walls that my wife and I don't like. We originally wanted to skim coat the walls to smooth them out, but a contractor suggested that we could put up drywall over it ...
12
votes
6answers
7k views

What is the best method of hanging drywall on ceiling?

I am hanging more drywall and will be doing a basement ceiling. I generally start in a corner and work my way out. I use glue on the joists and then drywall screws. Is the glue needed? I learned ...
3
votes
1answer
1k views

How do I replace part of my bathroom ceiling?

I had a leak in the roof above my bathroom. I had a contractor investigate. He looked at the roof carefully, and he examined the ceiling with an infrared scanner while it was actually leaking. He ...
3
votes
1answer
766 views

How do I paint over a textured ceiling without removing the texture?

A painter I had at one time painted the textured drywall mud ceiling (off white color) in a different part of the house. He had to change to a sprayer because he said the drywall texture was coming ...
2
votes
1answer
1k views

How do I prepare a ceiling for restomping?

I had to cut access panels in the ceiling of a 7' x 11' room to make several plumbing repairs. The ceiling has the slapbrush/stomp texture: I have patched the drywall and I plan on restomping the ...
1
vote
2answers
284 views

How do I replace a 7' drop ceiling so it matches an 8' ceiling with 2 layers of drywall and popcorn texturing?

I would like to remove a dropped ceiling and give the room an 8 foot ceiling. The great room ceiling has 2 layers of drywall already. I need to repair many areas of the ceiling (remove an attic fan, ...
1
vote
1answer
2k views

How can I attach a light fixture to plasterboard?

After some water damage and a ceiling repair I cannot locate the joist to refix the light fitting. It is a circular fluorescent light weighing about 3 and a half pounds. Is it safe to fix all 3 ...
2
votes
1answer
790 views

Is this asbestos in my ceiling drywall?

While looking through a hole in the drywall, I saw this... Is this asbestos?
1
vote
1answer
1k views

Should I primer my walls/ceiling before I spray on texture?

I have removed a wall and upper cabinet, replacing some sheetrock. I have skim coated and sanded the existing walls and removed the "popcorn" ceiling. My question is: do I need to primer the walls ...
11
votes
1answer
1k views

Are these drywall screws driven too deep into the sheet?

First off, I apologize for the asking and deleting my previous question about this. I thought it was more of a dupe of this question that I asked a while back. I'll be more central to the actual ...
7
votes
2answers
1k views

Can I install drywall on the ceiling, without removing crown molding?

I'm in the process of replacing a failing plaster ceiling in my finished basement with drywall. I originally had intended only to scrape down the popcorn finish and have it skim coated, so I did not ...
2
votes
1answer
2k views

Can a new ceiling be build directly onto an old one

I would like to build a new ceiling on to an old slightly sagging and poorly finished ceiling (peeling paint and no joint plaster used). I see this way as more convenient and less messy than ripping ...
1
vote
3answers
905 views

What products are available to make coved ceilings?

Due to massive cracks and drooping ceilings we need to tear off our existing plaster/lath walls and replace with sheetrock. The 1948 house currently has coved ceilings that we want to duplicate when ...
7
votes
2answers
1k views

Why are there two layers of dry wall in my ceiling, and how can I patch it?

The fan in my bathroom died. We bought a replacement that's a bit bigger. The original was nailed to a beam in the ceiling and required me to cut out some drywall to remove. When removing the old ...
3
votes
2answers
2k views

How can I fix a ceiling above the shower that was damaged by water?

Our pipe coming out of the wall was leaking a very fine stream of water. We haven't had time to fix it. I don't know what that bumpy stuff on the ceiling is called but it's all peeling off. I know the ...
4
votes
1answer
192 views

What advice would you offer somebody who is building a laundry chute for the first time?

I'm looking to build a laundry chute from our bedroom closet to the laundry room below. The positioning is such that the wall of our closet is shared with a storage closet in the loft above our ...
4
votes
4answers
4k views

Second layer of drywall on textured ceiling: Do I need to sand down or remove the texture before second layer goes on?

I have a textured ceiling similar to this: Some of the texture peaks at 1/8", but it mostly peaks at 1/16". I am going to be applying a second layer of drywall with Green Glue in between and I ...
9
votes
2answers
15k views

How much weight can I hang from a drywall ceiling?

I have a potted plant (approx 5kg/10lbs) that I wish to hang from a drywall ceiling of a window aisle. Unfortunately, I have no idea about what specific kind of drywall plate it is or how it was ...
2
votes
2answers
453 views

How do I replace ceiling drywall over cabinets?

I recently had some water damage to my ceiling after a storm. For the most part, it's a simple cut out and replace procedure, but I'm stuck wondering what to do in the kitchen. There's about 1'x2' ...
24
votes
4answers
13k views

Should I use nails or screws for hanging drywall on the ceiling?

I'm replacing water-damaged drywall on my ceiling and was considering using screws. Other than cost, is there any other reason I should use nails instead? Or am I too paranoid that nails won't have ...
3
votes
2answers
4k views

Should I replace or patch a plaster ceiling?

My house is about 109 years old, excellent condition, other than cracking in the plaster ceilings. I've had one 3x3 section even fall out in my dining room. I want to replace the ceiling in the ...
3
votes
2answers
2k views

How do I repair a drywall ceiling when there is blown in insulation above?

I was finishing the space above a garage. The space was buried in blown in cellulose insulation and we framed in some walls, laid a subfloor, and finished the room. During framing two different ...
5
votes
1answer
668 views

How do I splice a drywall metal outside corner bead?

When re-finishing my ceiling (formerly popcorn, now smooth) I had some trouble with the edge of the tray ceiling in the master bedroom. Since the length of the tray was longer than a standard metal ...