Questions pertaining to clothes dryers

learn more… | top users | synonyms

4
votes
3answers
111k views

Where does the ground wire go in a 3-prong dryer cord configuration?

We moved to a new place where the dryer connection is 3-prong instead of 4-prong. The dryer was originally 4-prong, so we bought a 3-prong cord and installed it. It works fine, except I am not ...
6
votes
2answers
12k views

Insufficient voltage to dryer receptacle; what next?

I just moved into a home and I am hooking up a used dryer (which I'm told works). The dryer spins, but I get no heat. I bought a multimeter, and it tells me that the receptacle provides insufficient ...
6
votes
4answers
34k views

Is it safe to install a three pronged wire into a four pronged dryer?

I just moved into an old home that has a three pronged wall jack as shown below: I have a newer dryer that has a four pronged wire. Please see the back of the dryer, I've removed the four pronged ...
5
votes
3answers
36k views

Why does it take my dryer 3 hours to dry a load of clothes?

I have a Maytag model LD69806AAE clothes dryer. Since our tenants in our town home have moved in July 2012. They have pointed out that the dryer takes about 3 hours to dry a load of clothes. The dryer ...
10
votes
8answers
24k views

What is the best way to clean your clothes dryer exhaust?

My dryer exhaust goes out of my laundry room, into my attic, and runs for about 15 feet before it gets outside. Over time the lent has built up quite a bit. What is the best way to clean this? The ...
6
votes
2answers
2k views

Can an electric dryer be next to the gas furnace?

I intend to relocate my washing machine and electric dryer within the basement. The dryer will then be about 2 feet from the furnace. Is that OK?
6
votes
7answers
15k views

Can I vent my dryer into the crawl space without creating mold and moisture problems?

We have a crawl space with a combination of sandy and clay soil in it. The crawl space is about 3' deep. To eliminate a long dryer vent run, I'd like to vent the dryer directly into the crawl space. ...
2
votes
3answers
6k views

How should I route my dryer exhaust pipe?

My existing dryer vent run enters the crawlspace behind the dryer and exits through a vent that is part of one of the normal crawlspace vents. Since the house sits on a slight slope, the crawlspace on ...
7
votes
4answers
15k views

Can a dryer be vented through the roof?

In my home the dryer vent is set up to vent out into an enclosed back porch. The problem is that all sorts of lint (and heat) get pumped out into that enclosed area and makes a mess. Directly above ...
6
votes
4answers
81k views

How do I connect a dryer with a four prong plug to a three prong socket?

I've just moved house and my clothes dryer has a four prong plug but on the wall there's a three prong socket. Do adapters exist for this? Or do I need to get a new cord for my dryer? Or is there ...
5
votes
1answer
2k views

How can I plug my 3 prong dryer into a 4 prong receptacle?

My dryer blew up and there is no chance of repair — it was pretty old anyway. I found a used dryer and brought it home. Unfortunately, the cord don't match the receptacle. I Need to know if ...
5
votes
4answers
10k views

What is the proper wiring for a NEMA 14-30 240v receptacle?

We moved into a resale home, the previous owners had a Gas Dryer, we have an Electric. The laundry room has a NEMA 14-30 receptacle installed. I hooked up our brand new dryer and it didn't get power. ...
4
votes
4answers
7k views

Can a dryer receptacle be wired without a neutral?

In my apartment, I have a 4 wire 240V receptacle for a dryer where the neutral is not connected, only the 2 hots and ground. Is this configuration permitted for a dryer circuit? An electrician and ...
3
votes
2answers
147 views

Whatzit? Name this dryer or washer thing-a-ma-bob

I am victorious! I have my new LG washer and gas dryer installed. After a weekend of pain and suffering. Well, at least a few trips to Home Depot. All's done except...I'm left with this one part. I ...
3
votes
2answers
1k views

30 amp dryer plug is hooked to a 40 amp double breaker, is this ok?

I just bought a home and needed to buy a new washer and dryer. The new dryers need a 30 amp plug, currently has 50 amp plug. I replaced the plug but noticed it was ran to a double pull 40 breaker, is ...
2
votes
2answers
642 views

How can I prevent my clothes dryer door from fogging up?

When I turn the air conditioning on in my house, the inside of the window in the clothes dryer door fogs up. Also, if clothes are left in the dryer, they become slightly damp again. How can I prevent ...
2
votes
3answers
539 views

Where are the fuses in my Kenmore dryer, and how do I access them?

I have a Kenmore HE3 electric clothe dryer. The problem is that it has no heat even its drum is turning. (I set the temperature at high). The owner manual says it may have a fuse blown. Is the fuse ...
2
votes
3answers
11k views

Two dryers connected to the same exhaust via a “Y”. Backdraft problems?

I have two dryers (one gas, one electric) and their exhaust pipes are merged with a "Y" to a common exterior exhaust. I'd like to keep it that way to minimize cuts through the wall (and eventually I ...
1
vote
2answers
7k views

How do I connect a dryer to a dryer vent?

I just moved my dryer (gas) a couple feet to a better location in the basement. It is actually now closer to the existing dryer vent to the outside of the house. The previous owner has it connected ...
0
votes
1answer
584 views

What type of dryer best handles long exhaust vents?

I have a very long exhaust line (about 5 meters) from the dryer and have issues with moisture staying in it when I do laundry. Since the old dryer broke down, I am now shopping around for a new dryer ...
0
votes
1answer
1k views

Is it okay to have a dryer vent in the wall cavity?

I'm redoing the wall of a utility room that, among other things, has the dryer vent embedded in the wall cavity with all kinds of stupid turns to go around the plumbing. Would it be a good idea to ...