A tool used for creating holes in surfaces, such as for mounting objects on walls.
8
votes
3answers
18k views
How do you know when and where it is safe to drill into a wall?
Lots of home projects involve cutting or drilling through walls (everything from nails, screws, or hooks to mount things to cutting through drywall and drilling through studs to run wire).
In ...
5
votes
4answers
1k views
How do I drill additional holes for adjustable-height shelving?
I have a set of cupboards with shelves that adjust in height, by means of moving pins that hold up the shelves to different holes:
Unfortunately, for some reason, whoever made the cupboards didn't ...
2
votes
1answer
970 views
1/2“ Chuck on 3/8” Cordless Drill?
I need to use a step bit with a 1/2" shank. I only have drills with 3/8" chucks. Is the arbor size on most drills a standard which would enable me to just replace one of the 3/8" chucks with a 1/2" ...
13
votes
11answers
12k views
What is the best technique for using a drill to insert screws?
It looks so easy on the DIY programs, but I battle to insert screws using my drill. The screwdriver bit keeps slipping out, and it damages the screw head.
Is there a neat trick for this?
Should I ...
12
votes
3answers
17k views
What is the best drill bit to pre-drill holes for screws of a certain size?
Total noob question here:
This can apply in general, but for a specific case, suppose I have a 5/16 bolt for which I want to drill a hole. What's the best drill bit to use to make the hole big ...
11
votes
2answers
683 views
What type of cordless tool battery chemistry should I purchase?
I'm about to buy a cordless tool set in which the tools all operate off the same form-factor battery. The batteries come in several different chemistries and I'm wondering which type is better for ...
5
votes
6answers
782 views
What's a good general purpose light-use drill?
I was wondering if anyone had any suggestions for a decent general purpose light use drill for around the home? It's not going to get a whole lot of use. When it does get used most of the time it'll ...
4
votes
4answers
275 views
What sort of bit can I use to drill out a thin seized screw?
I have a piece of moulding on an appliance that is held on by a long, thin screw with a hex head. The screw is perhaps 5" long and perhaps 1/8" diameter (modestly heavier than a wire coat hanger).
...
