6
votes
6answers
1k views

How to SLIGHTLY widen bored hole in 2x6

I'm making a stand-alone pullup bar and I bored 1 1/4" holes in 2x6's for my 1" galvanized pipe (1 1'4" outside) to slide through. Only the pipe is definitely 1 5/16" (thank you, guy at Lowes) and I ...
1
vote
3answers
321 views

How to drill a hole in the wood without an electric drill?

During a travel in Laos, I need to drill some holes into a double-door's wood to install a locker. The wood is rather hard, and I don't have an electric drill (and can't find it). I only have 2 small ...
5
votes
7answers
1k views

How can I bore deep straight holes through wood?

I wish to bore a 12mm hole in a 9x2 vertically. How do I keep the bore hole straight through 9 inches?
0
votes
1answer
2k views

How can I fill a hole in wood so that it can be redrilled? [duplicate]

The original strike plate for the deadbolt is mounted with 2 screws on top and 2 screws on bottom. I'm replacing the whole deadbolt and the new strike plate only has 1 screw on top and 1 screw on ...
17
votes
4answers
41k views

When pre-drilling for screws, how do you determine the correct bit diameter?

Suppose I want to pre-drill for, say, a 5/16 screw. How do I determine the correct drill bit diameter?